load transistor 中文意思是什麼

load transistor 解釋
負載晶體管
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  • transistor : n. 【無線電】晶體（三極）管；晶體管[半導體]收音機。 a transistor radio 晶體管[半導體]收音機。
  1. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  2. Current mirror circuits may be found in two basic varieties : the current sinking configuration, where the regulating transistor connects the load to ground ; and the current sourcing configuration, where the regulating transistor connects the load to the positive terminal of the dc power supply

    鏡像電流源可能以兩種基本的類型出現：調整管連接負載到地的吸電流結構；以及調整管連接負載到直流電源正極的灌電流結構。
  3. Green - mode which provides off - time modulation to linearly decrease the working frequency under light - load conditions and power limiting which will turn off the transistor when peak current of inductor reaches the threshold current

    同時該電路集成了能在輕負載情況下自動降低頻率的綠色模式以及能在電感峰值電流過高時關斷調整管的功率限制模塊，降低了系統的功耗。
  4. To compare with transistor ( complete solid - state ) high - frequency linear power amplifier, there are some disadvantages : bad stability and reliability, low efficiency, high cost for operating, huge cabinet, heavy maintenance work load, low security for high - voltage electricity offering, and to ensure the continuance of tv program, the transmitter must be operating with main frame and spare frame

    它們與晶體管（全固態）高頻線性功率放大器相比，存在著穩定性及可靠性差、效率低、運行費用高、發射機體積大、日常維護工作量大、高壓供電不安全、必須採用主機和備機的運行方式來確保電視節目不停播等缺點。
  5. Compared with quasi - resonant, it can reduced transistor voltage stress and improved load range and stability in low frequency range. because of the structure of three - level, transistor voltage stress and filter can be reduced significantly

    與傳統的準諧振變換器相比，該變換器功率器件的電壓應力大大降低，在很窄的開關頻率變化范圍內實現寬負載范圍的軟開關。
  6. That is, through analysis of the principle on flow control and " hydraulic transistor ", design and calculation of flow control characteristic as well as main parts in valve inner chamber, a piloted reducing valve will be installed between main valve and pilot valve. after a pressure - difference compensating reducing valve was added in the non - pressure compensating piloted reducing valve of the flow control valve in vlalvistor valve, the calculation on control characteristic emulation and load characteristic emulation has been carried out. the result of the calculation shows that after pressure compensating reducing valve was added, the linearity of the control characteristics has been greatly improved thus eliminating influence upon outlet flow by load pressure - change of the hydraulic system and improving performance characteristics of the hydraulic component

    文章還在對瑞典valvistor閥的插裝比例閥研究的基礎上，提出了一種新的流量控制原理，即：通過對流量控制和「液壓晶體管」原理的分析、流量控制特性及閥內腔主要結構件的設計計算，在主閥和導閥之間增設先導減壓閥，並進一步對valvistor閥的流量控制閥之無壓力補償先導減壓閥、加入壓差補償減壓閥后的控制特性進行了模擬計算和負載特性模擬計算，結果表明：增設壓力補償先導增壓閥后，其控制特性曲線變得非常線性，從而消除了液壓系統負載壓力變化對主閥輸出流量的影響。
分享友人
分享到 Line

分享到臉書