stage of amplification 中文意思是什麼
stage of amplification
解釋
放大級- stage : n 1 講臺；舞臺；戲院，劇場；〈the stage〉戲劇，戲劇藝術；戲劇文學；〈the stage〉戲劇業；劇壇。2 ...
- of : OF ＝Old French 古法語。
- amplification : n. 1. 擴大；擴充。2. 【電學】增幅，放大（率）。3. （聲明等的）補充材料。
-
At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency
在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。 -
The dynamic experiment was tried. the maximal output power, which can be achieved, is 420kw. although there is a distance to the goal of 500kw output power, it still is the maximal power amplification broadcast tube on final stage in our nation
該樣管上整機做動態試驗時，在整機電壓不變的情況下，輸出功率為420kw ，盡管與輸出功率500kw的研製目標尚有一定差距，但也是我國目前輸出功率最大的末級功率放大管。
分享友人