thickness pattern 中文意思是什麼
thickness pattern
解釋
厚度型-
The thickness had some influence on the development of the banded spherulites : when the thickness reduced to some degree, pcl would develop chrysanthemum - like spherulites, which had no extinction rings or the maltese cross pattern under the crossed polarized optical microscopy. the results of the phase - contrast microscopy showed that growth speed of the chrysanthemum - like spherulites along the radius was not constant
發現薄膜厚度對球晶的生長有一定的影響，當共混物膜薄到一定程度時， pcl不能形成環帶球晶，而是形成一種類似菊花狀的晶體，在偏光顯微鏡下看不到環帶，也沒有典型球晶所特有的maltese十字消光圖案。 -
The factors which affect the spl : the square measure of diaphragm, the amplitude of vibration, magnetic field intensity, power, impedance, resonant chamber, the pattern and the thickness of diaphragm, and the holes
音量會影響聲音大小的因素:膜片面積，振幅，磁場強度，功率，阻抗，音腔大小，膜片花紋/厚度，開孔 -
When the thickness increases up to a critical value, about 30 nm, the spotty rheed pattern gradually changes to streaky pattern, and the rheed oscillation curve appears. the rheed pattern of the ultra thin lno film deposited in the relatively high oxygen pressure is streaky pattern. with pumping the oxygen pressure to the relatively low value, the streaky rheed pattern gradually changes to spotty one
我們發現在較低的真空度下，即氧分壓處於2 10 - 4pa和3 10 - 3pa之間， lno晶格中的一個o2 -將會轉移兩個電子給兩個ni3 + ，並且移動到薄膜表面形成o2被泵抽走，從而導致鈣鈦礦結構的垮塌，其相應的rheed圖樣呈現出清晰而明亮的點，表明表面為較為粗糙的三維島狀結構。 -
When increasing the oxygen pressure, the rheed pattern changes to streaky one again. this rheed pattern transformation induced by the oxygen pressure is reversible. ex situ xps results indicate that the element ni of lno film deposited in the relatively low oxygen pressure with thickness below the critical value exists in the form as ni2 +, while as ni3 + in the relatively high oxygen pressure
隨著膜厚增加而超過約30nm的臨界厚度時，越來越多的晶格氧會移動到了薄膜表面，此時所提供的氧將使得后續生長的lno膜層重新形成鈣鈦礦結構，並以層狀方式外延生長。 -
The experimental results show that if such technology parameters as the baking speed, wall thickness, and sl pattern thickness are suitable, or the size of sl pattern in one direction gets very small, shell can be prevented from cracking during baking process
研究結果表明：採用樹脂制備方法，不僅可以簡化傳統製作蠟模的工藝步驟，而且大大縮短了製作周期；樹脂模型精度、粗糙度對復雜鑄件的傳遞特性，己成為該方法被廣泛應用的一個重要的前提條件。 -
Dual usage : plotting pattern and marker less than 1. 6m and cutting pattern papers in 0. 06 - 0. 13mm thickness
一機兩用，即可以繪制樣板及幅寬1 . 6米以下的排料圖，也可以切割厚度為0 . 06至0 . 13mm的紙樣 -
It was found that an uniform and compact tio2 nanoparticulate film can be deposited on pet substrates in a short time, and it ' s thickness increases with the treating time. when the thickness comes to a critical value, there grows a greater size cluster on the nano - sized film. this is an interesting film growing pattern, which has never been reported
與以往報道的生長模式不同，發現在很短的時間內即可在基底上濺射生成緻密均勻的納米膜層，其膜厚隨著時間的延長而增加，且當達到一定厚度時，又在原有納米膜層上生長出更大尺寸的團蔟結構。 -
The theoretical study of the recovery percent vs. water cut of thin and bottom water reservoir in luliang oilfield is based on developing its geologic and flow models, obtaining oil - thickness ratio, oil - water viscosity ratio, relative permeability curve parameter and chart of effect of bottom water toning, etc., on water - yielding pattern of the reservoir
摘要在建立了陸梁薄層底水藏地質及滲流模型基礎上，採用理論研究的方法，研究了薄層底水油藏采出程度與含水率關系式，並獲得了油厚比、油水粘度比、相滲曲線特徵參數以及底水錐進等對油藏產水規律的影響關系圖版。 -
( 3 ) using the csim4, the arctic sea ice equilibrium state was simulated reasonably. the simulated ice thickness distribution pattern very like that detected by submarine investigations. the simulated ice concentration and motion are similar to the observation
模擬的海冰厚度分佈與潛艇探測的海冰厚度分佈具有一致性；模擬的海冰密集度、海冰流速與觀測相近，模擬的海冰氣候態是合理的。 -
On the basis of areal geological background, the distribution pattern of sedimentary microfacies in the chang - 6 oil - bearing beds was distinguished and the palaeogeographic environment was reconstructed by the analysis of geology facies, logging facies, stratum thickness, sandstone thickness and sandstone percent and other sedimentary characteristic. the method of digital sedimentary microfacies was applied in part of the research area for the first time, and acquired the satisfying effect. the digital sedimentary microfacies realized the description of the sedimentary evolution from chang - 62 to chang - 61
在區域沉積背景的墓礎上，結合地質相特徵與測井相分析，對地層厚度、砂體厚度以及砂地比（砂巖含量）等在平面上的分佈規律進行了綜合分析，並結合沉積序列與沉積特徵等，判別了沉積微相在平面上的分佈格局，恢復出長6油層組各沉積期的古地理環境。 -
For dual energy gamma ray coal ash gauge, the error induced by inten sity averaging is consisted of two parts, the error caused by thickness change and by ash content change the magnitudes of the two errors are compared using app roximate analytical expressions under a simplified change pattern
定向斷裂爆破技術是利用聚能管改變巷道周邊眼裝藥結構，爆破時，利用聚能作用控制裂隙的方向和數量，以獲得較好的爆破效果的技術；它與傳統的光面爆破技術有較大的差別。 -
Based on the analysis of distribution of upper jurassic and lower cretaceous strata and basin - controlled faults, tanlu fault zone strike slip to develop the three nw - trending grabens from north to south western to tanlu fault zone in late jurassic and early cretaceous, which are bohai graben, jiyang graben and luxinan graben. based on the analysis of regional geology, the basic tectonic pattern of bohai basin is the cenozoic basin pattern since early paleogene. the outline, structure, deposit characteristics and heat flow distributions show that the basin is pull - apart basin in cenozoic time. the tectonic evolution pattern can be reconstructed based on the analysis of cenozoic strata, deposit thickness, location and activity of basin - controlled faults in the different depresses in bohai basin. the characteristics of structure and depositment in this mesozoic and cenozoic time show that bohai basin is a mesozoic and cenozoic composite basin
根據中生界上侏羅統和下白堊統地層和控盆斷裂分佈分析，中生代晚期晚侏羅早白堊世郯廬斷裂帶的左旋走滑平移導致郯廬斷裂帶以西自北向南發育了3個北西向斷塹系，即北部的渤海斷塹系中部的濟陽斷塹系和南部的魯西南斷塹系。從區域資料綜合分析，渤海灣盆地的基本格局是早第三紀以來的新生代盆地格局。渤海灣盆地的形態構造和沉積特徵及熱流值分佈表明該盆地在新生代為拉分盆地。 -
Railway tunnel and highway tunnel extensively adopt pattern is load - structure pattern, from it we know that the concrete thickness is a important effect to structure security. thus the mathematic statistics rule of concrete structure thickness is importance part of application reliability theory design
鐵路隧道和公路隧道廣泛採用的結構計算模式仍是荷載-結構模式，從中可以看到混凝土結構的厚度對結構的安全影響是非常大的，因而厚度的數理統計規律分析也是運用可靠度理論進行設計的重要組成部分。 -
Take certain typed three compartment sedan as an example, on the basis of simulation calculation of torsional rigidity and by applying the finite element theory and through sensitivity analysis of torsional rigidity via board thickness of part this paper gained the key frame structure that affects the torsional rigidity of white body and under the guidance of this frame structure the measures of further enhancing its torsional rigidity was laid down for the being studied sedan pattern
以某型三廂轎車為例，在扭轉剛度模擬計算的基礎上，應用有限元理論，通過零件板厚對扭轉剛度的靈敏度分析，得到了影響白車身扭轉剛度的關鍵框架結構，並在此框架結構的指導下，對所研究車型制定了進一步提高其扭轉剛度的措施。 -
Abstract : according to the reservoir characteristic of calcium containing and thin interbed of putaohua and fuyang reservoirs in the low permeable oil fields in the peripheral daqing, this paper uses activated function, pattern recognition and resolution matching processing to realize the automatic dividing of reservoir thickness in low permeable oil fields so as to provide a reliable method for the evaluation and development of the reservoir parameters in the peripheral oil fields in daqing
文摘:針對大慶外圍低滲透油氣田葡萄花、扶、楊油層含鈣、薄互層的儲層特點，採用活性函數、模式識別和解析度匹配處理技術，實現了低滲透油氣田儲層厚度的自動劃分，為大慶外圍油氣田的儲層參數的評價與開發提供了快速、直觀、可靠的手段。
分享友人