secondary error 中文意思是什麼
secondary error
解釋
次要誤差-
Do regional economic gaps result from fdi ? the forming of secondary statistical error
析二次統計誤差的形成 -
A small error in secondary alignment is usually not a problem
副鏡稍微有些偏離也問題不大。 -
The analysis on the error of the measurement of secondary wind temperature of rotary kiln
回轉窯二次風溫的測量誤差分析 -
Using computer - aided alignment method, the schwarzschild optics was assembled with wave - front error of 18nm in rms value which is a good match to the simulation wave - front error by introducing figure errors of primary and secondary mirrors using zemax optical software. positive resist of zep520 ( nippon zeon co. ltd ) was employed in exposure experiments
在集成后的euvl原理裝置上,採用zep520 ( nipponzeonco . ltd )正性抗蝕劑及掩模調焦方案,初步進行了透射掩模的曝光復制實驗,國內首次獲得了0 . 75 m線寬的euvl復制圖形,完成了euvl的原理性貫通。 -
Based on literature and introducing the error coefficient ( r2 ), the paper infers the formula ( 2. 63 - 2. 66 ), which is applied to calculate the lag strain of bonded materials ( elag ) under the secondary load
本文在有關文獻的基礎上,引入誤差調整系數_ 2 ,推導出鋼筋混凝土受彎構件二次受力下粘貼加固材料滯后應變_ ( tag )的計算公式( 2 . 63 ) ( 2 . 66 ) 。 -
The presented dissertation mainly discusses the non - linearity existing in monostation and multistation radar measurement. the first part of this dissertation integrated the non - linearity with the uncertainty of measurement system, and presents a secondary order filter for correcting measuring variance while the measurement equation is non - linear. by comparing the filter error of extended kalman filter with that of secondary order filter, we find the filter performance of these two filters are almost same
本文主要討論單站與多站雷達中的非線性測量問題,在1中,我們把測量系統的非線性與測量系統的不確定性聯系起來,針對只有測量方程是非線性的情況,給出了一種修正測量方差二階濾波器,並用這種二階濾波器分析了推廣kalman濾波器的濾波誤差,指出推廣kalman濾波器與二階濾波器相比,濾波性能幾乎相同。 -
An error identified by a test case early in the sequence could cause secondary errors and reduce the amount of real testing achieved when the tests are executed
序列中處於前列的測試用例所引發的缺陷會導致次要錯誤並減少很多測試用例被執行時真正的測試所達到的情況。 -
Secondary simulation error
二次模擬誤差 -
With the increase of the electric power system capacity as well as the short lines, high currents will possibly occur in the transmission line when a fault happens at the end of the line. the iron core of the current transformer ( ct ) will become saturated easily because of the large current, or when the secondary load of the ct does n ' t match the 10 % error curve
隨著電力系統容量增大以及短線的增加,在電力系統線路末端發生短路時,有可能出現很大的短路電流;在很大短路電流的作用下,或由於電流互感器二次側負載與10誤差曲線不匹配等原因,電流互感器鐵芯很容易飽和。
分享友人