negative-feedback amplifier 中文意思是什麼
negative-feedback amplifier
解釋
負反饋放大器-
While working on a means of reducing amplifier distortion, he devised the negative feedback amplifier.
在研究減少放大器失真方法時他發明了負反饋放大器。 -
In the forth chapter the series negative feedback and interstage mismatching are presentation, and a low noise amplifier whose operating frequency is 1. 5ghz 1. 8ghz is developed
第四章詳細介紹了源極串聯負反饋和級間失配法，並設計和製作了1 . 5ghz 1 . 8ghz低噪聲放大器。 -
The restudying of network analysis on negative - feedback amplifier
負反饋放大器網路分析的再研究 -
Discussion of negative feedback types in amplifier circuits
放大電路中負反饋類型的討論 -
Research of the negative feedback amplifier experiment in the current combination
電流並聯負反饋放大器實驗的研究 -
The calculation of relative variation of the negative feedback amplifier by differential method results in some errors under certain condition, so there was certain limitation in this method
摘要利用求微分的方法計算負反饋放大器增益的相對變化量，由於在一定的條件下計算出的結果存在一定誤差，因而使用這種方法具有一定的局限性。 -
Theoretically several solutions are derived in the final scheme such as broadband matching technology which included negative - feedback technology, traveling wave technology and balance technology. in addition, the design will be optimized by eda software and the final test result indicates that our design is successful. the principle of microwave amplifier is introduced at first in this paper, especially its main parameters index sign, then the material performance and the influence of parasic parameter and model setting of the gaas phemt is discussed
文中首先介紹寬頻帶放大器的主要參數指標，接著介紹了gaasfet的材料特性，以及phemt管芯寄生參數對實際放大器設計的影響，然後討論gaasphemt的大、小信號模型的建立與分類;結合gaasphemt模型和s埠參數分析了寬頻帶匹配技術的原理;最後論述本課題中各個放大器實現的具體方案，以及在放大器實現過程中應該注意的問題，給出了實際寬帶放大器的測試結果，並將軟體模擬結果與實測曲線進行對比。 -
In the fifth chapter the shunt negative feedback is presented, and a low noise amplifier whose operating frequency is 0. 2ghz 2ghz is developed
第五章分析了漏極並聯負反饋在寬帶低噪聲放大器設計中的作用和原理，並設計、製作了0 . 2ghz 2ghz低噪聲放大器。 -
In this paper, the application of ewb simulation technology in electronic circuit course design is introduced, using negative feedback amplifier as a example
摘要以「負反饋放大器」課程設計為例，分析了ewb模擬技術在電子線路課程設計教學中應用的實施過程。 -
This subject aim at designing a linear power amplifer whose output power is 40w for 225 - 450mhz band. but it seems not easy to finish the task because of this power amplifier own unique requirements including high output power, broad working frequency band, high linearity, and flat gain. due to the complexity involved, theoretically several soltuions are derived in the final scheme such as broadband matching technology, power - retreat, power synthesize, automatic power control and negative feedback. in addition, the design will be optimized by eda software and the final test result indicates that our design is successful
本課題的目標是研製一個輸出功率為40w的225 450mhz的線性功率放大器。由於該功放要求輸出功率大，工作頻帶寬，帶內增益波動小，線性度高，所以其終合設計難度大。鑒于這個原因，在理論設計上筆者採用了寬帶匹配、功率合成、功率回退、負反饋、自動功率控制等技術；在實踐中精心設計電路，並且配合eda軟體模擬，最終達到所要求的指標。 -
In the fifth chapter, a new fully differential operational amplifier with voltage and current - mode negative feedback has been proposed, which can stabilize its quiescent operation point, using the characteristic of mos transistors which operate in the triode region acting as active variable resistor, a fully differential fourth - order chebyshev low - pass filter with tunable frequency and bessel low - pass filter with accurate group delay based on r - mosfet - c and operational amplifier has been designed
第五章：提出了一種新的既具有電壓共模負反饋又同時具有電流共模負反饋的全差分運算放大器電路，能較好地穩定電路的靜態工作點，並應用mos管工作在線性區可作有源可變電阻用的特性設計得到了截止頻率可連續調節的高性能r - mosfet - c 、運放結構切比雪夫（ chebyshev ）和精確群時延值貝塞爾（ bessel ）低通濾波器。 -
Broadband matching is very difficult, but we can make it easier with negative feedback and balanced amplifier. so at first we should choose a project, then according to the requirement of the low noise amplifier to choose the transistor, bias and matching
寬帶匹配網路的設計是一個難點，可以採用負反饋、平衡電路等形式降低寬帶匹配的難度，所以寬帶電路的設計首先是方案設計。
分享友人