speed actual value 中文意思是什麼
speed actual value
解釋
速度實際值-
The design testing piezoelectric material surface acoustic during the experiment process in the paper has several merits : convenience, efficiency, no loss, fastness. and they can be realized. the design applies material piezoelectric response and anti - piezoelectric response to stimulus and receive saw, and apply the method of testing resonator frequency to calculate saw tested speed, simultaneously contrast the actual test result about different material to typical value in the paper
在本論文的研究實驗過程中，給出了一種方便、有效、無損、快捷的檢測壓電材料表面聲速的設計與實現，該設計中運用材料的壓電效應和逆壓電效應激勵和接收saw ，並運用檢測諧振頻率的方法計算測量saw速度，同時給出了對不同材料的實際測試結果以及與資料典型值的對比。 -
According to the wind speed distribution function with exponential rule, the difference value is accurately calculated between the actual wind power produced through the rotor swept area and the wind power produced by taking wind speed at the rotor centre as the design wind speed, and the power increment is obtained
摘要根據指數律的風速分佈函數，對風輪掃掠面積上的實際風功率與以風輪中心風速為設計風速產生的風功率的差值做精確計算，得到了風功率的增量。 -
This model indicated that minimal headway is quadratic function of the following vehicle speed as the following vehicle speed reduces ; rear - end collision will happen, when actual headway is less than certain value
追尾模型表明：最小車頭距離是后車速度的二次函數，隨后車速度急劇縮小；當實際車頭距離小於該值時，則會發生追尾事件。 -
Aim at the shortage in actual application that the frp pipe flange joint with the steel pipe and steel parts, in consideration of the special advantage of the adhesive boned joint, put forward the method that the steel flange adhesive boned steel pipe or steel part after the steel flange instead the frp pipe flange, or the frp pipe adhesive boned direct with the steel and steel part, it can reduce the stress concentration problem that cause from the different of the descend speed and the hot bulge or freeze coefficient in the applied process. thus reduce the damage number and the maintenance costs of the piping, so this method can have the greatly actual application value
針對玻璃鋼管道與鋼管及鋼管件之間法蘭連接方式在實際應用中的不足之處，考慮到膠接連接的獨特優勢，提出如用鋼法蘭代替玻璃鋼法蘭與玻璃鋼管道膠接后，再與配套的鋼管及鋼管件進行連接，或玻璃鋼管道直接與鋼管（件）進行膠接連接，則可減少玻璃鋼管道在應用過程中與鋼管（件）連接后因沉降速度及凍脹系數均不同而產生的應力集中問題，減少管道的損壞次數及維護成本，有很大的實際應用價值。
分享友人