test vessel 中文意思是什麼

test vessel 解釋
試件容器
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  • vessel : n. 1. 容器，器皿〈桶、缽、碗等〉。2. 船，艦；飛船。3. 〈喻、謔〉人。4. 【解剖學；動物學】管，脈管，血管；【植物；植物學】導管。
  1. Test should be proceed under good meteorologic conditions and sea condition, keep the cruise 、 ship speed and main engine revolution of the vessel stable before trial, rudder angle should keep at center position

    試驗應在良好的氣象條件和海況下進行，試驗前，應保持航行、航速以及主機轉速的穩定，試驗期間，舵角應保持在正中位置。
  2. Ion objective : to investigate effect of nd : yag laser irradiating root canals on periapical tissue. methods : three minipigs were used in this study, deciduous premolars were opened, pulps were extracted, root canals were enlarged, then irradiated with nd : yag laser 30s and filled conventionally. the changes of periapical tissue were observed after 1, 3, 7 and 15 days. results : after one day, periapical tissue showed enlargement and engorgement of blood vessel and a few of leukocyte, the changes were more serious than in control. after 3 and 7 days, there were minor reactions in periapical tissue and same as the control group. after 15 days, periapical membrance in most specimens was normal. slight inflammatory reaction was found in the test group as same as in control group. conclusion : there was little damage to periapical tissue with the laser irradiation

    目的:觀察激光在根管內照射后對根尖周組織的作用.方法:選3隻小型豬，全麻下將乳前磨牙開髓、抽髓，根管擴大后，激光照射30秒，做常規根管充填.對照組為常規根管充填. 1天、 3天、 7天和15天後觀察根尖周組織的變化.結果:激光照射后1天，根周膜血管充血、輕度炎癥，對照組只有根尖周膜充血.激光組組織反應比對照組稍重.激光照射后3天和7天，少數病例根周組織有輕度的刺激與對照組的病理表現相近.激光照射后15天部分標本根周膜正常，部分標本有輕度炎癥反應，與對照組結果基本相似.結論:本激光照射條件對根尖周組織沒有明顯損傷作用，可供臨床應用時參考
  3. The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi

    得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 「角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器製造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86
  4. Stress measurement and analysis for a spherical vessel under hydrostatic test

    球形爆炸容器水壓試驗應力測試及分析
  5. Test requirements of frp fishing vessel

    玻璃鋼漁船建造檢驗要求
  6. Test method of hull tightness for fiberglass reinforced plastic fishing vessel

    玻璃鋼漁船船體密性試驗方法
  7. Test method for overall longitudinal bending of glass fiber reinforced plastics fishing vessel

    玻璃鋼漁船總縱彎曲試驗方法
  8. Corrosion test for hull steel of zhongshan vessel

    中山艦船體鋼耐蝕性能檢測與分析
  9. According to some model test results of fishing vessels in the developed fishery countries, through analyzing the capsizing mechanism of fishing vessels, author gives some measurs for improving the stability of fishing vessel in rough sea, which include how to design and arrange the bulkwark port and ensure the reliability of water - tight facilities and use catamaran

    為此，作者根據海洋漁業發達國家進行的一些漁船穩性的船模試驗研究結果，經過對漁船傾覆機理的分析，提出改善漁船風浪中穩性的一些措施，包括如何合理設計與布置舷墻排水口，確保船體開口水密設施的可靠性以及採用雙體漁船等。
  10. 05. 01 standard test method for oxidation stability of steam turbine oils by rotating pressure vessel

    用旋轉式儲氣瓶測定蒸氣渦輪機油氧化穩定性的標準試驗方法
  11. These results do not conform to those of the "silvered vessel test".

    上述試驗結果與「銀瓶試驗」的結果相異。
  12. If appropriate helium leak test plan is selected, it will be of benefit to improving detectability and effectively secure titanium vessel safety and reliability

    選擇合理的氦?漏試驗方案，可做到既能檢漏又能及時發現漏點，有效地保證鈦制容器安全性和可靠性。
  13. Standard test method for dust explosions in a 1. 2 - litre closed cylindrical vessel

    1 . 2公升的密封圓筒形容器中粉塵爆炸產生壓力以及壓力升高的速率的標準測試方法
  14. Micromechanics analysis and test on the ductile fracture of pressure vessel materials

    壓力容器材料韌性斷裂細觀力學分析與測試
  15. Which located at the foot of wutai mountain, china famous buddhism holy land. with rich source of coal, electricity, and iron, dingxiang is the famous forging county in china, being in superior geography location and good highway and railroad transportation, it is a specialized factory for producing forging steel flanges and forging parts of pressure vessel. it has been listed one of the first class supplier by china petoleum group and china petrochemistry group. having the capacity of buying raw material, forging, heat treatment, maching, quality test, mechanical stamp, surface galvanized, packing, shipping, it can produce 4000 metric tons of flanges and forgings in accordance with the standard of ansi, bs, din, gb, jis etc. the diameter of forging is form 15mm to 3000mm

    山西眾立法蘭有限公司位於佛教聖地五臺山腳下「中國鍛造之鄉」定襄縣，是生產鍛鋼法蘭和壓力容器鍛件的專業廠家，是中石油中石化一級供應網路成員。主要產品有單重小於2500kg公稱直徑dn15 - dn3000mm之間的美標英標德標國標等各國標準和非標法蘭盤及鍛件，年生產能力4000餘噸。
  16. Technique condition current of fix test center high liquid press system of fishing vessel

    漁船中高壓液壓系統安裝調試通用技術條件
  17. Massachusetts - based advanced cell technology said it had devised a straightforward way to make blood vessel precursor cells out of the stem cells and plans to test them in humans

    立足於麻薩諸塞州的高級細胞技術院說他們發明了一條直接的方法將血管前體細胞直接從幹細胞中分離並且計劃在人身上測試它們。
  18. A research team from the university of hawaii discovered the i - 401 submarine thursday during test dives off oahu. " we thought it was rocks at first, it was so huge, " said terry kerby, pilot of the research craft that found the vessel

    據cnn3月21日報道，美國夏威夷大學一個水下研究小組17日在夏威夷群島的瓦胡島海域進行試潛水時，發現了這艘「 i - 401 」號潛艇。
  19. The characteristics and requitements of the seal of vessel stem tube shaft is introduced and structural form and actual effect of packing seal of vessel stem tube shaft is analyzed, based on comparison, test and screening of seal packing materials, two braiding forms of synthetic fiber compounded packing arc adopted and are tested in real vessels, and good sealing effect is obtained

    摘要介紹了艦船艉軸密封的特點和要求，分析了艦船艉軸填料密封的結構形式和實效，在比較、試驗和篩選密封填料材料的基礎上，採用了兩種編織形式的合成纖維復合填料，並通過實船試驗，取得了良好的密封效果。
  20. Test methods for strength and tightness of marine auxiliary boiler and pressure vessel

    船用輔鍋爐及受壓容器強度和密性試驗方法
分享友人
分享到 Line

分享到臉書