oblique stress 中文意思是什麼
oblique stress
解釋
斜向應力-
The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection
本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。 -
It was showed that under the transverse tension, high stress concentration and even concrete cracks would appear on the oblique webs of the model
研究表明，在張拉橫向預應力鋼束以後，主梁邊箱斜腹板中部會出現高拉應力區以及混凝土裂縫。 -
Comparison and analysis of the stress distribute rule and deformation of two kinds of combination dies that with flat end plane or with oblique end plane cavity come to conclusion that the oblique end plane combination die is of higher intensity
摘要通過對平、斜端面組合凹模在預緊及合成兩種狀態下應力和變形位移的對比分析，得出了斜端面組合凹模的應力分佈規律，指出在其他條件相同的情況下，斜端面組合凹模具有更高的強度。 -
Abstract : comprehensive measuring and testing of oblique shearers was carried out, based on finite element and testing stress analysis, through which shortcomings of the shearer can be found out and improvement is possible
文摘:在理論分析、有限元計算和機架模型應力分析的基礎上對四米斜刃剪切機進行了綜合測試，為剪切機的改造提供科學依據。
分享友人