induced circuit 中文意思是什麼

induced circuit 解釋
感應電路
  • induced : 感生的
  • circuit : n 1 (某一范圍的)周邊一圈;巡迴,周遊;巡迴路線[區域];迂路。2 巡迴審判(區);巡迴律師會。3 【...
  1. In order for there to be an induced current, we must have a closed circuit.

    為了出現感生電流,我們必須有閉合迴路。
  2. An analytical mosfet threshold voltage shift model due to radiation in the low - dose range has been developed for circuit simulations. experimental data in the literature shows that the model predictions are in good agreement. it is simple in functional form and hence computationally efficient. it can be used as a basic circuit simulation tool for analysing mosfet exposed to a nuclear environment up to about 1mrad. in accordance with common believe, radiation induced absolute change of threshold voltage was found to be larger in irradiated pmos devices. however, if the radiation sensitivity is defined in the way we did it, the results indicated nmos rather than pmos devices are more sensitive, especially at low doses. this is important from the standpoint of their possible application in dosimetry

    該模型物理意義明確,參數提取方便,適合於低輻照總劑量條件下的mos器件與電路的模擬。並進一步討論了mosfet的輻照敏感性。結果表明,盡管pmos較之nmos因輻照引起的閾值電壓漂移的絕對量更大,但從mosfet閾值電壓漂移量的擺幅這一角度來看,在低劑量輻照條件下nmos較之pmos顯得對輻照更為敏感。
  3. Psychologist dr. robert sinclair and his former phd student carrie lavis recently conducted a series of four studies addressing the effects of experimentally induced happiness versus sadness on work productivity by asking the participants to build circuit boards

    最近進行了一系列研究,用實驗方法誘導參與者心情愉快或悲觀憂愁,要他們製作電路板,最後了解其對工作效率的影響。
  4. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流,兩者產生的偏置磁場在控制線圈產生感應信號,檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號,該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號,再由pid控制器轉換為轉子位移的控制信號,最後控制信號輸入功放電路產生控制電流,實現閉環控制。
  5. This thesis aims at discussing the model of manufacturing defects, the principles of soft and hard faults induced by manufacturing defects, the effects of soft fault on circuit reliability and yield and the relationship between yield loss and reliability decrease caused by manufacturing defects. the author ' s main contributions are as following : reliability and yield are two significant factors to semiconductor manufacture. based on the principles of the manufacturability engineering, the thesis discusses the effects of the manufacturing defect on the functional yield, parametric yield and the reliability for ics, and abstracts geometric models from actual chips

    本文對集成電路製造缺陷模型、由製造缺陷導致的軟、硬故障的作用機理、軟故障對電路可靠性和成品率的影響以及由製造缺陷導致的電路成品率的損失和可靠性下降之間的關系進行了系統的研究,主要研究結果如下:可靠性和成品率是影響半導體生產的兩個主要因素,本文首先從集成電路的可製造性工程理論出發,討論了製造缺陷在影響集成電路功能成品率、參數成品率和可靠性方面的作用。
  6. In the third one we investigated the measure of minority carrier lifetime in silicon solar cells by the photo - induced open - circuit voltage decay ( ocvd )

    該部分研究對工業化生產具有參考價值。第三部分研究了採用開路電壓法測量晶體硅太陽電池的少子壽命。
  7. Besed on the circuit, electromagnetism and electric power electronics theories, we have done some theory research on the harmonics induced by thyristor commutate circuits of ac - dc locomotive, surge electromagnetism process. we calculate the theory content of harmonics using the fourier arithmetic under thyristor commutate and surge electrmagnetism process

    論文根據電力機車類型的不同,運用電路、電磁場和電力電子學理論研究了交?直型電力機車相控整流時諧波的產生機理、勵磁涌流的電磁過程,並對晶閘管相控整流和勵磁涌流時的理論諧波含量進行了傅里葉分析。
  8. Then we set up the model of rectangle - shape pipeline. we compare it to circuit - shape pipeline on sides of the value of induced electromotive force, pressure loss when liquid flow trough the pipeline and resistance ' s value of the sensor. we get the result that we can finish the measurement of low - velocity flow by using the rectangle - shape pipeline

    接著對矩形測量導管進行建模,並在流體流經矩形測量導管時產生感應電動勢的大小、流體在測量導管中的壓力損失和傳感器內阻的大小對輸出信號的影響等幾個方面與圓形測量導管進行比較后得出採用矩形測量導管完全能夠有效地完成微流量的測量。
  9. The analysis of self - induced emf in rl circuit and its experimental design

    電路的自感電動勢分析及實驗設計研究
  10. An analysis of factors that impact maximum self - induced emf in open rl circuit

    電路斷電過程中影響自感電動勢最大值的因素分析及實驗驗證
  11. A measure of the induced voltage in a circuit caused by a magnetic flux and equal to the flux times the number of turns in the coil that surrounds it

    碰撞,匝鏈電路中由於磁通量而造成電伏減少的單位,等於穿過一載流線圈的磁通量與線圈匝數之積
  12. Abstract : the rechargeble batteries are used for backup power internal electrically equipments and instruments. but batteries lifetime usually is shorten by overwork and then malfunctions of equipment are induced. to avoid the complexion described above, the protection circuit against overwork is designed. it is based upon the voltage comparator and regulator. it will light up a red led when the volume of the batteries discharged close upon 50 % ; it will switch off the load automatically when it discharged closing to 80 % of their energy capacity, thus overwork of batteries can be avoided and lifetime may be extended

    文摘:用蓄電池做后備電源的系統(或設備) ,常因過放電導致電池提前報廢而造成設備故障.根據電池電壓隨容量變化的規律,利用電壓比較器和電壓基準源設計製作了電池放電保護電路,當電池放電量接近容量的50 %時,啟動預警信號;當電池放電量達到容量的80 %時,電路自動切斷負載,防止電池過度放電,延長電池壽命,保證系統(或設備)在供電恢復正常后能正常運行
  13. This model of valve overcomes such defects with the motor valve, piston - type electromagnetic valve as the post - wear defective closure due to the mechanical movement, the soft membrane full of elasticity, the balance hole can not close water because the foreign matters and mud sand accumulate and block it up etc., the highly effective use of the unique circuit greatly raises the reliability of the switch, extensively used for ic card watermeter, infrared induced sanitary utensils, etc

    Fck - 118 :進水口出水口為1寸25內螺紋該型閥克服了如電機閥活塞式電磁閥機械運動磨損后的關閉不良。軟性膜片富有彈性,平衡小孔不會因雜質與泥沙的淤積堵塞使其關不住水,獨特線圈磁路的高效利用大大提高了閥開關可靠性,廣泛用於ic卡水表紅外線感應潔具等自動控水系統。
  14. To make use of parasitic parameter to design the circuit : because parasitic inductance induced by packaging could not only influence the circuit characteristics, but also lead to a design failure, the inductor value needed in the circuit can be designed in the amplifier according to the size of parasitic inductance

    4 、利用寄生參數來設計電路。由於電路的封裝存在寄生電感,其不僅會影響電路的特性,而且可能造成電路設計工作的失敗,所以根據電路所需電感及其值的大小,將之有效的設計在放大器電路中。
  15. Small - signal pre - amplifying circuit for microwave - induced thermoacoustic tomography

    微波熱聲成像弱信號預放大電路
  16. In this paper, the over voltage induced by re - ignition, rules of breakdown in vacuum contact clearance, factors which influence dielectric strength of clearance and characteristics of re - ignition when vacuum switchgear switch capacitor banks are analyzed. the conclusion is that the breakdown of clearance in vacuum interrupter is the direct cause which inducing re - ignition of vacuum circuit - breaker in capacitor banks ’ switch. particle breakdown is the essential reason to induce breakdown in clearance of vacuum interrupter, although mechanical characteristic of vacuum circuit - breaker is another factor

    本文通過對真空開關投切電容器組重燃過電壓、真空觸頭間隙擊穿機理及影響真空間隙介質強度的因素、真空開關投切電容器組重燃現象特點進行分析研究發現,真空滅弧室斷口的真空間隙擊穿是導致真空斷路器投切電容器組重燃的直接原因,其次是真空斷路器機械性能的影響,而微粒擊穿是導致國產真空滅弧室真空間隙擊穿的根本原因。
分享友人