modulating amplifier 中文意思是什麼

modulating amplifier 解釋
調制放大器
  1. In succession, the theory of chirped - pulse amplifier system is given in detail, firstly, studying from designing experimental light road and optical components to theoretical analysis, we par ' tly finished the system by ourselves. about ultr a - shoft pulse with a pulse - width of 9. 8f s and output power of 650mw and band - width of about l 20nm is output from oscillator source, secondiy, the stretching capacity of single grating four - pass stretcher is measured using abcd matrix combining collins function, and the effect of relativ e parameters to the streching ratio is also simulated. thirdly, a new type of disjunctional frequency moduiating function is provided according to the gain - narrowing and gain - saturation which are appeared in the co urse of amplification, under modulating the two effects are both controlled on some e xtent, fourthiy, the effect of ase that is often ignored by people is analyzed and the resolving methods are also given

    從光路、光學元件的自行設計到理論分析計算,初步建立了一臺實驗系統;採用abcd矩陣法結合collins公式計算了四通式單光柵展寬器的展寬量,並模擬了相關參數對展寬比的影響,對實驗具有指導意義;評價了再生放大器和多通放大器的優缺點,對放大過程中通常忽略的放大自發輻射現象( ase )進行了分析,並提出了相應的解決方法;針對放大過程中出現的增益窄化和增益飽和現象,對輸入種子脈沖提出了一種新的分段頻率調制函數,實現了對增益窄化效應和增益飽和效應的共同抑制;提出了系統的材料(包括放大介質和光路中的普通介質)正是融合高階色散的來源。
  2. Based the research on the laser beam drift feedback control technique, analysing the beam drift and its frequency components, a laser beam directional stability method is studied in the thesis in detail, with its measurement and control circuit system that combines the laser beam intensity modulation and the beam drift feedback control technique. in this method, at first the laser beam intensity is modulated with the acoustooptic modulator, then the lock - in amplifier is applied to detect and demodulate the modulating signal, at last a feedback control signal is generated by the dsp control circuit at last, including : 1

    本文在原有的激光光束漂移量反饋控制準直技術的基礎上,對光束漂移量信號的數據和頻譜進行了分析,重點研究了一種集聲光調制光強與光束漂移量反饋控制準直技術於一體的激光光束方向穩定方法及其測控電路系統,該方法通過聲光調制實現光強調制,接著通過鎖相放大電路檢測並解調調制信號,然後通過dsp控制電路進一步對光束的漂移量進行反饋控制。
分享友人