refrigerant temperature 中文意思是什麼

refrigerant temperature 解釋
製冷劑溫度
  • refrigerant : adj. 解熱的,使清涼的;冷卻的。n. 清涼劑,涼藥;清涼飲料;冷卻劑,冷凍劑,致冷劑。
  • temperature : n. 1. 溫度,氣溫。2. 體溫。3. 〈口語〉發燒,高燒。
  1. J as the medium s temperature too high, must adopt refrigerant measure to machine - airproof, use to prevent whisht - ring of machine - airproof to dehisce

    10介質溫度過高時,應對機封採取冷卻措施,以防機封靜環開裂。
  2. Our mylar sleeves are mainly used to protect a wide range of electrical equipments, such as thermal protectors, temperature limiting switches, refrigerant compressors, rechargeable batteries, fuses, transformers, motors, electrical wires, electrical ? heating elements, capacitors, telephone relay, soldered dot, tie - in and winding, etc

    我們的聚脂套管主要用於熱保護器、高溫控制開關、製冷壓縮機、充電電池、保險絲、變壓器、馬達、電線、電器元件、電容、電話繼電器、焊點、接頭、線圈等耐絕緣及機械保護。
  3. Based on the refrigerant state, divides a heat exchanger into three zones with zoned lump method, i. e. superheat, two - phase and subcooling zones, works out the temperature difference and heat transfer coefficients of the three zones

    採用分區參數法將換熱器按製冷劑狀態分為過熱、兩相、過冷三區,分別計算了各區的換熱溫差、傳熱系數等。
  4. This experiment focuses on the characteristic of green refrigerant r600a in a small parallel flow aluminum closed two - phase thermosiphon and measures all the quantity of injected mass and heat dissipation, the speed of air and the difference of temperature of the electronic element ( cpu simulate chip ) surface and environment

    處理速度達到g數量級,功率消耗更達幾十瓦。如何解決cpu散熱問題,成為關注的焦點。本實驗首次研究了綠色環保工質r600a在一種鋁質重力熱管中的工作特性。
  5. On the basis of the investigation on the related literatures of new refrigerants substitutes and new refrigerant oil, the in - tube evaporation of refrigerant and refrigerant - oil mixtures. this paper make a experimental research on the saturated temperature of propane ( r290 ) and lubricant oil ( suniso 3gs ) mixtures, evaporation heat transfer and pressure drop characteristics in a horizontal micro - fin tube

    本論文在參考研究國內外有關製冷工質、替代製冷工質及其含潤滑油混合物在水平管內流動沸騰換熱研究現狀的基礎上,對丙烷( r290 )與潤滑油suniso3gs的混合物的飽和溫度、水平微肋管內流動沸騰換熱及壓降進行了實驗研究與理論分析。
  6. On the basis of the investigation on the related literature of new refrigerant substitutes, the in - tube condensation of refrigerant and refrigerant - oil mixtures, this paper investigates the saturated temperature of hc290 - oil mixtures, condensation heat transfer and pressure drop characteristics in a horizontal micro - fin tube for it

    本文在分析研究國內外有關替代工質、製冷工質及其含油混合物管內凝結性能研究現狀的基礎上,對純天然工質丙烷( hc290 )與潤滑油suniso3gs的混合物飽和溫度、水平微肋管內凝結過程的傳熱及流阻特性進行了實驗研究分析。
  7. Simulation study of internal model control system of refrigerant average temperature of nuclear reactor

    核電站反應堆冷卻劑平均溫度內模控制系統模擬
  8. The results show that while the mass flow of refrigerant is 1. 85g / s, the inlet temperature of refrigerant is 18. 9, the evaporating pressure is 0. 62mpa, the mass flow of water is 31. 1g / s, and the inlet temperature of water is 36. 9, the refrigerant of miniature evaporator wholly vaporizes in the tube, and the heat transfer rate is 342w. it achieved the demand of design

    經過實驗測試,當製冷劑質量流量為1 . 85g / s ,製冷劑入口溫度為18 . 9 ,蒸發壓力為0 . 62mpa ,水的質量流量為31 . 1g / s ,水的入口溫度為36 . 9 ,此時,螺旋管蒸發器內製冷劑完全蒸發,換熱量342w ,達到了微型蒸發器的預期設計要求。
  9. At the same time, experimental study on boiling heat transfer by changing mass flow of refrigerant, mass flow of water, and inlet temperature of water was also finished. and then the performance of miniature evaporator was estimated

    本文完成了液單相、兩相熱平衡實驗和阻力特性實驗,研究了製冷劑在管內流動的壓降;同時進行了微型蒸發器流動沸騰實驗,通過改變製冷劑質量流量、水的質量流量、水的進口溫度等,實現了對微型蒸發器的性能評價。
  10. For the first method, each house has a separate refrigerating unit, freon as the refrigerant evaporates in the cooler to cool the air. the unit is controlled with the set temperature

    氟利昂單機單控方式是指每個冷庫的製冷系統由一套或兩套獨立的氟利昂製冷機和冷風機組成,根據溫度控制其自動開停,由氟利昂直接在冷風機內蒸發來降溫。
  11. We make a theoretical analysis of the experimental results and draw some conclusions as follows : the saturated temperature r290 - oil mixture is higher than that of pure r290 at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixtures, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture. ( oil concentration is 0. 43 ? - 5. 28 ? )

    並根據實驗結果進行理論計算,得出以下結論:天然製冷劑r290含油混合物的飽和溫度高於相同壓力下純工質的飽和溫度,這個溫度差,也就是本文中提到的所謂製冷劑含油混合物的過熱溫度隨混合物質量含氣率、含油濃度的增加而增加,而飽和壓力對過熱溫度的影響不大(含油率0 . 43 ? - 5 . 28 ? ) 。
  12. The conclusions reached are as follows : 1. the saturated temperature of refrigerant - oil mixture is higher than that of pure refrigerant at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixture, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture

    得出以下結論: 1 、相同壓力下,製冷劑hc600a含油混合物的飽和溫度高於純工質的飽和溫度,這個溫度差,在就是文中稱為的製冷劑含油混合物的過熱溫度,它隨混合物質量含汽率、含油濃度的增加而增加,而飽和壓力對過熱溫度的影響不大。
  13. The conclusions reached are as follows : ( 1 ) the saturated temperature of refrigerant - oil mixture is higher than that of pure refrigerant at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixture, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture

    得出以下結論: ( 1 )製冷劑hc290含油混合物的飽和溫度高於相同壓力下純工質的飽和溫度,這個溫度差,也就是文中所謂的製冷劑含油混合物的過熱溫度隨混合物質量含汽率、含油濃度的增加而增加,而飽和壓力對過熱溫度的影響不大。
  14. ( 3 ) the saturated temperature of refrigerant - oil mixture has different definitions because of the superheat temperature of the mixture. one is the real saturated temperature of the mixture and the other is the saturated temperature of pure refrigerant corresponding to the tested pressure of the mixture. in this paper, the heat transfer coefficients based on the two different saturated temperatures are compared and the results showed the latter is larger

    ( 3 )由於製冷劑含油混合物過熱溫度的存在,使其具有兩種不同的飽和溫度定義,一種是所測實際溫度,另一種是所測壓力對應純工質的飽和溫度,文中就這兩種飽和溫度定義下的冷凝平均換熱系數進行了比較,發現後者大於前者。
  15. 3. in this paper, the heat transfer coefficients based on the two different saturated temperatures - one is the real saturated temperature of the mixture and the other is the saturated temperature of pure refrigerant corresponding to the tested pressure of the mixture - are compared and the results showed the latter is larger

    3 、文中就所測實際飽和溫度與所測壓力對應純工質的飽和溫度這兩種飽和溫度定義下的冷凝平均換熱系數進行了比較,發現後者大於前者。
  16. When refrigeration in this temperature range is realized by using single stage refrigerator with mixed refrigerant, not only the structure of the refrigerator is simplified, thus the operation reliability of the refrigerator is increased, but also the refrigerator can operate with a higher thermodynamic efficiency than that of conventional ones

    採用單級壓縮的混合工質製冷機進行該溫區的深度製冷,不但可以使製冷機的結構得到簡化,提高製冷機運行的可靠性,而且還可以獲得更高的熱力學效率。
  17. The aim of this study is to compare the thermodynamic characteristics of different j - t refrigerator cycles with mixed refrigerant in - 40 " c ~ - 120 " c temperature range and to find out the refrigerator type with high thermodynamic efficiency and high reliability, as well as the corresponding optimum composition of the refrigerant mixture

    本文的研究目的就是通過理論和實驗兩方面深入的分析和比較各類混合工質節流製冷機循環在- 40 - 120溫區的熱力學性能,探求其中的內在規律,找到該溫區內具有較高熱力學效率和高可靠性的製冷機型式以及相應的最優混合工質成分。
  18. The magnetic ground state of lafe _ ( 11. 4 ) al _ ( 1. 6 ) cx compound changes from antiferromagnetic to ferromagnetic for x > 0. 06 and the curie temperature increased monotonously with the increase of carbon content. a large magnetic entropy change was obtained near the phase transition temperature and the refrigerant capacity is good

    當碳含量高於0 . 06時,化合物的基態由反鐵磁變為鐵磁且居里溫度隨c含量的增加向高溫區移動,在各自相變溫度附近保持較大磁熵變,具有良好的磁製冷能力。
  19. Two kinds of room temperature refrigerant materials were studied in detail and their process, structure and the change of magnetic entropy were researched

    本文系統地研究了兩類室溫磁致冷材料? ? eufe系合金和gdsige系合金,重點研究了它們的制備工藝、組織結構和磁致冷性能。
  20. An experimental apparatus has been set up and experiments have been carried out successfully. it is the first time to use a kind of environment - friendly refrigerant, a rectifying column and an air - conditioning compressor in the ultra - low temperature refrigeration cycle. high boiling component, low boiling component and lubricant can be separated effectively

    本文自製了一臺自動復疊製冷循環樣機,採用環保型製冷工質、精餾裝置和單級油潤滑空調壓縮機,實現了混合工質高低沸點組元和潤滑油的高效分離,成功地把低溫箱內的溫度降到- 80 。
分享友人