point beam 中文意思是什麼

point beam 解釋
點波束
  • point : n 1 尖頭，尖端；尖頭器具；〈美國〉筆尖；接種針，雕刻針，編織針；小岬，小地角；【拳擊】下巴。2 【...
  • beam : n 1 梁，棟梁，桁條；（船的）橫梁。2 船幅；（動物、人的）體幅。3 （秤）桿，杠桿，（織機的）卷軸，...
  1. The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection

    本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。
  2. The diffusion welding behavior of single - crystalline cu to single - crystalline - aio with a nb film interlayer and the joint microstructure properties were studied by tem, sem / eds analyses and four - point bend testing. the nb film interlayer deposited by electron beam evaporation on the ceramic side prior to diffusion welding was found to be olycrytalline and fiber - textured after diffusion bonding, with the close - packed plane ( 110 ) being parallel to the ( 0001 ) basal plane of - aio

    擴散連接技術是一門邊緣科學，涉及材料、擴散、相變、界面反應、接頭應力應變等各種行為，工藝參數多，雖然已經進行了大量的試驗研究，但卻對各種材料的連接機理尚未有明確的認識，為此人們試圖藉助于計算技術，對接頭行為進行數值模擬，以便找到共同規律，對擴散連接過程及質量進行預測與實時控制。
  3. Chapter 3 studies the false target jamming. jamming signal generation formula is proposed by the investigation of simultaneous ground echoes of two different point targets in radar beam. comprehensive research about the characteristics of jamming signal is made, and raw data is used in simulation

    第三章對虛假圖像干擾進行了研究，通過對雷達波束內兩個不同的點目標在同一時刻的回波信號進行的分析比較，推導了干擾信號的生成公式，對干擾信號的特徵作了詳細的分析，並結合實測數據做了模擬實驗。
  4. Lin h, li l and zeng l., " in - situ end - point detection during ion - beam etching of multilayer dielectric gratings ", chin. opt. lett., 3 ( 2 ), 63 ( 2005 )

    林華， "介質膜光柵:光刻膠掩模占寬比和離子束刻蝕槽深的監控" ，博士論文，導師:李立峰（ 2006 ）
  5. Abstract : in this paper ， a ray - optics analysis is performed to investigate the asymmetry of dual beam scanning field produced by a rotating polygon. some basic equations of dual beam scan are derived ， such as ， the position vector for the incident point ， the scalar expression for reflected ray ， scan pattern on observation plane ect. the far - field asymmetry of the scanning field has been discussed

    文摘:應用幾何光學理論研究了多光束轉鏡掃描場的非對稱性，導出多光束掃描入射點位置矢量、反射線標量表達式、觀察面上的掃描軌跡方程，並研究了掃描遠場的非對稱性。
  6. " when a particle beam is directed toward a point on the surface, the gold atoms bounce off and expose the silicon layer underneath just like a hammer and chisel, " zohar said

    當粒子光束被導向于矽片表面的某一點，金原子反彈，露出底下的矽層，就像是鐵?與鑿子的作用，左哈爾說。
  7. Abstract : a new method for determining proximity parameters, and in electron - beam lithography is introduced on the assumption that the point exposure spread function is composed of two gaussians. a single line is used as test pattern to determine proximity effect parameters and the normalization approach is adopted in experimental data transaction in order to eliminate the need of measuring exposure clearing dose of the resist. furthermore, the parameters acquired by this method are successfully used for proximity effect correction in electron - beam lithography on the same experimental conditions

    文摘:在電子散射能量沉積為雙高斯分佈的前提下，提出了一種提取電子束光刻中電子散射參數，和的新方法.該方法使用單線條作為測試圖形.為了避免測定光刻膠的顯影閾值，在實驗數據處理中使用歸一化方法.此外，用此方法提取的電子散射參數被成功地用於相同實驗條件下的電子束臨近效應校正
  8. 7 the shaft of his spear was like a weaver ' s beam, and the iron point of his spear weighed six hundred shekels. his shield bearer was walking before him

    7他的標槍柄像一枝織布機的桿木，他的矛頭鐵尖重7 . 2公斤.他的持盾人走在他前面
  9. Suddenly, like a great sword of flame, a beam from the setting sun pierced the stygian gloom, and smote upon setting the point of rock whereon we lay, illuminating ayesha's lovely form with an unearthly splendour.

    突然，一縷落日的余輝，象一柄巨大的火劍，劈開了這兒的陰森森地獄般的黑暗，落在了我們趴著的這塊巖石上，以一種奇異的光輝照亮了阿霞美麗的身影。
  10. The modified traveling wave monopole model is employed in simulating the electron beam in crt of computer vdu. meanwhile acceleration fields of the electron beam are studied in details and its expression given for the first time with measured results. a novel analyzing method is proposed to study the spectrum of electromagnetic information leakage based on the viewpoint of field point, which has been verified effective by experiments

    採用經修正的行波單極子模型模擬計算機陰極射線管顯示器電子束，並詳細研究了電子束的加速場，首次給出了其計算公式和實驗測試結果；還提出了一種新的從場點出發的信息電磁泄漏頻譜分析方法，實驗證明了其有效性； 3
  11. 4, single focuse the single head : is single for single laser head that panasonic lead off to adopt to focuse the double the laser beam for focusing ordering the project, he adopting the special whole synthesizing lens, passing lens in the center part ofly the focusing of formation cd the point, and pass the anastigmatic laser beam of part edge the formation the focusing of dvd the point, this kind of construction because of have no the machining to spread to move, and also can t produce the mechanical trouble, therefore increased to recognize the dish the speed, and however and also lowered the cost. but adoption this project of generation is with part of the next generation dvd nonsupports cdr

    4單聚焦單鏡頭：為panasonic率先採用的單激光頭單聚焦鏡雙聚焦點方案，他採用特別的全息綜合透鏡，通過透鏡中間部分的激光束形成cd的聚焦點，通過透鏡邊緣部分的激光束形成dvd的聚焦點，這種結構由於沒有機械傳動，也不會產生機械故障，所以提高了認盤速度，不過同時也降低了成本。但採用此方案的第一代和部分第二代dvd不支持cdr 。
  12. The harmonic analysis method for computing force of end - point of variable cross - section beam when it does transverse vibration

    計算變截面梁橫向振動時桿端力的調和分析法
  13. By digitization, we optimize the intensity data of the incidence beam at the vicinity of start point and end point. 3

    通過選擇合適的塗膠參數，在凹透鏡表面上進行了薄光刻膠膠層的均勻塗布。
  14. In chapter 5, by number value simulation calculation and experiment of one simple support beam, we will compare the magnitude of the coupling static and dynamic stress at each point on the girder under harmonic excitation, and so find conclusions such as : ( 1 ) there are so much correlations between structure damage and environmental effect and exterior excitation leads dominant effects in structure damage that we should consider static and dynamic stress together. ( 2 ) new intension design rules should be set up, according which the range of structure possible damage position should be estimated in advance

    得到以下結論： （ 1 ）結構的破壞和環境的影響密不可分，外部激勵在結構破壞中發揮了重要的作用，應該將結構所受的靜力和動力一起考慮； （ 2 ）應該建立新的強度設計準則，並以此作為依據，對已知結構的可能損傷位置有預先的范圍估計，從而為損傷識別的準確定位提供理論依據。
  15. A traverse load on a beam causes a deflection or change in elevation at the point of application.

    樑上的橫向載荷在作用處引起撓度或垂直面內的變化。
  16. Based on huygens - fresnel diffraction integral theory, the propagation properties of bessel beam were studied in this paper. by using the analyses of geometrical optics, hollow beam are found and the formula of the starting point 、 the end point and the bottle length can be got

    論文中，我們基於惠更斯-菲涅耳衍射積分理論研究了由軸棱錐產生的貝塞爾光束的傳輸特性，並且通過幾何光學解析無衍射光束的聚焦特性。
  17. For a wiggly-line trace, the beam is focused on the scope face at a point.

    對于波形道，光束在熒光屏面的一點上聚焦。
  18. Jh30 and jh20 belong to low power physiotherapy. it is a kind of photochemical action in laser irradiating and beam needle. it has the advantage of no pain, no infect, no forbidden acupuncture point and convenience

    氦氖激光可對人體產生熱效應，電磁效應，光化學效應，具有止痛消炎活血化瘀，疏調經絡，照射人體血液，可降低血液粘度，改善微循環等作用。
  19. The advanced point estimate method is presented to evaluate the random properties of the torsion of thin - walled beam

    提出了改進點估計法來計算薄壁梁結構扭轉的概率特性。
  20. In the counting system, a semiconductor laser emitter is used as the light source, point laser beam produced by optic system, reflection of part transferred into electric signal by photoelectric triode, and scm system as the counter

    採用半導體激光發射器作為光源，經過光學系統形成的最小激光束照射器件，反射光由光電三極體進行光電轉換，計數控制使用單片機系統。
分享友人
分享到 Line

分享到臉書