iteration parameter 中文意思是什麼
iteration parameter
解釋
迭代參數-
On one hand, from the technique of constrained least squares and limited energy of additive noise, an effective restored approach by adopting regularization method to overcoming ill - posed problem, solving an equation with a single variable, and using space iterative algorithm is proposed ; on the other hand, aiming at the restoration of blurred image, another effective restoration approach based on least - square algorithm is also proposed in this paper. this method firstly adopts increment iterative algorithm to improve convergence and meanwhile applies regularization technique to overcome ill - posed problem. in the computations, the regularized parameter has its adaptive character, which can be determined in terms of the restored image at each iteration step therefore automatically correct to the appropriate value
一是從約束最小二乘出發，在加性噪聲能量有界的前提下，採用正則化方法來克服病態問題，通過解一個單變量方程，並利用空域迭代運算實現了一種有效的圖像復原;二是針對模糊圖像的復原問題，從最小二乘演算法出發，採用增量迭代的方法改善演算法的收斂性，同時結合正則化技術克服問題的病態性質，並引入自適應的正則化參數，使其與圖像復原的迭代運算同步進行並自動修正到最優值。 -
The adaptive homotopy method uses the homotopy with parameter to get a enough good approximation xn of the genuine solution x, and then use the newton iteration to attain a more precise one
自適應延拓演算法用含參同倫迭代求出一個真解x ~ *的較好近似x ~ n ，再用newton迭代精確化。 -
The last proposed method is based on the distributed parameter model, the algorithm utilizes searching and iteration methods to locate the fault point
第三種方法採用電纜線路的分佈參數線路模型，根據功率平衡原理推導出故障測距方程，並通過搜索迭代方法解之。 -
Lastly, we will carry out an iteration method, with the help of the interior regularity theorem of elliptic equation, to obtain high order regularity and the corresponding estimates for solutions of the auxiliary problems without small parameter e
然後，重復與周期區域情形相同的方法和論證，可以分別在每個區域上得到其弱解的高階正則性以及高階模估計 -
A method is proposed for the parameter identification of the viscoelastic internal dampers of the multirotor systems in this paper. the multi - rotor system is regarded as a composite structure. the impedance matching method in the substructure method for structural dynamic analysis is used for the dynamic calculation of the structure. the augmented lagrange method is applied to the iteration calculations of the characteristic determinant of eigenvalve equation of the system. and then the results of parameter identification can be obtained. upon the dynamic characteristics of the system, the method can reveal the influence of the gyroscopic moments of force precisely. in process of the analysis, the various properties of multi - rotor systems are made the best use of, so the measure of the modes parameters is avoided, the calculation is simplified. in addition, an efficient method is proposed to establish a dynamic model of multirotor systems with viscoelastic internal dampers. the calculating results are consistent with the experimental results satisfactorily
提出了多轉子系統的粘彈性中間彈支參數辨識的一種方法.該方法把多轉子系統看作復合結構，用動態子結構分析的阻抗匹配法計算動力學特性，用增廣拉格朗日乘子法迭代計算系統特徵方程的系數行列式，獲得系統物理參數的辨識結果.該方法可以準確計入陀螺力矩的影響，避免測量振型參數.在分析中，利用多轉子系統的特性可簡化分析過程.文中還介紹了一種建立粘彈性彈支多轉子系統動力學模型的方法.計算結果與試驗結果基本一致 -
Based on them, parameter approach analysis method of design segmental reasonable state is introduced, which has only iteration in due direction, and more efficient than present backward analysis, backward - forward iteration analysis and non - stress state method as well as more stable because of introduction of iteration parameter
基於此，提出了設計（施工）節段合理狀態分析的參數逼近法。因只需正向迭代計算，比目前倒退分析、前進倒退交替分析法及無應力狀態法具有更高的效率，又因引入迭代控制參數，而具有更好的穩定性。 -
Three temperature equations include disconnected thermal conductivity coefficient and energy exchange terms between electron and ion, electron and photon, which are affected by the density an d temperature of the plasma, and by the atom parameter. implicit scheme have to be used to solve them. we use entirety linear iteration method to do this work
三溫方程含有間斷的熱傳導系數，存在著電子與光子、電子與離子的能量交換，這些量與離子的密度、溫度和原子物理參數有關，對它們的求解必須採用隱式格式，我們採用整體線性化迭代格式迭代求解。
分享友人