low-load 中文意思是什麼

low-load 解釋
低負載
  • low : adj 1 低的;淺的,矮的。 low flight 低飛。 a low temperature 低溫。 low tide [water] 低潮。 The g...
  • load : n 1 裝載,擔子;負擔;工作(負荷)量。2 (車船等的)裝載量;一馱,一車,一飛機。3 【電、機】(機...
  1. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下,當裝置穩態功率變化時,冷卻劑平均溫度與蒸汽壓都保持不變,與通常採用的冷卻劑平均溫度恆定運行方案相比,有效地改善了核動力裝置的總體運行性能,特別是在低負荷運行時,可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件,這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  2. And a solve scheme is presented, controlling the voltage of 220kv power network in chongqing under 232kv during low load period. with the increase of load and power supply, the reasonable positions and capacitance of reactive power compensation become reasonless

    隨著負荷的不斷增加,電源亦隨之大幅度增加,使得原網路中本來合理的補償位置、補償容量變得不合理,因此有必要重新選擇補償點。
  3. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件,以水為工質,對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究,實驗壓力為0 . 02 0 . 8mpa ,實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式,彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  4. The cooling or heating loads of different conditioned zones in one system are highly diversified and variable, or the time of operation under low load is long, and the temperatures in conditioned zones need to be controlled individually

    同一個空氣調節風系統中,各空調區的冷?熱負荷差異和變化大?低負荷運行時間較長,且需要分別控制各空調區溫度
  5. The results show that the composites were more wear resistant than the matrix, contributing to the " volume effect " and " size effect ", the wear resistance increases with the particle content and size. the composite shows better wear resistance than high chromium cast iron material especially in low load and fine abrasive test condition. the results also indicate that the composite strengthened by ageing treatment was more wear resistant than as - cast composite

    磨損試驗結果表明,鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料具有比較高的抗磨料磨損能力,而且其耐磨性隨著鑄造碳化鎢顆粒體積分數及尺寸的增大而提高,表現出了強烈的「體積效應」及「尺寸效應」 ,尤其是在低載荷、細磨料磨損條件下,復合材料表現出更好的而寸磨性,即使與高鉻鑄鐵( cr28 )相比也有很大程度的提高。
  6. A series of multi - pulse experiments are performed at breakdown voltage up to 400kv, peak current up to 30ka with an interval of 5ms, which shows spark gap switch could be obtained good insulation recovery in several milliseconds under the condition of water dielectric pulse power modulator with low load

    在擊穿電壓400kv ,峰值電流30ka ,脈寬40ns的工作參數下,採用吹氣的辦法(氣流速度30m / s ) ,使氣體火花開關多脈沖運行間隔達到5ms ,實驗結果與理論估計相符。
  7. Opposite nip type line with rubber butterfly valve, metal hard seal eccentric butterfly valve, intensifying polytetrafluoro - ethylene soft ? sealing butterfly valve, low - load light type high temperature butterfly valve, fluorine - butterfly butterfly valve

    對夾式襯膠蝶閥,金屬硬密封偏心蝶閥,強化聚氟乙烯軟密封蝶閥,低負載輕型高溫蝶閥,襯氟蝶閥。
  8. Suilable for low load position, wear performance worsens greatly when under middle or high load. can be applied in furnace door lindge, furnace, conveyor, tool machines, light industries, etc

    51主要適應低載高溫中速的使用場合,例如壁爐門鉸鏈、烘爐滾道、輕工機械、機床工業等。
  9. In the same way, we should consider the problem that reactive power surplus and over - voltage during the period of low - water and low load

    同樣在枯水期輕負荷時,我們也要考慮到無功功率過剩,系統電壓偏高的問題。
  10. Leaving the rated load, especially with low load and free running operation, ihe efficiency of turbocharger and ratio boost pressure decrease, leading to the shortage of air in cylinders and worsening of combustion, and the economic, power and exhaust performances deteriorate

    當偏離標定點,尤其在低負荷和空轉工況工作時,增壓器效率降低,增壓壓力明顯下降,導致氣缸供氣不足,缸內燃燒不良,柴油機的經濟性能、動力性能和排放性能將嚴重惡化。
  11. Vickers hardness testing of resistance spot, projection and seam welds low load and microhardness

    電阻點焊凸焊和滾焊的維氏硬度試驗
  12. In the actual cases, there are many motors often operate on low load with low power factor and low efficiency, also there are many motors operate on the magnetic flux saturate region with high energy consumption, a large mount of energy used by ac motors is wasted due to all of those factors

    在實際運行中,許多電動機經常處在低效率、低功率因數的欠載運行狀態下,還有許多電機則是鐵芯磁通常進入飽和區的高能耗電機,這些因素均可導致大量電能的浪費。
  13. The paper introduced the run characteristics and their designed load performance of large - scale units with output of 200mw and over in hubei province, as well as their improved load performance after the modification of burner for low - load stable combustion

    摘要簡要介紹了湖北省200mw及以上大型燃煤鍋爐機組的運行特性、設計調峰性能,以及經過對燃燒器進行低負荷穩燃改造以後,調峰能力的改善。
  14. With the reference of many relevant materials, the author prepared a fined molybdenum disulfide powder with a average size of 800nm by ball milling, and a nano - copper with average size of 30nm in micromulsion solution method, and synthesized surface - modified titanium dioxide nanoparticles with average size of 40nm in organic media via sol - gel method. the tribological performances of three particles were studied by universal test as well, with the result of fined molybdenum disulfide powder with good reducing wear and antiwear performance at low load, nano - copper with good reducing wear and antiwear performance at high load, surface - modified titanium dioxide nanoparticles maintaining stable reducing wear and antiwear performance from low load to high load due to its characteristics of organic and inorganic nanocomposite. the results indicate that the nanocomposite is the most perspective oil additive. the reducing wear and antiwear mechanism of nano oil additive was studied with in - situ tribochemical principle. nano additives possess broadly developing prospect with its above - mentioned performance

    在參閱了大量文獻的基礎上,分別採用了球磨法、微乳液法、溶膠?凝膠法制備了超細二硫化鉬、納米銅粒子、表面修飾納米二氧化鈦,經原子力顯微鏡測試,獲得的超細二硫化鉬的粒度平均在800nm以內,納米銅粒子平均粒度約為30nm ,表面修飾納米二氧化鈦平均粒度約為40nm ,在萬能摩擦磨損試驗機上測試了三種粒子的摩擦學特性,結果表明:在合理的添加濃度范圍內,超細二硫化鉬在低載時具有優良的減摩抗磨性能,納米銅在高載時具有比較好的減摩抗磨性能,表面修飾二氧化鈦粒子因具有有機與無機復合物的特性,從低載到高載都保持穩定的減摩抗磨性能。
  15. In china, feedwater control system of most power plants can not be in automation at full range, especial during low load after synchronization

    在國內,有相當一部分機組給水控制系統不能投入全程自動,尤其在並網后低負荷階段。
  16. It consists of the method that cleaning the steam path by steam on low - load and that cleaning the steam path by water spray into the turbines

    即高壓水射流噴砂除垢清洗方案研究方案,此方案對指導實際的汽輪機通流部分結垢清除具有參考借鑒作用。
  17. The efficiency is very high, especially under low load condition, because the output voltage is regulated by skipping clock cycles as necessary

    該電荷泵採用跳周期( skipcycles )控制模式,具有在輕負載情況下效率高的顯著優點。
  18. Although oil is used only in the case of ignition and low load operation, the amount is very great. in order to save the precious and expensive oil, a novel technology, induction - heating multi - stage free - oil ignition technology of pulverized coal ( mfit ), is brought forward in this thesis. based on the study of ignition mechanism of coal, ignition criterion, heating method and ignition theory of pulverized coal ( pc ), mfit integrates hot - wall ignition technology, induction heating technology and multi - stage ignition technology

    為降低電站鍋爐點火成本和低負荷運行費用、解決電站鍋爐點火用油和低負荷助燃用油居高不下的問題,在分析研究煤的著火機理、著火判據、加熱方式和煤粉的點燃理論的基礎上,本文將熱壁面點火、感應加熱、多級點火等過程有機地結合起來,進行了感應加熱煤粉多級無油點火的試驗研究。
  19. The cooling method of nature oil circulation is not only widely used in small - middle type power transformer, but also used in large type power transformer with low load and low ambient temperature

    自然油循環的冷卻方式不僅廣泛應用於電力網中的中小型電力變壓器,也會在在大型電力變壓器低負荷和低環境溫度時應用。
  20. During the calculation of reactive power and voltage in the power network, reactive power insufficiency and the system under - voltage are always concerned. in the same way, we should consider the problem that reactive power surplus and over - voltage during the period of low - water and low load

    在無功電壓優化計算中,對于無功功率不足和系統電壓偏低的情況一直是研究者關注的問題;同樣在枯水期輕負荷時,電網運行中也要考慮到無功功率過剩,系統電壓偏高的問題。
分享友人