static elasticity 中文意思是什麼

static elasticity 解釋
靜彈性
  • static : adj 1 靜止的，靜態的，靜力的。2 【物理學】天電的，靜電的。3 【無線電】靜態特性。4 固定的，不活潑...
  • elasticity : n. 1. 彈力，彈性；伸縮力，伸縮性，靈活性。2. 開朗的性情。
  1. In this paper we discuss the three - dimensional quasi - static problems by using the magneto thermo elasticity theory, which is related to geotherm : the situations of the heat - carrying fluid intruding into the vertical or horizontal cracks, and the case of static local high temperature regions

    摘要以磁熱彈性理論為工具，討論與地熱有關的三維準靜態問題：載熱流體侵入豎直或水平裂隙的情況和存在靜態局部高溫區的情況。
  2. Static analysis was analogued by elasticity and ideally elastic - plasticity material, while kinetic analysis was carried out by the combination of modal analysis and kinetic reaction analysis hierarchical method

    靜力分析採用彈性和理想彈塑性材料進行模擬，動力分析採用模態分析並結合動力反應譜法進行。
  3. Ga applied in inverse problems of elasticity structure static load

    彈性結構靜荷載反問題的遺傳演算法
  4. Determination of static modulus of elasticity under compression of autoclaved aerated concrete or lightweight aggregate concrete with open structure

    敞形結構高壓蒸養加氣混凝土或輕集料混凝土受壓靜態彈性模數測定
  5. Point to above problems, under the financial support of the national natural science foundation ( exploration of high tech and new concept and new conceive ), the excellent young teachers program of ministry of education and national excellent doctoral dissertation special foundation, the static and dynamic real - time computation of elasticity - plastic mechanics, solving method of fuzzy finite element and other problems were studied in this paper. and some achievement was gained as following : ( 1 ) based on the positive definiteness of system stiffness matrix of finite element that was modified and the form of potential energy function of elastic body, the linear system of saturation mode ( lssm ) was introduced into the neural computation of finite element, by which the no - error solving of finite element neural net computation was realized in theory

    針對上述問題，在國家自然科學基金（高技術新概念新構思探索） 、教育部優秀青年教師資助計劃、高等學校全國100篇優秀博士學位論文作者專項基金等的資助下，本文對彈塑性力學問題的動靜態的實時計算、模糊有限元的求解方法等問題進行了系統和深入的研究，取得了以下成果： （ 1 ）根據有限元總剛矩陣經修正後具有正定性的特點以及彈性體勢能函數的具體形式，將飽和模式的線性系統（簡稱為lssm系統）引入到有限元的神經網路計算中，在理論上實現了有限元神經網路計算的無誤差求解。
  6. Practices show that the compressive strength, the modulus of elasticity, the permeability coefficient and the compactness of concrete obtained respectively by the compaction method, the unconfined compression static compaction method, the sand trenching and filling method, and nuclear densimeters meet the requirement of design, and the mixing proportion of concrete of the side - wall is reasonable

    實踐證明施工中用擊實法、無側限抗壓靜力壓實法、挖坑灌砂法及核子密度儀分別檢測出的邊墻混凝土抗壓強度、彈性模量、滲透系數和密實度值均滿足設計要求，邊墻混凝土配合比合理。
  7. Wood. static bending. determination of modulus of elasticity in static bending using small clear specimens

    木材.靜力抗彎強度.用無瑕疵小試件測定靜力抗彎強度試驗中的彈性模量
  8. On the basis of the traditional elasticity theory, nonlinear theory, ultimate theory and theory of reinforced concrete slabs with simple - supported condition, this paper analyzes the whole process of reinforced concrete thin slabs in the loading test of distributing static load, on the objects of reinforced concrete thin slabs with complex geometry, complex boundary condition and distributing of reinforce bars. and then analyzes the load capacity under the effecting of static load

    本文在傳統的鋼筋混凝土彈性理論、非線性理論和極限理論以及在簡單支承條件下的鋼筋混凝土板理論的基礎上，以復雜幾何形狀、邊界條件及配筋形式的鋼筋混凝土薄板為研究對象，對其在靜力分配梁加載下的加荷試驗的全過程進行分析，並對其在靜荷作用下的受力性能進行分析。
  9. Since the similarity between plane elasticity and plate bending is a special case of the static - geometric analogy, this paper, therefore, studies the new formulation based on the static - geometric analogy in a broad sense

    平面彈性和板彎曲的相似性是殼體靜力?幾何比擬的特例，所以在總的意義下本文就是研究基於板殼靜力?幾何比擬理論的新型板殼單元列式。
  10. In the first place, with the similarity theory, a bridge is set up between plane elasticity and plate bending to transform those good plane elasticity elements into plate bending elements ; then with the guiding theory of the static - geometric analogy, a new methodology of thin shell element is presented

    研究的目的和解決方案首先是利用相似性理論在平面彈性有限元與板彎曲有限元之間建立一道橋梁，則可以將平面彈性中性能良好的單元轉化為板彎曲單元。之後可以在此基礎上以殼體的靜力?幾何比擬為指導理論構造新型薄殼單元。
  11. Test for static modulus of elasticity in compression

    靜力受壓彈性模量試驗
  12. Method of test for static modulus of elasticity of concrete

    混凝土的靜態彈性模量測試方法
  13. Determination of static modulus of elasticity under compression of autoclaved aerated concrete or lightweight aggregate concrete with open structure ; german version en 1352 : 1996

    高壓蒸氣加氣混凝土和堆放多孔輕質混凝土受壓靜態彈
  14. Standard test method for static modulus of elasticity and poisson ' s ratio of concrete in compression

    混凝土在壓縮中靜態彈性模量及泊松比的標準測試方法
分享友人
分享到 Line

分享到臉書