inlet angle 中文意思是什麼

inlet angle 解釋
進角
  • inlet : n. 1. 進口，入口。2. 【電學】引入，輸入，輸入線。3. 水灣，小港。4. 插入物，鑲嵌物。vt. （inlet, inletting）1. 引進。2. 嵌入，插入。
  • angle : n 【英史】盎格魯人〈cf Angles〉。n 1 角，隅，角落；棱，嬗角。2 【數學】角，角位，角的度數。3 【機...
  1. The design point of the designed forebody / inlet is flight mach number m = 6 and flight attitude h = 25km. the three - ramp, mixed external and internal compression hypersonic / inlet is chosen as representative geometry to be designed. nine types of hypersonic / inlet model with difference forebody length and total turning angle are obtained that the incidence angle of the first ramp and height of isolator are given

    根據飛行任務要求，以飛行馬赫數6 ，飛行高度25km為設計點，給定前體預壓縮角、隔離段高度，對具有不同前體長度和不同總壓縮轉角的帶隔離段的前體進氣道進行了設計。
  2. With account for the effect of temperature and shock - boundary layer interaction, the forebody / inlet with plane lip and wedge lip are designed by using the design methods of constant shock wave intensity and constant shock wave angle. in the design, the incidence angle of the first ramp, height of isolator, length of forebody and total turning angle of the designed forebody / inlet models are given

    另外，根據優選結果，給定前體長度、前體預壓縮楔角、總壓縮轉角及隔離段高度，分別用等激波強度和等激波角度的方法設計了唇口平直和唇口帶楔角的前體進氣道。
  3. Simulation results show that better atomization can be realized by enhancing the cavitation intensity via increasing the injection pressure difference or decreasing the nozzle inlet round angle - radius ratio

    通過模擬計算可知，提高噴射壓差和減小噴孔入口圓角半徑都可以提高空穴強度，同時也發現提高噴孔長徑比可以使空穴在噴孔出口截面上分佈更為均勻。
  4. Based on this model, the effects of geometric and structural parameters, such as injection pressure, rear pressure, length - diameter ratio, inlet round angle - radius ratio and non - axis symmetry of nozzle, on the distribution of the cavitation inside the nozzle are analyzed

    基於這一模型進一步分析了噴射壓力、背壓和噴孔長徑比、噴孔入口圓角比、非軸對稱噴孔等幾何結構參數對噴孔內空穴分佈的影響。
  5. By using harika algorithm, the characteristic of a high - pressure compressor is calculated at different installation angle of the inlet guide vane and the stator vanes ; the characteristics of a high - pressure turbine and a low - pressure turbine are simulated at different installation angles of the guide vane based on ainley method

    本文用harika演算法計算了導流葉片和靜子葉片安裝角度可調的變幾何高壓壓氣機特性；用ainley法計算了渦輪導向器面積可調的高壓渦輪和低壓渦輪的特性。
  6. On the basis of these results, the relations of total - pressure recovery coefficient or flow coefficient and flight mach number, angle of attack and the second movable wedge angle of the inlet have been founded by hypersurface fitting, then the mathematical model of the inlet is established

    根據流場計算結果並利用超曲面擬合方法建立了進氣道總壓恢復系數、流量系數與飛行馬赫數、進氣道攻角及二級可調斜板角度之間的關系，由此得到了二元混壓式超聲速進氣道數學模型。
  7. The best compression ratio and fuel injection advance angle are calculated through mess optimization calculation program of language c. on the basis, optimization simulation of inlet and exhaust timing has been carried with the diesel engine working model to increase diesel engine ' s volumetric efficient

    在此基礎上，利用柴油機工作過程模型，對進排氣正時進行了優化計算，以提高柴油機的充氣效率，改善燃燒性能，為進一步改善該機性能指明了方向。
  8. Inlet advance crank angle

    進氣提前角
  9. Mainly, the type of pump in the large - scale irrigation and drainage pumping station in our country is adjustable - blade propeller pump. we can regulate the pump ' s blade mounting angle following the variation of water level at the inlet and outlet of the station in order to control the discharge of pump, we also determine the number of running machines with machine ' s optimal combination. so we can reduce its energy consumption, and make it optimally and economically run

    我國大部分大型電力排灌站所安裝的泵都為可調節葉片的軸流泵，這一有利條件使我們可以根據排灌站進、出口水位的變化來調節水泵的葉片角度，控制水泵的流量，併合理的確定開機臺數，通過機組間的優化組合，使整個泵站的能耗最少，達到整體最優、經濟運行的目的。
  10. The existence of angle of attack reduces the inlet performance

    攻角的存在也在一定程度上降低了進氣道性能。
  11. For shelters, the results show : 1 ) to reduce the raining drops entering into the inlet and to decrease the influence of the vortex, the declining angle of 45 is recommended for the shelters ; 2 ) it is better to choose those shelters which are longer 100 mm ~ 200 mm than the height of the inlets, as they may protect the room from rain

    對于單側百葉風口的擋雨板，計算表明: 1 ）為了防止雨水隨空氣流入自然進風口，並且使風口盡量少受渦流區的影響，建議選用傾斜角度為45 「的擋雨板; 2 ）建議選用長度比風口高度長100mm - - 200 「的擋雨板，可以較好的避免擋雨板過短將雨水帶入室內和過長影響風口進風的情況。
  12. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  13. At large attack angle the frequency of the vortex has n ' t a apparent zone of " lock - in ". the fluid - induced vibration at large attack angle belongs to the stable dynamic response problems. but a sudden skip of amplitude will occur at large inlet velocity

    在大攻角下分離渦脫落的頻率沒有一個明顯的頻率鎖定區域，流體振動屬于穩定的動力響應問題，但在大來流速度下會出現振幅突跳的現象。
  14. The article analyses the influence to the generator electrode temperature from different inlet angle and inlet total pressure and the compressive angle of fluid in the situational process

    本文在對等離子發生器內部純空氣流場的模擬過程中，分析了不同進口氣流角、不同進口總壓以及不同氣流壓縮角對發生器電極壁面溫度的影響。
  15. The full flow field characteristics of a supersonic inlet are illustrated at design conditions ; the influence of attack angle on flow field of the inlet is investigated ; b - spline theory is used to model the inlet with attack angle

    給出了設計狀態下進氣道內外流場特徵；分析了攻角變化對進氣道流場的影響；以數值模擬結果為基礎，利用b樣條理論建立了反映攻角、馬赫數及可調斜板角度變化的超聲速進氣道數學模型。
  16. The velocity - coefficient method was used to design a 180mm diameter impeller with five single - arc - cylinder blades. the exit angle and inlet angle of the segment are 35. 1 and 36. 0 in degrees respectively. the shape volute ' s cross - section is the rectangle

    該葉輪採用速度系數法設計，轉輪外徑180mm ，共有5張單圓弧圓柱形葉片，其出口安放角、進口安放角分別為35 . 1度、 36 . 0度。
  17. It can make sprinkler of water feeding install on strap or on sand inlet of double disk and adjust spraying angle of sprinkler according to real condition ; the water will spray on falling sand that makes it form sand curtain ; it sprays water on hot sand equably and extends exchanging time of water and hot sand. 4

    根據現場情況，加水噴頭可設在進砂皮帶上，或設在雙盤的進砂口處，調整噴頭的噴灑角度，使水噴向由下落的砂子組成的砂簾，將水盡可能預先均勻得噴灑在熱砂上，增加水與熱砂的有效熱交換時間。
  18. On basis of the modeling results, the effects of mach number, attack angle and ramp angle on the inlet performance are analyzed

    根據此數學模型，分析了攻角和進口氣流馬赫數對進氣道性能的影響，同時給出了斜板對進氣道性能的影響。
  19. Inlet lag crank angle

    進氣滯后角
  20. Blade inlet angle

    葉片入口角
分享友人
分享到 Line

分享到臉書