resonant circuit 中文意思是什麼
resonant circuit
解釋
諧振電路, 共振電路-
The load character and control object for a parallel inverter is analyzed, the conclusion that series and parallel resonant circuit are two antithetic circuits is pointed out, this provides a theoretical guide to the control circuit design for these two inverters
分析了並聯諧振逆變器的負載特性及控制目標，指出串並聯諧振逆變電路是兩種對偶電路，為這兩種逆變器控制電路的設計提供了理論指導。 -
In the next place, by studying the change of the resonant frequency of the whole system, this paper designs the circuit to track the resonant frequency of the system by cd4046 mainly. at the same time, in order to improve the efficiency and get better dynamic capability of the converter, we choose pll and fuzzy control after comparing the pll circuit, fuzzy circuit and pll ? fuzzy control circuit. in the end, this paper brings forward the control blue print to realize the drive control circuit of the high frequency converter, using the dsp chip as the key part to realize four routes of pwm drive pulses with dead band of the control system
其次，通過對整個系統諧振頻率變化的分析和研究，設計了以鎖相環cd4046為核心的鎖相環控制電路，同時，在綜合比較鎖相環控制、模糊控制以及模糊控制和鎖相環復合控制三種控制演算法的基礎上，進行了系統模擬，得出採用復合控制可使跟蹤電路既具有鎖相環路較好的穩態性能，又擁有模糊控制較好的動態性能，系統魯棒性能好，同時也提高了逆變器的效率。 -
A monolithic integrated logic circuit of resonant tunneling diodes and a hemt
的單片集成邏輯電路 -
Firstly. operation principle of induction heating is introduced and the actuality of the power supply for induction heating is summarized. then, the scheme of structure of the power supply is established : uncontrolled rectifier and buck chopper constitute dc circuit. in this part, operation principle of a kind of soft switching buck chopper is presented mainly and the conclusion that the power semiconductor devices operate in soft switching is also illustrated by analysing the operation principle of all stages ; series resonant inverter is selected as inverter circuit via comparing the advantage and shortcoming of parallel resonant and series resonant. moreover. the work principle of series resonant inverter is analysed and the calculating method of the best dead time is put forward as well
文中首先介紹了感應加熱電源的工作原理並綜述了國內外的研究現狀。接下來分析並制定了電源主電路的構成方案：在對比幾種功率調節方式的基礎上選擇了不控整流加斬波調壓作為直流部分。在這部分里，重點研究了一種軟開關buck變換器，通過分析各階段的工作原理說明了開關器件如何工作在軟開關狀態；對于逆變器部分，在比較了串、並聯逆變器優缺點的基礎上選擇了串聯諧振逆變器，並詳細分析了串聯逆變器的工作原理，提出了最佳死區的計算方法。 -
This paper select the series - resonant inverter because it is more suited to high frequency power supply and it will be easy to enhance power capacity and enable the power supply to work on higher frequency if power is regulated in the rectifier. so uncontrolled rectifier and buck chopper constitute dc circuit is selected as rectifier circuit
並分析了感應加熱電源的各種調功方式，在對比幾種功率調節方式的基礎上，得出在整流側調功有利於高頻感應加熱電源頻率和功率的提高，選擇了不控整流加斬波器調壓作為研究對象。 -
Based on the study of transferring characteristics of the lcc - type resonant voltage, the parameter combinations, which make widths and magnitudes of voltage pulses of resonant network adjustable, arededucedo when the following requirements are met : fn > 3, k > 3 or cp / cs > 8, the above circuit is of natural voltage - stabilized characteristics, thus open - loop control method for bucking voltage is presented and the experimental results verify that the method is feasible.,
實測整機在額定負載時效率達到88以上。在研究lcc諧振網路電壓傳輸特性的基礎上，推導出滿足可變寬度和幅度的諧振網路輸出電壓脈沖列的參數組合。設計f n 3 、 k 3或c _ p / c _ s 8時，諧振網路具有自然穩壓特性，因此本文提出並實驗驗證了一種整機為降電壓時的開環控制策略。 -
1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %
從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。 -
The equivalent - circuit parameters and resonant frequencies of the piezoelectric quartz crystal resonance, the value of half peak width of the electroacoustic conductance spectrum ( fg1 / 2 ) as well as the electrical double - layer capacitance were obtained and analyzed
獲得並分析了pqc諧振等效電路參數、諧振頻率、電導譜半峰寬f _ （ g1 2 ）和雙電層電容，考察了電極界面發生的吸附動力學過程。 -
Using an lc circuit as a power supply filter can actually multiply the power supply noise at the filter " s resonant frequency. use inductor with low q to overcome this
使用lc電路作為電源濾波器能精確地在濾波器的諧振頻率點處乘以電源噪聲，使用低q電感來應對。 -
A lcc multi - resonant ( mr ) network is added to the traditional three - level converters to realize zvs. the unique arrangement of a multi - resonant network results in absorption of all major parasitic components hi the resonant circuit, such as transistor output capacitance, diode junction capacitance and transformer leakage inductance, which can eliminate parasitic oscillation in the converter
它的優點在於諧振電容吸收了開關管和續流二極體的結電容，諧振電感吸收了變壓器的漏感，使得開關管和續流二極體都能在軟開關的條件下完成導通和關斷過程，消除了電路中的寄生振蕩。 -
A common example is shown in figure 11. 34 where the resonant circuit formed by an inductive power line and its decoupling capacitor may be excited by pulse currents drawn by the ic
圖11 . 34所示的例子中，電源線的電感與去耦電容形成了諧振電路，晶元工作時產生的脈動電流，可能會激勵該電路（產生振蕩） 。 -
In order to describe the actual working processes of dielectric barrier discharge ( dbd ) circuit, an analysis model of differential - difference equations was presented, based on the working modes of full bridge serial load resonant dbd circuit, which was adopted with phase shifting control
摘要為描述介質阻擋放電型臭氧發生器電路的實際工作過程，在分析一種移相全橋脈寬調制下串聯負載諧振電源供電的臭氧發生器電路的基礎上，提出了採用微分差分方程來描述電路的工作過程，並給出了電路可能的工作軌跡。 -
By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source
通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。 -
The research of this paper is based upon miniaturization and digitalization of the peripheral control circuit. in this paper, associate with resonant cavity of mdrlg, mathematical models of control circuits are built, control characteristic, electromagnetic interference and electromagnetic compatibility are analyzed in detail, a part of the circuit is optimized
論文在激光陀螺控制電路小型化、數字化的基礎上，結合激光陀螺諧振腔體建立了控制電路的數學模型，對控制電路的控制特性、電磁干擾和電磁兼容性作了詳細的分析，對部分電路進行了優化設計。 -
Grounding on above theory, the zvs resonant of soft switch full - bridges circuit, and class - e amplifier, and push - pull class - e amplifier are analyzed respectively in theory. push - pull class - e amplifier is available by comparing results of simulation and low power experiment
基於以上理論，分別選擇了zvs諧振型全橋串聯逆變器、 e類放大器以及推挽式e類放大器進行詳細的理論分析，模擬比較以及小功率實驗對照。 -
Zvs soft switching resonant circuit is selected after analyzing and comparing zvs and zcs soft switching resonant circuit
分析比較zvs 、 zcs兩種諧振型軟開關的基礎上，選擇了zvs串聯諧振逆變器。 -
Application of rlc series resonant circuit in verification of spuare wave
串聯選頻電路驗證方波付里葉分解 -
Resonant circuit ' s modeling and simulation based on matlab
的諧振電路的建模與模擬 -
Based on the others " research, a sapphire resonator working at 12ghz was improved and fabricated. the coupling of resonant circuit and the match of the outside circuit are analyzed. and the automatic test system is also built
本文在前人的研究基礎上，改進製作了一個工作在17ghz附近的藍寶石介質諧振腔測試座，分析了諧振迴路的耦合及外電路的匹配問題，並構建了自動測試系統。 -
In chapter 3, according to the requirements of high voltage power supply used for charging capacitors with constant current, the series resonant converter ( src ) was chosen as the main circuit frame. the dynamic process of src was discussed by using mathematical analyses and numeric simulation to study the operational characteristics, the effects of parameters of resonant circuit on them and the relationship between switching frequency and out put power, which provided the bases of designing the power supply
第三章中根據高壓電容恆流充電電源的運行特點，選擇了串聯負載諧振變換器作為主電路結構形式，並對其動態過程進行了數學分析及數值模擬，討論了該電路的運行特點、諧振迴路參數對運行特性的影響以及開關工作頻率與功率輸出的關系，為電源的設計提供了依據。
分享友人