standard load 中文意思是什麼

standard load 解釋
標準負荷
  • standard : n 1 標準，水準，規格，模範。2 旗；軍旗，隊旗；【徽章】標幟，標記；旗標，象徵。3 【植物；植物學】...
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  1. For protective female worker healthy, law set the labor range that female worker prohibits be engaged in, unit of choose and employ persons must not arrange female worker to be engaged in the following these law prohibit the labor that female worker is engaged in : ( 1 ) course of study of mine well dirty ; ( 2 ) silvan industry cutting, put in arris and banish exercise ' s charge ; ( 3 ) " physical labor intensity classifications " the 4th class in the standard the exercise of physical labor intensity ; ( 4 ) the assembly of bldg. scaffold and remove operation, and the altitude wiring of electric power, telegraphic industry works ; ( 5 ) load continuously ( point to load the frequency is in 6 times hourly above ) load every time more than 20 kilograms, discontinuous load load every time more than 25 kilograms exercise

    為了保護女職工的身體健康，法律規定了女職工禁止從事的勞動范圍，用人單位不得安排女職工從事以下這些法律禁止女職工從事的勞動： （ 1 ）礦山井下作業； （ 2 ）森林業伐木、歸楞及流放作業； （ 3 ） 《體力勞動強度分級》標準中第四級體力勞動強度的作業； （ 4 ）建築業腳手架的組裝和拆除作業，以及電力、電信行業的高處架線作業； （ 5 ）連續負重（指每小時負重次數在6次以上）每次負重超過20公斤，間斷負重每次負重超過25公斤的作業。
  2. The labor range that female worker contraindication undertakes includes : ( 1 ) course of study of mine well dirty ; ( 2 ) silvan industry cutting, put in arris and banish exercise ' s charge ; ( 3 ) " physical labor intensity classifications " the 4th class in the standard the exercise of physical labor intensity ; ( 4 ) the assembly of bldg. scaffold and remove operation, and the altitude wiring of electric power, telegraphic industry works ; ( 5 ) load continuously ( point to load the frequency is in 6 times hourly above ) load every time more than 20 kilograms, discontinuous load load every time more than 25 kilograms exercise

    女職工禁忌從事的勞動范圍包括： （ 1 ）礦山井下作業； （ 2 ）森林業伐木、歸楞及流放作業； （ 3 ） 《體力勞動強度分級》標準中第四級體力勞動強度的作業； （ 4 ）建築業腳手架的組裝和拆除作業，以及電力、電信行業的高處架線作業； （ 5 ）連續負重（指每小時負重次數在六次以上）每次負重超過二十公斤，間斷負重每次負重超過二十五公斤的作業。
  3. Technical standard for measurements of bed load and bed material in open channels

    河流推移質泥沙及床沙.測驗規程
  4. Standard requirements for load tap changers

    負載開關轉換器的標準要求
  5. Standard test method for heat resistance of hot - applied sealants under dead load shear

    最大承載剪切下熱應用密封劑耐熱性的標準試驗方法
  6. Standard test method for maximum media density for dead load analysis of green roof systems

    新暴露頂層系統靜荷載分析用最大介質密度的標準試驗方法
  7. It calculate 60 driving speed kilometers / hour, it design 30 kilometers of speed of deck bridges road, ground of offices / hour, road calculate and load type standard cars standard bzz - 100s, iron do distance to city one for new urban north and southses by mountain path by road surface structure, calculation 40 driving speed kilometer / hour

    計算行車速度60公里/小時，跨線橋處地面道路設計車速30公里/小時，道路路面結構計算荷載標準bzz - 100型標準車，鐵山路為新城區南北向城市次幹路，計算行車速度40公里/小時。
  8. Ordinary bolt connecting bolts as a permanent use, when the design requirements or questions about its quality should be carried out when the smallest lag bolts kind complex load testing and the results were consistent with national standard 《 mechanical fasteners, bolts, screws and stud 》 ( gb3098 )

    普通螺栓作為永久性連接螺栓使用時，當設計有要求或對其質量有疑義時，應進行螺栓實物最小拉力載荷復驗，其結果符合國家標準《堅固件機械性能、螺栓、螺釘和螺柱》 （ gb3098 ）的規定。
  9. The paper is based on innumerable practical heavy - load road data, deliberate heavy - load standard in detail through theoretical arithmetic, and bring heavy - load standard about cement concrete pavement and asphalt concrete pavement separately ; in the meantime, through a large quantity of cement concrete pavement stress calculation, the paper puts forward relation expression between load on concrete board and stress level under board ; meanwhile, the paper puts forward traffic classification about cement concrete pavement and asphalt concrete pavement ; through bearing board testing on each structure sheaf the paper finds the material modulus gets modified ; through comparing position equivalent rebound modulus to theoretical equivalent rebound modulus, the paper points out limitation of nomograph in course of cement concrete pavement design, whereby, puts forward modifier formulas about theoretical equivalent modulus

    本文以大量的重載道路資料為主，從實際出發，結合理論計算，對重載標準進行了詳細的討論，分別給出了水泥混凝土路面與瀝青混凝土路面的重載標準了；同時，通過大量的水泥混凝土板底應力計算，推導出了混凝土面板荷載與板底應力水平的關系式；給出了水泥混凝土路面與瀝青混凝土路面的交通分級；通過對試驗路各結構層進行承載板測試，發現現有材料模量較以前有了明顯的提高；對比現場實測的當量回彈模量與理論當量回彈模量，指出現有水泥路面設計中的諾謨圖不能完全符合現有道路材料，從而提出了對理論模量的修正公式。
  10. According to experimental data and related standard, the finite element model of frame has been set based on its geometric model through simplified processing, selecting element, dividing mesh grids, load cases setting and putting characteristic etc. on the basis of this, the integrated finite element model of motorcycle has been established including frame, engine, suspension, wheel, rider and oil box etc. to understand the relationship and dynamic property of frame and integrated motorcycle, mode analysis and frequency response analysis have been done

    根據實驗測試數據和有關標準規范，以總體設計階段得出的車架幾何模型為基礎，通過模型簡化、單元類型確定、網格劃分、工況設置、邊界處理、物理特性賦予等，建立車架的有限元模型。並基於此，建立整車的有限元模型，包括車架、發動機、懸架、輪胎、乘員、油箱等。
  11. Standard test method for permittivity of geotextiles under load

    載荷條件下土工織物介電常數的標準試驗方法
  12. The " xinguan brand building material and industrial material has more than 300 series including 2000 specifications. their surface has been already dealt with three crafts : positive pole oxidize, electrophoresis scribble load with, powder spraying. the color incorporates the international popular color ; quality of the product reaches the international standard

    生產的「鑫冠」牌建築型材工業型材已擁有300多個系列，近2000餘種規格，表面處理已形成陽極氧化電泳塗裝粉末噴塗三大工藝，色彩融入國際流行色，產品質量達到國際標準，被評為江蘇省信用產品，省鄉鎮企業名牌產品，全面通過iso90012000質量體系認證。
  13. Standard test method for scuffing load capacity of gears

    齒輪膠合承載能力試驗方法
  14. Based on developed experimental testing facility, the shading performances of southing horizontal shading devices, vertical shading devices and integrative shading devices of external windows are measured, the performance parameters including indoor temperature, air - conditioned cooling load and shading coefficient as so on. and the shading coefficient of experimental test results and calculation results based on design standard for building energy efficiency are compared, and the windows5. 2 simulation results are compared also. the measured results are consistent with the calculation results of horizontal shading devices and vertical shading devices

    本文利用研製的建築遮陽性能檢測裝置，對南向水平遮陽板、垂直遮陽板和綜合遮陽板外窗的遮陽性能（包括室內溫度、空調耗冷量和遮陽系數等）進行了實驗測試，並對遮陽系數的實驗測試結果與節能設計標準的計算值以及windows5 . 2軟體的模擬結果進行了比較分析，測試結果表明水平遮陽板和垂直遮陽板外窗的遮陽系數與計算結果比較一致，相對誤差分別為2 . 5 %和4 % ，而綜合遮陽板外窗的遮陽系數與計算結果的差值比較大，相對誤差達到10 %以上。
  15. Wattmeters will be calibrated by direct comparison method against the laboratory standard wattmeter with phantom load

    功率表將透過直接比較法及用虛假負載，利用本所的標準功率表，加以校正。
  16. Uss lexington cv - 2 length overall : 270. 8m beam max : 39. 7m hull : 32. 2m displacement standard : 41187t full load : 43054t the lexington, was originally designated cc - 1, laid down as a battlecruiser 8 jan 1921 quincy, massachusetts. authorized to be completed as an aircraft carrier 1 july 1922, commissioned 14 december 1927. on 7 december 1941, lexington based at pearl harbor, when word of the japanese attack on pearl harbor was recevied, she immediately launched searchplane to hunt for the japanese fleet

    1927年12月14日開始進入美國海軍序列服役。 1941年12月7日，以珍珠港為基地的列剋星敦號收到母港遭到襲擊的消息，她立刻派遣偵察機搜索日本艦隊。 1942年5月7日，列剋星敦號的艦載機擊沉了日本輕型航母祥鳳號。
  17. Standard for manually - operated dead - front padmounted switchgear with load interrupting switches and separable connectors for alternating - current systems

    電流系統用的配有裝載中斷開關和可分連接器的手工操作正面不帶電面板上安裝的開關設備標準
  18. V standard test method for endurance life and load - carrying capacity of solid film lubricants falex pin and vee method

    固態薄膜潤滑劑的壽命持久性和荷載能力的標準試驗方法
  19. Verification regulation of waveguide standard load at x - band

    三厘米波導標準負載檢定規程
  20. Grade ii standard load calibrating machine

    二等標準測力機
分享友人
分享到 Line

分享到臉書