simulation circuit 中文意思是什麼

simulation circuit 解釋
模似電路
  • simulation : n. 假裝；模擬；裝病，裝瘋；【生物學】擬態，擬色。
  • circuit : n 1 （某一范圍的）周邊一圈；巡迴，周遊；巡迴路線[區域]；迂路。2 巡迴審判（區）；巡迴律師會。3 【...
  1. Then, anticipative results are attained by design and simulation of hardware circuit

    在上述基礎上，通過對硬體電路的設計和模擬，得到了預期的輸出結果。
  2. Chaotic measured circuit of constant current and simulation analysis

    恆流式混沌測量電路及其模擬分析
  3. Simulation for metal - semiconductor - metal - photodetector msm - pd circuit based - on pspice

    的肖特基勢壘光電探測器的模擬
  4. Now with the development of computer control technique applied in it, computer control technique has had a profound influence on pneumatic system structure / control performance / control theory etc. this thesis deeply researches on the task - computer control smart high - speed pneumatic cushioning system. which mainly includes the design of mechanical structure / electronical circuit / pneumatic loop and the researches of system modeling / simulation / control strategy

    計算機控制技術和電-氣比例伺服控制技術的結合，更是對控制系統的性能、系統的結構以及控制理論等多方面都產生了極為深刻的影響。本文對計算機控制智能高速氣動緩沖系統進行了機械、電氣、氣路系統的設計以及系統建模方法、系統辨識研究和控制策略研究。
  5. The three - order modulator has a 2 - 1 cascaded structure and 1 - bit quantizer at the end of each stage, the modulator is implemented with fully differential switched - capacitor circuits. and then, the discussion will begin by exploring the design of various circuit blocks in the modulator in more detail, i. e., ota, switched - capacitor integrator, quantizer, two - phase non - overlapping clock signal, etc., at the same time, these circuits will be simulated in spectre and hspice. at last, the whole cascaded modulator will do behavioral level simulation by matlab soft and simulink toolbox

    本論文中，首先介紹模數轉換器的各種參數的意義，以及一階sigma - delta調制器和高階sigma - delta調制器的原理;給出解決高階單環sigma - delta調制器不穩定性的方案，引入級聯結構調制器，特別針對級聯結構調制器中的失配和開關電容積分器的非理想特性進行詳細的討論;本設計的sigma - delta調制器採用2 - 1級聯結構和一位量化器，調制器採用全差分開關電容電路實現;同時對整個調制器的各個模塊進行了電路設計，包括跨導放大器、開關電容積分器、量化器、兩相非交疊時鐘等，並利用hspice和spectre模擬工具對這些電路進行模擬測試;最後，利用matlab軟體和simulink工具對整個級聯調制器進行行為級模擬。
  6. Through the simulation of large - scale circuit simulation proved that use the crossover tearing technology could detailed network structure, simplify the diagnostic process, and the neural network can parallel deal with the diagnosis information, and the logic operation can judge the information of the multi - fault. the illustrative simulation shows that it can increase the diagnosis speed and decrease the workload before test

    通過對大規模模擬電路的模擬證明，使用交叉撕裂明細網路結構，簡化診斷過程，且運用神經網路組對信息進行并行處理，邏輯分析運算對多故障信息進行處理判斷，大大提高了故障診斷速度，減小了測前工作量。
  7. This paper researches and analyses the developments of web technology and magnetostrictive transducers from world wide region. the paper also analyes the characteristics curve of magnetostrictive transducers based on its equivalent circuit and researches the method how to make sure its syntony frequency and its electric simulation network parameters. at the same time, by using jsp technology, a magnetostrictive transducer electric simulation application is designed based on b / s three - tier system structure. the experiment data is fitted by curve fitting module. the equivalent input impedance of it with stimulate loop is separated based on the results of curve fitting and the syntony frequency and electric simulation network parameters of magnetostrictive transducers is determined by the input impedance. the method presented in this paper can determine the syntony frequency and electric simulation network parameters of magnetostrictive transducers with a better accuracy than the testing method of syntony & anti - synton y. further more, jsp, the advanced technology at current, has been used to realize a magnetostrictive transducer web electric simulation system. the system has good human computer interface and the function of resource sharing and information publishing. the research of this paper and its achievements have some practical merits in the researchful and applied fields of magnetostrictive transducer

    用java編程語言編寫的曲線擬合模塊，對輸入的實驗數據進行了最小二乘法的曲線擬合；根據曲線擬合結果可從帶激勵線圈的磁致伸縮換能器的輸入阻抗中分離出磁致伸縮換能器鐵芯在無激勵電流時由機械振動形成的等效輸入阻抗，並由此輸入阻抗確定磁致伸縮換能器的諧振頻率及電氣模擬網路參數。本課題提出的方法與傳統的諧振?反諧振法相比，能更準確地確定磁致伸縮換能器的諧振頻率及其電氣網路參數。同時，採用當前比較先進的web技術，實現了基於jsp的磁致伸縮換能器web電氣模擬系統，該系統具有良好的人機界面和資源共享、信息發布功能。
  8. And experiment was based on the simulation, the results show that charge circuit and uplifted circuit both was adopted the same circuit, which can realize energy bi - directional flow, also have low switch ullage and high dynamic response

    在此基礎上進行了實驗研究，模擬和實驗結果表明，該裝置升壓和降壓只採用同一個主電路，即可實現能量的雙向流動，且具有低開關損耗和較高的動態響應。
  9. However, since memory circuit is very large and dense and the growing of its size is amazing, it is unpractical to extract the logic parameter directly with simulation tools

    然而，由於存儲器單元密集和電路龐大的特點，並且存儲器的增大極為迅速，使得用模擬工具直接提取邏輯參數並不現實，存儲器的簡化迫在眉睫。
  10. The way used in this paper, which uses digital method to design the governor in the simulation system and draws the software on replacing the analogy circuit, can overcome these disappointments. in addition, a piece of lcd is used to make the operation visible and easy to adjust

    本文對該模擬系統中的調速器採用微機數字化設計方案，利用計算機軟體去取代模擬電路的功能，可以很好地克服以上缺點。此外，在設計中引入lcd顯示，操作直觀、便於監視和調整。
  11. The robustness and associated memory of ann make the method more advantageous than tradition method. the simulation results show us that the proposed method can perform correct diagnosis in the linear analog circuit with tolerances

    通過電路模擬表明，利用所提出的實現方法對具有容差的模擬電路進行了較為準確的診斷，達到預期的自的。
  12. In this thesis, one cycle controlled switching power amplifier is analyzed detailed in theory and researched in simulation and experiment. main work and conclusion are described below. first, the basic structure and operational principle of one cycle controlled half - bridge and bridge circuit are analyzed, and control equation are deduced

    主要工作和結論如下：首先，對單周控制的半橋和全橋開關功率放大器的基本結構和工作原理進行了分析，推導了具體的控制方程，建立了單周控制的全橋開關功率放大器的小信號模型。
  13. Circuit simulation demonstrated that the dynamic and static performances of buck converter controlling by sliding mode are better than that of pwm converter

    電路模擬表明，滑動模控制的buck變換器的許多動態性能和靜態性能都優于pwm控制的buck變換器。
  14. Theoretical analysis and simulation are presented. finally, the proposed buck - boost type circuit was implemented and tested

    對于buck - boost型電路做出電路板進行了實驗測試，測試結果也一併給出。
  15. The circuit is used in high resolution resistance measuring. the coupled chaotic circuit array composed of this circuit is researched by computer simulation and circuit experiment. results show that, it is feasible to improve the stability of orders of chaotic systems and reduce noise in measuring by coupling

    最後，對以這種單電源驅動的混沌電路為基本單元所構成的耦合混沌陣列在提高系統輸出的穩定性和抑制噪聲作用方面，進行了計算機模擬研究和實際的電路實驗研究，結果顯示通過耦合的方式，可以將信號檢測的精度提高近一個數量級。
  16. Computer simulation technology apply to analysis of power electronics circuit and system

    計算機模擬技術在電力電子電路與系統分析中的應用
  17. The clock recovery system is fabricated in tsmc 0. 25um cmos process. simulation in smartspice shows that the circuit as expected

    設計中採用tsmc0 . 25umcmos工藝，用smartspice進行設計模擬和優化。
  18. Secondly, the composition and function of expander board is introduced, the paper describes a detail developing process of selecting component, design interface circuit, protract pcb with protel and design pci interface logic and user ' s logic. with ahdl and max + plus. in addition this paper discusses how to debug pci board, and give the simulation waveform and the result of debug. on the base of all functions is ture, this paper introduce the config registers and memory of bu - 61580, realize the interrupt function and communication based on mil - std - 1553b

    首先分析了擴展板的組成、功能，對pci介面邏輯和擴展板的內部邏輯進行詳細設計，並根據其資源要求進行器件選擇，然後使用protel工具進行電路板的製作。另外，本文還介紹了擴展板的調試方法，給出了邏輯模擬波形和調試結果。在此基礎上，本文闡述了協議晶元的配置方法，實現了1553b通訊擴展板間的通訊及中斷功能，達到了開發技術指標。
  19. The thesis mainly studies the correlatively pivotal technique and theory during the design process of computer control system for short circuit experimentation, which is an important part of dynamic simulation laboratory

    本論文主要基於短路實驗控制系統，對系統設計開發過程中涉及的關鍵性技術和理論作詳細的研究和探討。
  20. By utilizing the knowledge of digital circuit and simulation circuit, the system designs the pretreatment dealing circuit of the myoelectrical signal, which has the feature of big input impedance well suppress of public module and high gains. then the signal is gathered with " zhentong " data gathering after dealing with, and the software of signal processing is explored before the myoelectric signal is analyzed. after picking up eigenvalue, it is proved that the result is unanimous basically with the data of the relevant materials ; the other is to control artificial hand by the eigenvalue of the myoelectric signa l and at last the system gets very good control results

    即利用數字電路和模擬電路等相關知識，設計了具有輸入阻抗大、共模抑制好、增益高等特點的肌電信號前置處理電路，利用「振通」數據採集儀對處理后的信號進行採集，並利用快速傅立葉變換的相關知識編寫了信號處理程序，對肌電信號進行了波形分析、幅值譜分析和功率譜分析，提取了信號特徵值，與相關資料的數據相比，基本一致；二是利用肌電信號的特徵值對肌電假手進行控制。
分享友人
分享到 Line

分享到臉書