stiffened skin 中文意思是什麼
stiffened skin
解釋
加肋殼板-
The entire vehicle is covered with a stiffened skin.
整個飛行器包上了鋼性蒙皮。 -
According to the special shape and operate requirements of the torpedo, the structure and moulding process of the torpedo shell are established, in which the body and overlay block with grooves are moulded by fiber winding, and close moulding respectively with the adhesive by limited stop compression. in the light of the selection of raw material system, composite system with outstanding performance are defined, based on which the mechanical properties are tested., with the overall consideration of structural characters and design demands, the main factors which may have effects on the strength and stability ( including stiffness section dimension, stiffeners space, skin thickness and skin lay angle ) is optimized one by one for the structure design parameters on the base of the fem model of skin, stiffness and layover block by fem. as a result, the prototype with 1 : 1 proportion and its structure and lay optimization design are completed. the moulding technology for polyurethane foam moulding the stiffened shell is obtai ned in terms of the design, manufacture moulding, experimental mould and tooling
依據在研產品特殊的外型結構和使用要求，確定了該型號水雷復合材料殼體的具體結構形式和復合成型工藝路線，即由纖維纏繞工藝成型主體異形件，閉模成型帶通槽外貼塊，用限位加壓工裝實現粘接的工藝路線；通過對原材料體系的篩選，確定了綜合性能較好的復合材料體系，以此為基礎進行了力學性能測試；運用有限元方法，建立了蒙皮、筋條和外貼塊的分析模型，綜合考慮結構特點和設計要求，對影響結構強度與穩定性的主要因素（包括筋截面尺寸、筋間距、蒙皮厚度、蒙皮鋪層角度）分別進行了結構設計參數的優選，最終完成了復合材料異形耐外壓殼體1 : 1樣件和縮比實驗件結構及鋪層優化設計；完成了聚氨酯泡沫胎成型內置加筋殼體的成型工藝技術研究；對縮比件進行外壓性能測試，並給出了應力、應變測試結果。 -
Firstly, itis explained that the application research of smart layer. to laod detecting and simulative damage for the model of wing - box, fbg fiber smart layer and pzt smart layer are designed, and manufactured. so, those are surface - mounted respectively on the stiffened skin of aluminum alloy and carbon fiber reinforced. data acquisition system based on different signal processing technique are designed
針對機翼盒段試件結構載荷識別和模擬損傷監測的功能要求，結合智能夾層的設計製作工藝，設計製作了基於fbg傳感器的光纖和壓電兩種智能夾層，並分別安裝在機翼盒段試件上的鋁合金和碳纖維制蒙皮上。
分享友人