torque transmission system 中文意思是什麼

torque transmission system 解釋
扭矩傳輸系統
  • torque : n. 1. （古代條頓人、高盧人戴的）金絲項圈。2. 【物理學】扭（力）矩，轉（力）矩。
  • transmission : n 遞送；傳遞；傳達；傳染；移轉；【機械工程】傳動；傳遞；變速器；聯動機件；【無線電】傳送；發射；...
  • system : n 1 體系，系統；分類法；組織；設備，裝置。2 方式；方法；作業方法。3 制度；主義。4 次序，規律。5 ...
  1. The problem of torque increase and drill fracture during the process of deep well drilling was analyzed, and a safety protection and control technique was introduced, where a torque sensor was fixed between drilling bar and motor axis, while an electromagnetic clutch was fixed in the transmission chain of feed system

    摘要對深孔鉆削過程中出現扭矩增大及折斷鉆頭鉆桿問題進行了分析，介紹了一種鉆桿主軸與電機軸的連接中安裝扭矩傳感器，進給系統的傳動鏈中安裝電磁離合器的深孔鉆削安全保護與控制技術。
  2. Presents the system established by taking variable - speed torque converter with adjustable guide blades as a pilot control unit and forming an open or closed loop feedback control system, and its outstanding advantages, such as high capacity, simplicity, reliability and good transmission efficiency owned by hydrodynamic drive, and the dynamic model developed for variable - speed torque converter with adjustable guide blades by means of theoretical analysis and regression analysis of experimental data, and concluds that the model is sophisticated and simple enough to be used as a tool for design, analysis and computer simulation of a hydrodynamic control system

    以導葉可調式液力變矩器作為控制單元組成的開環或閉環液力控制系統，具有液力傳動裝置能容大、系統簡單可靠、傳動效率較高等顯著的優點.通過理論分析和試驗數據的回歸分析方法建立了導葉可調式液力變矩器的數學模型，模型既簡單，又有足夠的工程應用精度，為液力控制系統的設計、動態分析和性能預測提供了必要的理論基礎
  3. By analyzing the engine driving torque characteristics and the transmission inertia torque while speed ratio is changed under transient condition, a new synthetic control algorithm is developed which can approach engine target torque by compensating engine output torque with transmission system inertia torque

    通過研究無級變速傳動速比變化時的慣性矩，提出了一種新的控制演算法，採用傳動系的慣性矩來補償發動機的輸出轉矩，以獲取目標驅動轉矩。
  4. By using for reference, in theory, simply introduced the basic working principle of the secondary adjusting hydrostatic transmission system, the basic controlling rules of secondary regulation, and the most radical controlling rules such as rotational speed, torque control and power control etc. by analyzing theory and studying, check - uping the motion parts of secondary element and constructing the control system ; and setting up the topmost rotational speed control system ; designing and completing the software of date processing and system control

    通過參考相關的資料，從理論上介紹了二次調節靜液傳動系統原理，二次調節系統的基本控制規律，簡要介紹了最基本控制規律如：轉速控制、扭矩控制和恆功率控制等。在理論分析和研究的同時，對二次元件的運動部件的檢測和控制系統進行構建；組建了二次元件最高轉速控制系統；設計並完成了數據採集和系統控制軟體；同時，對二次元件控制系統和制動特性採用pid控制進行計算機模擬研究。
  5. The system properties of single - loop system, such as velocity, torque, bifurcated power, transmission efficiency are researched deeply using theoretical analysis and numerical computing, and gives new methods for designing which according to the design parameter a and combine with the system diffluent coefficient q and the ratio of x, p cell transmission. so the theoretical expressions for designing this kind of transmission is established. the design parameter a is put forward as the ratio of confluent power and the input power of single - loop system

    通過對單環路系統的運動學和動力學特性、功率流特性、傳動效率特性等所進行的理論分析和數值計算，提出了以單環路系統主支路功率大小與輸入總功率的比值為關鍵設計參數的設計新方法，並結合系統的功率分流系數q和各組成單元的傳動比，得到了單環路系統的速度、力矩、功率流、傳動效率等計算公式，為該種傳動類型的設計提供了必要的理論依據。
  6. In this paper, the author deduces the air dynamic and torque transmission system model for the 1. 3 mw active stall wind turbine, then founds the control model under the simulink circumstance. and does the output power simulation based on the certain wind speeds. then confirms the coefficients ki and kp

    本文針對1 . 3mw風力發電機組，推導了了空氣動力學模型和傳動系統模型，在此基礎上在控制模擬軟體simulink環境下建立了風力發電機組控制模型，在給定風速下對風力發電機組的輸出功率進行了模擬，並確定了pi控制器的比例系數和積分系數。
分享友人
分享到 Line

分享到臉書