transmittance of light 中文意思是什麼
transmittance of light
解釋
光透射- transmittance : n. 1. 透射作用，透射過程。2. 【物理學】透射比〈率〉。
- of : OF ＝Old French 古法語。
- light : n 1 光，光線；光明，亮光 （opp darkness） Hang the picture in a good light 把那幅畫掛在能看清楚的...
-
The as - grown crystals were characterization by cutting and directional, x - ray diffraction, high resolution ohmmeter, ir transmission spectroscopy, visible light absorption spectroscopy, scan electronic microscopy ( sem ) and positron annihilate time technique ( pat ). the ir transmittance of czt single crystals grown with cd - riched is about 53 %, while 23 % with no cd riched
採用解理實驗、 x射線衍射、電學性能測試、紅外透過譜測試、可見光吸收譜測試、 sem蝕坑分析、探測器的試制等分析測試方法，並首次採用正電子湮沒壽命譜分析方法來研究czt單晶體的空位缺陷，綜合表徵了所生長的晶體的質量和性能。 -
Under the applied voltage of 2v, the duration of colored process and bleaching process of the semisolid - state smart window was 2s and 1. 5s respectively, which denoted rapid response velocities. researches on the glass / ito / wo3 / linbo3 / niox / au all solid - state smart window were referred to the effect of each film ' s thickness on the device ' s electrochromic properties. through the test of the visible light transmittance of the colored state and bleaching state of the device, it proved good electrochromic capabilities with the dynamic optical density changed between 0. 2 - 0. 5
並在此基礎上繼續研究了glass ito wo _ 3 linbo _ 3 nio _ x au結構的全固態智能窗器件模型，對于各薄膜層厚度對于器件電致變色性能的影響做了初步的研究，測試了器件可見光范圍內的著色褪色透射光譜，光密度變化量在0 . 2 0 . 5范圍內，表明器件具有良好的電致變色性能。 -
The experiments show that the color of the iceland spar can be changed when heated to a certain temperature, that is, light yellow iceland spars will fade when heated to 360 - 370, while dark yellow iceland spar will fade at 440 - 450, brownish yellow iceland spar at 460 - 470 ; and the color of light purple iceland spar can be removed when heated to 390 - 400, while the color of deep purple iceland spar can be removed at 440 - 450, deep reddish purple iceland spar at 460 - 470. on base of the u - v absorption spectrum, we find that the u - v absorption spectra of the faded iceland spars are paralleled to the x axis, the transmittance of them are also greatly improved
實驗表明，冰洲石在加熱到一定溫度時顏色會發生變化：淺黃色、深黃色和褐黃色冰洲石分別在360 - 370 、 440 - 450和460 - 470完全褪色；淺紫色、深紫色和深紫紅色冰洲石分別在370 - 380 、 440 - 450和460 - 470時完全褪色。通過對褪色后冰洲石進行紫外-可見光吸收光譜測試表明：完全褪色后的冰洲石在紫外-可見光的吸收光譜上表現為一條近平行x軸的直線；紫外、可見光區的紫區的光透過率有了很大了提高。 -
Determination of light transmittance, solar direct transmittance, total solar energy transmittance and ultraviolet transmittance for glass in building and related glazing factors
可見光透射比太陽光直接透射比太陽能總透射比紫外線透射比及有關窗玻璃參數的測定 -
Test method for visible light transmittance of fine ceramic thin films
精細陶瓷薄膜的可視光透射率的試驗方法 -
Compared with pure pmma, the thermal and mechanical properties of the nanocomposites are obviously improved at a very small amount of mmt ( ommt ) loading. the tgs of the composites via different methods are improved by 10 ~ 26 ?, the decomposition temperatures at weight loss of 5wt % are increased by 42 ~ 99 ?. in the bulk system, tensile strength, tensile modulus and impact strength are improved by 32. 2 %, 60. 3 % and 68. 6 %, respectively, without the loss of light transmittance
相對于純pmma體系，懸浮法、乳液法及本體法復合材料的t _ g值提高了10 26 ；后兩種復合材料熱失重5wt的溫度提高了42 99 ；而本體法復合材料的拉伸強度、拉伸模量及沖擊強度值最大分別提高了32 . 2 、 60 . 3和68 . 6 ，而透光性能基本未受影響。 -
To find the parameters of preparation and annealing process associated with the best electrochromic properties of these films, following researches and experiments were carried out : to compare the visible light transmittance of the colored state with bleaching state of the electrochromic films which were annealed at different temperatures and for different duration, to count the dynamic optical density change, and to test the i - v relations of these films " electrochromic cycles and their colored / bleaching response time
對經過不同熱處理溫度和不同熱處理持續時間得到的薄膜樣品的著色褪色可見光范圍內透射光譜的比較，計算薄膜動態光密度變化量的大小，測試薄膜著色褪色循環伏-安關系以及薄膜著色褪色響應時間的快慢，尋求到薄膜呈現最佳電致變色性能時所對應的制備參數與熱處理參數。 -
The mechanical property, light transmittance of ion exchange strengthened solar cell cover glass and the effect of ion beam bombardment on its properties are investigated by dynamic mechanical analyser ( dma ), microscope, sem, uv / visible spectrophotometer and micro hardness instrument respectively
摘要系統研究了太陽能電池蓋片玻璃經離于交換增強（化學鋼化）后的機械性能、透光率以及離子束轟擊對蓋片性能的影響。 -
The damage and the decrement of light transmittance of ion exchange strengthened cover glass arc much lower than that of as - received one after ion beam bombardment, which demonstrates that ion exchanged solar cell cover glass has better resistance to ion beam bombardment
結果表明，經離子交換增強后的蓋片玻璃，彎曲強度最大可以提高約4倍；且在受到離子束轟擊時的損傷以及透光率下降的程度都小於原片玻璃，說明化學鋼化玻璃具有較好的耐離子束轟擊的能力。 -
The multiply scattering method is used to simulate the propagation of waves in these structures. on the other hand, we also manufacture the samples and measure the transmittance of light with hp8510c vector network analyzer
按照這些條件，設計製作了相應的光子晶體模型，並用多重散射的方法對它們分別進行了模擬計算。 -
Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis. a unique method for cleaning and drying of substrate - cleaning used by scour, drying used by infrared light was fished out by large numbers of experiment. chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time. by the measurements of sem, xrd and uvs, the thin film was analysed. the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous, dense and crackfree was the crystalline phase of hexagonal wurtzite. the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm. the average transmittance of thin film in visible region was above 90 %. the results of measurements else also proved that the thickness of single dip - coating was 75 240nm, this films resistivity was found to be 3. 105 102 3. 96 105 ? cm. the thickness and resistivity of thin film influenced by dope - content, withdrawal speed, pre - heat - treatment, anealing were reseached respectively
利用xrd 、 sem以及uvs光譜儀等分析方法對薄膜進行了研究，結果顯示，所制備的薄膜為六方纖鋅礦型結構，具有高c軸擇優取向性；表面均勻、緻密，薄膜材料由許多星狀晶粒組成，晶粒尺寸大約為10 - 30nm左右；薄膜可見光透過率平均可達90 % ；對薄膜厚度以及電學性能進行了測定后發現：單次鍍膜厚度約為75 - 240nm ， al ~ （ 3 + ）離子摻雜型氧化鋅薄膜的電阻率在3 . 015 102 - 3 . 96 103 ? cm范圍內；分別研究了摻雜濃度、提拉速度、預燒溫度、退火溫度等工藝參數對薄膜厚度和電阻率的影響。 -
Solar protection devices combined with glazing - calculation of total solar energy transmittance and light transmittance - part 2 : detailed calculation method
裝有玻璃窗的遮陽設備.太陽能和光的透射率總量計算.第2部分:詳細的計算方法 -
Solar protection devices combined with glazing - calculation of total solar energy transmittance and light transmittance - part 2 : detailed calculation method ; german version en 13363 - 2 : 2005
裝有玻璃窗的遮陽設備.太陽能和光的透射率總量計算 -
Testing of fibre optic elements ; determination of spectral transmittance of light guides
光纖元件的檢驗.第2部分:光導體光譜透射系數的測定 -
Carbon black for rubber industry - secondary characteristics - part 4 : determination of light transmittance of toluene extract
橡膠業用炭黑.二級特徵.第4部分:甲苯提取物的光傳遞率的測定 -
Rubber compounding ingredients - carbon black - determination of light transmittance of toluene extract
橡膠配合劑.炭黑.甲苯萃取液透光率的測定 -
Rubber compounding ingredients. carbon black. determination of light transmittance of toluence extract. part 1 : rapid method
橡膠配料.炭黑.甲苯萃取物透光率測定.第1部分:快速法 -
The effect of the amt morphology on the optical transparency of epoxy / amt composites ( ep / amt ) was also investigated. the light transmittance of exfoliated and intercalated nanocomposites was made a comparison
採用xrd 、 sem和tem等實驗手段對材料的結構進行了表徵；並對環氧樹脂粘土二元納米復合材料的光學性能進行了系統的研究。 -
The light transmittance of the former with small amt content was higher than that of the latter with relatively higher amt content at the shorter wavelengths, and was lower than the latter at the longer wavelengths. and normalized light transmittance increased when the wavelength increased and the amt content decreased, whenever the amt is exfoliated or intercalated. on the additional, the light transmittance of composites prepared with different amounts of curing agent was also investigated
粘土在環氧樹脂基體中的結構對材料的光學透明性有很大的影響，當有機土含量相同時，粘土剝離有利於ec材料保持較高的透光率；當低粘土含量的插層型納米復合材料與高粘土含量的剝離型納米復合材料相比較時，材料的透光率大小關系隨波長的變化而變化：在短波長時，插層型納米復合材料優於後者；波長變長時，剝離型納米復合材料具有較高的透光率，盡管體系中粘土的含量遠大於插層型納米復合材料。 -
Rubber compouding ingredients. carbon black. determination of light transmittance of toluene extract. part 2 : method for product evaluation
橡膠配方配合劑.炭黑.甲苯萃取物透光率的測定.第2部分:產品評定法
分享友人