throttle-flow 中文意思是什麼

throttle-flow 解釋
汽機入口流量
  • throttle : n 1 〈方言〉喉嚨，氣管。2 【機械工程】風門，節氣閥，節流閥〈又叫 throttle valve〉；風門桿，節流桿...
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  1. According to a series of experimental data, the effect of following factors on the temperature in the ultra - low temperature box and cop are analyzed : the mixture composition, the pressure ratio and the return fluid extraction ratio of the rectifying column, the refrigeration capacity and the flow rate through throttle valve

    並根據一系列實驗結果，分析了工質配比、循環壓比及精餾柱迴流液的抽取率、加熱量和節流元件對低溫箱內溫度和系統cop的影響，為今後的進一步研究指明了方向。
  2. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀，在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲線的影響，並在此基礎上採用無節流方法測量流量，以風機調節性能曲線為依據，建立了基於徑向基函數（ rbf ）神經網路的風機流量全程監測模型；以實驗室4 - 73no . 8d離心風機為研究對象，探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的應用精度和誤差分佈規律；最後用visualc + +語言開發了風機性能在線監測系統。
  3. It has a long history using a throttle device to measure the flow volume of fluid in pipe the method has formed normalization at home and abroad the principle is to make the flow bunch form the particial shrink at the place where the throttle part is located so as to produce a static pressure difference then measure and calculate the flow volume at the moment when the fluid is flowing through the throttle device by the static pressure measured this method is based on the law of conservation of energy and the equation of flow continuity

    用節流裝置測量管道中流體流量已歷史悠久，在國內、國際上都已標準化，其原理是使流束在節流件處形成局部收縮，產生靜壓力差，通過測量靜壓力差來衡量流體流過節流裝置時的流量大小，這種測量方法是以能量守恆定律和流動連續性方程為基礎的。
  4. Numerical simulation of a boiler primary - air flow through a throttle orifice - plate

    鍋爐一次風通過節流孔板時的數值模擬
  5. According to theoretical analysis and experiments on the throttle control system, the quantitative relationship among the speed of executive element, the flow area of the throttle and the load is determined

    本文通過對進油路節流調速系統的理論分析與試驗研究，闡明了執行元件的運行速度與節流閥的通流面積以及負載之間的定量關系。
  6. Abstract : according to theoretical analysis and experiments on the throttle control system, the quantitative relationship among the speed of executive element, the flow area of the throttle and the load is determined

    文摘:本文通過對進油路節流調速系統的理論分析與試驗研究，闡明了執行元件的運行速度與節流閥的通流面積以及負載之間的定量關系。
  7. In order to improve measurement precision and display fidelity of the instrument, three new methods of nonlinear calibration of thermal instruments, which are based on intelligent control theory, are presented in this paper, such as nonlinear compensation of zr02 oxygen measurement instrument using bp nn, nonlinear calibration of temperature measurement sensors using cmac nn and nonlinear identification of throttle flow meter using ga. these methods prove to be not only simple but also effective

    火電廠熱工儀表普遍存在非線性特性，為了提高參數測量的準確度和儀表顯示的精確度，基於智能控制理論，文中提出了熱工儀表非線性校正的新方法： bp神經網路補償氧化鋯氧量計非線性特性的方法、 cmac神經網路校正測溫傳感器非線性特性的方法、遺傳演算法辯識節流式流量儀表非線性特性的方法。
  8. Instead the pump impeller should be trimmed or valves located else where in the system to partially throttle the flow

    代替泵葉輪應該經過修整，或者閥門應該位於系統部分節流的地方。
  9. The simulation shows that the valve throttle area should be little as possible but must be more than 40 % of pipe section area ; when the total length of pipe is same, and the flow quantity is enough, pipe before primary valve should be thin and long, and the pipe after primary valve should be thick and short, the upriver and downriver small pressure fluctuation will badly lead to waterdrammer pressure rising, and spending more time in establishing pressure and flow quantity

    模擬表明，閥門過流面積在滿足大於管道截面積40 %的條件下應盡可能小;在管道總長一定並滿足流量要求的條件下，主閥前應採取長而細的管道，閥后則應採用短而粗的管道;上下游微小的壓力波動都會嚴重增大開關閥門引起的水擊，並使壓力、流量的建立需要更長的時間。
  10. Accorded to the experimental research, under different flow area of flow valve and different adjusted pressure of relief valve, conclusion that the regulation of the pressure p1, p2 in the two cylinder chambers varied with the change of step load were as follows : when the throttle valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod decreased, meanwhile, it ' s time of rise, time to peak and the governing time all decreased. while the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    通過試驗研究得出系統在不同的流量閥開度、不同溢流閥調節壓力（進口壓力）下，液壓缸兩腔壓力p _ 1 、 p _ 2隨階躍負載變化的規律：當出口節流調速系統的回油路上串接節流閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是減小的，上升時間、峰值時間以及調整時間也是減小的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
分享友人
分享到 Line

分享到臉書