pressure valve spring 中文意思是什麼
pressure valve spring
解釋
限壓閥彈簧-
Spring type safety valve on pressure steam sterilizer
壓力蒸汽滅菌設備用彈簧式安全閥 -
When the temperature to gas pipelines, temperature packets of material expansion, the pressure rise, inflation pressures are rising corrugated box, corrugated promote the expansion thrust to overcome the spring - loaded pole resistance, the ball - type valve opened for big change ; when the gas pipeline to reduce the temperature, temperature of the material swelling up, the pressure lowered inflation corrugated box pressure also reduced, spring - loaded pole compressed corrugated of resistance to thrust, spherical valves open for smaller ; this constant push and pull adjustment for the balance, as long as refrigeration cycle continue
當回氣管道溫度升高,感溫包內的物質膨脹,壓力升高,膨脹波紋箱內壓力也升高,波紋腔膨脹推動推力桿克服彈簧阻力,球型閥開度變大;當回氣管道溫度減低,感溫包內的物質膨脹,壓力降低,膨脹波紋箱內壓力也降低,彈簧阻力推動推力桿壓縮波紋腔,球型閥開度變小;如此不斷的進行推拉調整平衡,只要製冷循環繼續下去。 -
The delivery pressure acting on the spring loaded diaphragm throttles the balanced valve to control the pressure
水輸出壓力在彈簧負載隔膜的作用下對平衡閥進行節流調節,以控制水壓。 -
The reduced pressure detector assembly shall consist of two independent torsion spring check modules, a differential pressure relief valve located between and below the two modules, two drip tight shutoff valves, and required torsion spring check modules and relief valve shall be contained within a sleeve accessible single housing constructed from 304 ( sch 40 ) stainless steel pipe with groove end connections
這種減壓檢測器總成應該包括兩個獨立扭力彈簧止回閥模塊,一個位於兩個模塊之間的下方的差壓安全閥,兩個防滴漏關閉閥,並且要求扭力彈簧止回模塊和安全閥應該放置在一個套筒內,要易於接近帶溝槽連接的304 (目錄40 )不銹鋼管的單個外殼。 -
Pressure regulator valve spring
減壓器閥彈簧 -
The spring - loaded excess - pressure safety valve protects the pump as well as the gearbox from overload which may arise from an erroneously closed sluice valve or alternatively due to a blocked discharge pipe etc
彈簧超壓安全閥對泵及齒輪箱起著保護作用,使其避免由於出口閥門的誤關或管道的堵塞而引起的超載。 -
Due to the release of pressure when removing the cover, the relief valve spring may eject quickly
因為在拆卸閥蓋時松開壓力,安全閥彈簧可能會快速彈出來。 -
To avoid this discharge, install a spring - loaded check valve ahead of the backflow assembly to " lock - in " the downstream pressure
如果放置在坑內,則應該採取措施使得排放總是在地面上,或對于坑內排放,要確保在安全閥下方配置一個適當的氣隙。
分享友人