saturation force 中文意思是什麼

saturation force 解釋
飽和力
  • saturation : n. 1. 浸透，浸潤。2. 充滿；飽和。3. 【化學】飽和（狀態）。4. 飽和劑。5. 【物理學】磁性飽和。6. 【色】濃度，章度。7. 【商業】（市場的）飽和供應，足量供應。
  • force : n 1 力，勢。2 體力，氣力，精力，魄力。3 暴力，壓力；兵力，武力。4 〈pl 〉 部隊，軍隊，兵力。5 勢...
  1. They also have higher saturation magnetization, lower coercive force, exhibit superparamagnetization, and they are good sofy magnetic materials. fe - co alloy was spherical, coalescence of small particles

    含cu合金中除了fe - ni - cu 、 ni - cu合金的晶型完整外，其餘的合金都為非晶態。
  2. Vibrating samples magnetometer ( vsm ) testing implied that yig were of ferrimagnetism, and cerium substitution had effects on saturation magnetization ( ms ), residual magnetization ( mr ) and coercive force ( hc )

    Vsm測試結果表明yig屬于亞鐵磁性物質， ce離子的摻雜對飽和磁化強度（ ms ） 、剩餘磁化強度（ mr ） 、矯頑力（ hc ）都有一定的影響。
  3. The effects of the different kinds of rare earths and the doping amount of them on magnetic properties of bafe, 2o19 ultrafine powders ( including the specific saturation magnetization, the specific remanent magnetization and coercive force ) were firstly discussed systematically

    首次查明了鋇鐵氧體粉末的磁性能（包括比飽和磁化強度、比剩餘磁化強度和內稟矯頑力）隨稀土元素種類及其摻雜量的變化規律。
  4. In this paper, the influence of cycles of drying and wetting on strength and deformation are studied by means of routine direct shear apparatus, triaxial apparatus and light consolidation apparatus which include : the influence of force of constraint on strength, the total stress strength of expansive soils with different saturation degree, the influence of cycles of drying and wetting on the total stress strength, the relation between saturation degree and compression modulus and that between saturation degree and void ratio, the influence of cycles of drying and wetting on the effective stress strength, the relation between saturation degree and generalized suction

    本文利用常規直剪儀、三軸儀以及輕便固結儀，分別對非飽和膨脹土的強度和變形特性以及干濕循環對強度和變形的影響進行了一系列的試驗研究。以飽和度、干濕循環次數為變量，分別探求了外力約束對膨脹土強度的影響，不同飽和度膨脹土的總應力強度特性，干濕循環對非飽和膨脹土總應力強度的影響，飽和度與壓縮模量以及孔隙比的關系，干濕循環對飽和膨脹土有效應力強度指標的影響，廣義吸力與飽和度的關系，建議了一組計算非飽和膨脹土變形及強度特性的經驗公式。
  5. Three parts are included as follows : first of all, the basic circuit equation of radial pm generator for autos is given. the effect of reciprocity of pm and winding ' s magnetic force upon winding ' s inductance and current upon magnetic circuit saturation are analysed. according to these, we can obtain optimized design

    首先，從本課題採用的徑向式結構的三相永磁同步發電機的物理模型出發，得出其基本電路方程式，並分析了永磁磁動勢與繞組磁動勢間相對位置的不同而對繞組電感不同的影響，相電流對磁路飽和效應的影響，為車用永磁發電機的優化設計提供了理論依據。
  6. Considering the relations between idle load characteristics and armature winding parameters of the salient pole propulsive synchronous motor ( spsm ) with its structure, stator tooth and magnetic saturation, the analysis of numerical method for the back electromotive force calculation of spsm is given under various exciting current values

    摘要針對凸極式同步推進電機的空載特性及其繞組參數與電機結構、定轉子齒槽、磁場飽和等緊密相關的問題，分析了在不同勵磁電流下同步推進電機相反電勢的數值計算方法，提出了採用電機磁場能量微動法計算相繞組的參數，並對一臺十二相同步推進電機的繞組參數及其空載特性進行了計算和測量。
  7. Furthermore, the controllers were improved to obtain better performance considering actuator saturation and the coefficient of control force. and then, according to the superiority of lmi about dealing with multi - objects, the robust performance of h _ control and the restrainability of h _ 2 control, a mixed h _ 2 / h _ controller was designed for reducing the absolute acceleration of structure or the special floors

    同時，利用h _控制的魯棒性能和h _ 2控制的抑制性能，基於lmi多目標控制理論，設計出h _ 2 / h _混合控制器，改善整體結構或特定樓層的絕對加速度，為mrd的不確定系統設計魯棒的h _ 2 / h _混合控制器提供理論依據。
  8. The formation process of w - type ferrite underwent from oxide of metal, the m - type transition phase to final w - phase. when the heating rate was 5 / min, at 900 for 3 hrs and 1200 for 4 hrs, pure m - type and w - type ferrites were formed in air respectively. with heat treatment temperature increasing, crystal structure was more intact, the saturation magnetization increased and the coercive force decreased

    熱處理過程表明， m型鐵氧體直接由金屬氧化物反應形成，未經歷尖晶石中間相； w型鐵氧體形成由金屬氧化物到m相過渡相最終向w相的轉變；當升溫速率為5 min ，溫度在900 ，保溫3小時和1200保溫4小時，就分別形成單相m相和w相鐵氧體；隨著熱處理溫度的升高和保溫時間的延長，衍射峰變尖銳，結晶更完整，空心微球的飽和磁化強度增大，矯頑力減小。
  9. Especially y - ni - 22fe, which have been widely used in industry things such as magnetic record heads, transformers or magnetic shielding materials due to its high permeability, low coercive force and relatively high saturation magnetization

    特別是- ni - 20fe合金，因其較高的磁導率、飽和磁化強度、低的矯頑力而廣泛用於磁記錄頭、變壓器和磁屏蔽材料等。
  10. The low carbon steel, which has a high permeability, increases the magnetic field in the gap and the saturation current resulting in an increased damping force

    並且，提出採用內置彈簧蓄能器的方法，解決了由於蓄能器補償不足而造成的阻尼力滯后現象。
  11. In addition, the magnetic force of the different structure pma and saturation characteristic of magnetic material are analyzed in this paper, that provide valuable results for the design and optimization of pma

    此外，本文還對不同結構形式的永磁操動機構電磁吸力及機構中鐵磁材料的飽和特性進行了分析，其結果為永磁操動機構的設計和優化提供了理論上的參考和依據。
  12. And flux distributions and radial force of an induction type bearingless motor is analyzed employing the finite element method. relationships between the radial force and radial force winding currents are influenced by magnetic saturation. it was shown that the generated radial force reaches its maximum value due to magnetic saturation

    首次運用有限元方法對該電機進行了深入的研究，充分展現了無軸承異步電機特有的氣隙磁場分佈、驗證了穩定磁懸浮力產生的條件、指出了磁飽和對磁懸浮力的影響、利用有限元方法修正了磁懸浮力數學模型。
  13. Nanostructured fe - ni alloy have been particularly emphasized because of their high permeability, low coercive force and relatively high saturation magnetization. fe - ni alloy fiber were also used as wave - absorbing materials. fe - co, co - ni, fe - co - ni alloy were armphous soft magnetic materials

    其中fe - ni合金是纖維狀的非晶態的軟磁材料， fe - co合金為球形， co - ni合金也是球形，相互聯結成鏈狀。
分享友人
分享到 Line

分享到臉書