load displacement 中文意思是什麼

load displacement 解釋
【航海】滿載排水量。

  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  • displacement : n 1 轉位，移動；取代，置換；（人的）流離失所。2 撤換，免職。3 【機械工程】（活塞）排氣量；【航海...
  1. Methods of test for ancillary components for masonry - determination of tensile and compressive load capacity and load displacement characteristics of wall ties couplet test

    圬工輔助砌塊的試驗方法.墻拉桿的拉伸和壓縮負載容量和負載轉移特性的測定
  2. Methods of test for ancillary components for masonry - determination of tensile and compressive load capacity and load displacement characteristics of wall ties single end test

    圬工輔助砌塊的試驗方法.墻拉桿的拉伸和壓縮負載容量和負載轉移特性的測定
  3. Methods of test for ancillary components for masonry - part 5 : determination of tensile and compressive load capacity and load displacement characteristics of wall ties couple test

    圬工輔助成份試驗方法.第5部分:拉伸和壓縮負載容量和墻系柱和負載代替特性測定
  4. Methods of test for ancillary components for masonry - part 6 : determination of tensile and compressive load capacity and load displacement characteristics of wall ties single end test

    圬工輔助成份試驗方法.第5部分:拉伸和壓縮負載容量和墻系柱和負載代替特性測定
  5. Methods of tests for ancillary components for masonry - part 5 : determination of tensile and compressive load capacity and load displacement characteristics of wall ties couplet test ; german version en 846 - 5 : 2000

    磚石工程輔助元部件試驗方法.第5部分:墻拉桿抗拉荷載
  6. Methods of tests for ancillary components for masonry - part 6 : determination of tensile and compressive load capacity and load displacement characteristics of wall ties single end test ; german version en 846 - 6 : 2000

    磚石工程輔助元部件試驗方法.第6部分:墻拉桿抗拉荷載
  7. Methods of test for ancillary components for masonry - determination of shear load capacity and load displacement characteristics of shear ties and slip ties couplet test for mortar joint connection

    圬工輔助砌塊的試驗方法.剪切桿和滑動桿的拉伸和壓縮負載容量和負載轉移特性的測定
  8. Methods of test for ancillary components for masonry - part 7 : determination of shear load capacity and load displacement characteristics of shear ties and slip ties couplet test for mortar joint connections

    圬工輔助成份試驗方法.第7部分:拉伸和壓縮負載容量和墻系柱和負載代替特性測定
  9. The load displacement curves and the ultimate strength of each member are presented. effects of beam length, radius of curvature and flexural - torsional rigidity on ultimate are considered

    通過試驗研究，給出每個構件的荷載位移曲線和極限承載力，得到了曲梁承載力隨跨長、曲率半徑以及截面尺寸的變化規律。
  10. With the mechanics simulation of temperature load and time independent, it is on time made to monitor the corresponding load displacement field and the change tendency at any time, and is monitored the dam work regularity

    並對溫度和時效進行力學的模擬，使其及時監測在任何時刻所對應荷載的位移場和變化趨勢，從而監控大壩的運行性態及規律。
  11. First, the generalized elastic theory is employed into in single pile analysis. the degeneration solution is accordant with poulos " results. analyzing the load - displacement behavior of the battered pile, the results agree well with meyerhof ' s model experiments and zhanglm ' s centrifuge experiments

    對于直樁，退化為彈性理論的計算結果同poulos的結果一致，退化為荷載傳遞法與他人的結果基本吻合；然後研究了斜樁的荷載-變形特性，把公式用於計算meyerhof的模型試驗以及zhanglm的離心機試驗的荷載-位移關系，發現同試驗結果吻合較好。
  12. A load - displacement full - process analyzing program of cfrp - confined rc eccentrically loaded columns is given. the computed results of load - displacement coincide with test results

    編制荷載-撓度全過程計算程序對碳纖維布約束偏壓柱進行數值分析，程序計算曲線與試驗曲線吻合良好。
  13. Comparison including the cracking, yielding and ultimate loads of the beam, load - displacement curve, envelop curve, the ductility and energy - dissipation capacity were made between the response of the specimens before and after strengthening. test results indicated that the yielding loads of the specimens after strengthening were improved from 12. 3 percent to 17. 2 percent and the improvement of specimens rehabilitated by jacketing was higher than that of the bonding steel plates one

    加固后試件破壞同樣發生在梁端，屈服荷載比加固前提高12 . 3 17 . 2 ，與粘鋼加固相比，加大截面法加固的試件承載力提高幅度較大；加固后試件的延性和耗能性能比加固前有很大的改善，其中以粘鋼加固的試件提高最為明顯。
  14. Through the pull - out experiment, the load displacement curve was obtained. contrasting the test results under the different condition to post - installed bar, it was clear about the mechanism of the inorganically post - installed bars. the test results of inorganically post - installed bars was compared especially with the traditional organically post ? installed bars

    通過拉拔試驗，得到了荷載位移曲線，對比了不同條件下植筋的試驗結果，明確了無機植筋的受力過程，特別同有機植筋進行對比，並提出了帶錐頭無機植筋的施工工藝。
  15. The method that discussed here is also suitable for joist floors. the theory basis is applied for understanding the inner load, displacement, and its varying regulation of the structure

    所述方法基本也適用於密肋樓蓋，也為深入理解該類結構的內力、位移及其變化規律提供了一些理論依據。
  16. Based on fem analysis software ansys, a cylindrical latticed dome of an aerodrome is analyzed as an example. the progress of load - displacement for the whole structure - - cylindrical latticed dome & columns is record

    本文利用結構分析軟體ansys ，以某機場航站樓單層柱面網殼結構為例，追蹤了柱面網殼+支承柱這一整體結構的荷載-位移全過程。
  17. Based on behavior of joint core under cyclic reversal load, according to actual measurement load - displacement hysteresis loops, slip of longitudinal reinforcement passing through joint and shear deformation of joint in a serial of beam - column subassemblage tests, the typical slip hysteresis model of longitudinal reinforcement passing through joint and typical shear deformation hysteresis model of joint are proposed in this paper

    本文以節點的受力特性及規律為基礎，基於若干樑柱組合體低周交變加載試驗的實測節點恢復力滯回曲線以及從中分離出來的貫穿節點的梁筋滑移變形結果、節點剪切變形結果，分析總結得到有一定代表性的梁端剪力與貫穿節點梁筋滑移之間和梁端剪力與節點剪切變形之間的滯回關系模型。
  18. In the elastic term, the two load - displacement curves slope are similar, the new structure s slope is more greatly. stiffness is better than the traditional structure. but the new joint s crack load is littleer

    在彈性階段兩者的荷載-位移曲線斜率相差不多，而且新的連接形式斜率還大一些，它的剛度較傳統連接形式要好，但新的連接形式樓板開裂荷載稍偏低，應採取加強措施來提高開裂荷載。
  19. Furthermore, it was shown that load - displacement of pile groups and load distribution on pile top were affected by properties of soil and stiffness ratio of piles to soil, and by length, diameter, spacing, and number of piles

    在此基礎上，分析了剛性承臺條件下超大群樁基礎的荷載位移曲線變化規律以及樁頂荷載分佈規律受樁土剛度比、樁長、樁徑、樁距、樁數、土性等因素的影響規律。
  20. ( 4 ) moment - curvature hysteretic curves, load - displacement hysteretic curves and their skeleton curves were calculated by fiber element method

    （ 4 ）利用纖維模型法，對壓彎構件的m -和p -滯回關系曲線及其骨架線進行了分析。
分享友人
分享到 Line

分享到臉書