pump waveguide 中文意思是什麼
pump waveguide
解釋
抽運波導-
The pump power is fed through a second waveguide.
泵的功率通過第二個波導管饋入。 -
Ignored the amplified spontaneous emission ( ase ) and esa, rate equations and propagations equations for continuous wave er ~ ( 3 + ) / yb ~ ( 3 + ) co - doped phosphate glass waveguide laser were calculated using runge - kutta algorithm. propagation characteristics of signal and pump light in the waveguide were analyzed too
利用fd - bpm法，對在平板波導以及波導折射率為漸變折射率分佈的溝道波導和掩埋型波導內傳播的波長為980nm的泵浦光和1540nm的信號光的光場進行了模擬。 -
In this paper, some investigation and design as following. have been carried out on er - yb codoped phosphate glass waveguide laser first, three primary performance parameters of er - yb waveguide laser pump threshold power ; output power and slope efficiency have been commulated and analysed theoretically based on er ~ ( 3 + ) - yb ~ ( 3 + ) energy configuration ; rate equation of stable state and transmitting equation. the influences of er - yb ions concentration ; enabled waveguide length ; light dot radius of signal light and pump light ; reflectivity of output lens on three above parameters have been researched
首先，從er ~ （ 3 + ） - yb ~ （ 3 + ）能級結構出發，結合激光穩態速率方程與傳輸方程，對鉺鐿波導激光器的三個主要性能參數:閾值功率、輸出功率、斜率效率作了理論計算分析，並研究了鉺、鐿離子濃度、光波導激活長度、信號光與泵浦光光斑半徑比例、輸出耦合鏡反射率對這三個關鍵性能參數的影響。 -
A novel scheme is presented that can be used to efficiently pump optical waveguide amplifiers. it is based on the coupling between two adjacent waveguides, where pump light is gradually coupled from a non - absorbing pump waveguide into the amplifier waveguide
2 .對泵浦方式進行改進，基於鄰近波導間的耦合原理，提出一種能在整個波導長度上泵浦功率逐漸耦合進信號光波導中的耦合結構。 -
The gain characteristics of edwa have been investigated by solving numerically propagation equations and rate equations at pump wavelength 980nm. the gain characteristics are functions of waveguide length, erbium concentration and pump light power, so the relations between them are analyzed in detail in this paper. the size of edwa is also discussed here, which has some reference value for the following study and the design of waveguide amplifier
通過解析速率方程和傳輸方程，在波長為980nm泵浦光作為泵浦源的條件下，對摻鉺光波導放大器的增益特性進行了分析，由於波導放大器的增益是波導長度、摻鉺濃度和泵浦功率的函數，因此本論文對三者與信號增益的關系分別進行了討論。 -
Formula of gain has been developed by rate equations, several factors, such as doped concentration of er3 + - yb3 +, configuration of waveguide amplifiers and pump power etc, have been analyzed to increase gain
由速率方程得出光波導放大器的增益公式，分析影響放大器增益的各個因素。主要從鉺鐿離子的摻雜濃度，放大器的結構及泵浦功率三方面加以討論。 -
3. 5 cm long and 4um wide channel silica glass waveguide was fabricated by ag + - na + ion - exchange and 5 db net gain at 1536 nm was obtained with a pump power of 250 mw ( at 980 wavelength ) ; fwhm is 14 nm around 1536 nm
用波長為980nm ， 250mw的半導體激光器泵浦該條型波導，在1536nm波長下得到的最大凈增益是5db ：在1536nm附近3db凈增益譜帶寬是14nm 。
分享友人