range calibration 中文意思是什麼

range calibration 解釋
固定距標距離校準
  • range : vt 1 排列；整理（頭發等）。2 使歸類[班、行、隊]；把…分類。3 〈用被動形或反身形〉加入，站住…的一邊...
  • calibration : n. 1. 測定口徑。2. 刻度，標度，劃度數。3. 校準；標準化。
  1. For single - range voltmeters, calibration will be made at cardinal points ( maximum 5 points )

    單量程電壓表將就其基點進行校正（最多不超過五點） 。
  2. For single - range voltmeters, calibration will be made at cardinal points ( normally not exceeding 5 points )

    單量程電壓表將按主要基點進行校正（一般最多不超過五點） 。
  3. Single range voltmeters are normally calibrated at cardinal points ( maximum 10 test points ). for multi - range voltmeters, the basic calibration will include measurements at full ranges and linearity check at 5 voltage levels for one range. linearity check for other ranges can be offered at extra cost

    單量程電壓表一般以基點（最多十個測試點）進行校正；多量程電壓表的基本校正則會包括全量程測量及按五個電壓量位為一個量程進行線性檢查。
  4. The calibration is usually made at full range setting for each range

    一般每量程均作全量程定位校正。
  5. According to research of redundant signed digit ( rsd ) calibration theory of pipelined adc, a novel out of range detection rsd technique is provided. when input signal is out of the adc ’ s range, the technique can detect this situation and the wrong output word is avoided

    然後，在深入分析冗餘位演算法的基礎上，提出了新型的校正演算法，針對傳統演算法不能判斷信號超出adc處理范圍的不足，增加了溢出判斷功能，既能有效校正比較器的失調，又防止了信號溢出時的誤碼輸出，保證了系統的性能。
  6. Calibration of a single range high voltage voltmeter

    校正一臺單量程高壓電壓表。
  7. Calibration of a single range ac high voltage voltmeter

    校正一個單量程交流高壓電壓表
  8. As proved by experiments, the present method can effectively restrain the influence of speckle to the laser triangular measurement system and the obtained calibration accuracy is about 0. 05mm within 100mm depth range

    只需對特殊設計的模塊進行一次測量，便可完成對整個測量系統的校準。該方法能夠有效的抑制激光散斑的影響，具有較高的系統精度。
  9. Foxy - cal ( optional ) calibration option for foxy systems configured with temperature - compensation accessories ; users must specify the temperature and the concentration range for their applications

    配置溫度補償附件的用於foxy系統的校準選項；使用者必須指明他們使用的溫度和濃度范圍。
  10. Foxy - cal probe calibration service available to buyers of foxy systems having temperature - compensation accessories ; users must specify the temperature and the concentration range of their applications

    對購買帶溫度補償附件的買家的探測器校準服務；使用者必須指明他們使用的溫度和濃度范圍。
  11. The detection limit was 0. 5 ng / ml and the calibration curve was in the range of 0 - 100 ng / ml. the within - run coefficient variations for standard samples were less than 10 %. one distinguished feature of this approach was its nearly homogeneous reaction and solution phase detection, which made the detection rapid and reproducible

    5ng ml ，標準曲線范圍為0 - 100ng ml ，檢測標準樣品的批內cv小於10 ，採用這種液相反應及液相熒光測定的方法，提高了分析速度。
  12. The absolute calibration of hydrophones using the planar scanning technique in the frequency range 0, 5 mhzto 15 mhz

    用0 . 5mhz 15mhz頻率的水平掃描技術對水下擴音器進行的絕對校準
  13. Calibration of a single range dc high voltage supply

    校正一單量程直流高壓電源。
  14. Calibration of a multi - range high - voltage voltmeter with not more than 4 ranges

    校正一臺不超過四個量程的多量程高壓電壓表。
  15. Calibration of a multi - range ac high voltage voltmeter with not more than 2 ranges

    校正一個不超過兩個量程的多量程交流高壓電壓表
  16. A simple and easy range zero value calibration method

    一種便捷的距離零值標校方法
  17. The force laboratory provides calibration services for force measuring instruments such as proving rings and load cells in the measuring range from 0. 5 kn to 3 mn

    本所可為0 . 5kn至3mn力值范圍的測力計，例如測力環和載荷傳感器提供校正服務。校正0
  18. Calibration of a wattmeter at rated voltage with 5 different current settings on one current range ( at one frequency and one power factor )

    按額定電壓，校正一個電流量程上有五個不同電流值的功率表（一個頻率及一個功率因數） 。
  19. Based on engineering experience of the author and theoretical experience, the physical and geometry delay from feed center to off - set element under near - field environment is compared and discussed, and the influence of near - field conditions on zero - range calibration is analyzed, and satisfactory results have been got

    筆者綜合了以往的工程與理論經驗，在近場條件下討論了由饋源中心到偏饋振子的物理、幾何時延，分析了近場條件對距離校零的影響，得出了令人滿意的結論。
  20. Zero - range calibration is determination of the zero range value of equipment with a " reverse - measurement method "

    距離的校零是利用「反測法」確定設備的距離零值。
分享友人
分享到 Line

分享到臉書