tunnel angle 中文意思是什麼
tunnel angle
解釋
通道角-
Obtain these chief research achievements. ( 1 ) the method of hydraulic fracturing, kaiser effect experiment and the finite element numerical simulation computation results, the direction of maximum horizontal principal stress intersect the small - angle of tunnel axial line, it is favorable to the stability of tunnel peripheral rock ; according to the test rust of field stress - relief method, at the present time, zhe gu mount tunnel have n ' t access to high crustal stress site, maximum principal stress magnitude is 17mpa ~ 20mpa
主要獲得以下研究成果： （ 1 ）綜合水壓致裂法、室內巖石kaiser效應試驗和有限元數值模擬計算研究成果，最大水平主應力方向與隧道洞軸線小角度相交，對隧道圍巖穩定性有利；根據現場應力解除法測試結果，目前鷓鴣山隧道尚未進入高地應力段，最大主應力量級為17mpa 20mpa 。 -
With the increase of lateral pressure modulus, the magnitude of principal stress decreases and the direction of it is hardly changeable ; with the increase of the angle between the direction of the maximal horizontal principal stress on magnitude and the fault bearing, the magnitude of principal stress increase and its direction can hardly change ; with the increase of the elastic modulus of rocks, the magnitude of principal stress increases and the direction changes more ; with the increase of pr, the magnitude of principal stress decreases and the direction changes more ; with the increase of lateral pressure modulus, the principal stress at hance, the tress at topmost arch, bottom arch and principal stress at lateral arch decreases, with the increase of the depth of tunnel, the stress of surrounding rock also increases, and the poorer the quality of surrounding rock is, the little its principle stress is
分析得出，隨著側壓力系數的增大，主應力量值減小，主應力方位難改變；隨著與斷層走向的夾角增大，主應力量值增大，應力方向難改變：隨著巖石的彈性模量的增大，主應力量值增大，方向變化越大；隨著泊松比的增大，主應力量值減小，方位變化越大。隨著側壓力系數的增大，頂、底拱處的各應力值增大，拱腰處的主應力減小，剪應力增大，側拱處的各主應力減小，同一側壓力系數的條件下圍巖質量越差，各應力值也越小；隨著洞室埋深的增加，圍巖壓力也增大，圍巖質量越差，其應力值也減小。 -
Systemic numerical tests are made first, to study the parameter sensitivity of cohesion and friction angle and other elastic parameters to the convergence in tunnel. some comprehensive parameter sensitivity laws have been draw thought these numerical tests. the method of emulating back analysis is illustrated secondly, in detail by tracing the excavation and supporting conditions by the special numerical modeling rested in final program
主要研究成果： （ 1 ）建立使各個參數靈敏度值具有可比性的靈敏度計算公式，不僅得到了靈敏度分佈規律，而且還得到了各參數對位移的量化影響結果； （ 2 ）詳細闡述了巖土工程模擬反演分析思路與具體方法； （ 3 ）假定圍巖為理想彈塑性模型，在可量測出理論上認為不可測的塑性變形、實現彈塑性位移分離的前提下，提出了彈塑性問題的分步反分析法。 -
Abstract : wind tunnel experiments were carried out to investigate the influence of wind direction on the wind pressure of proximite buildings. mean and fluctuating pressure coefficients on a high building, at sixteen different wind incidences and with one and two interfering buildings, were measured in the tests. this paper presents the characteristics of wind pressure on the building, which varies with the incident wind angle and with the numbers of adjacent buildins. due to the variation of wind angle and the interference effects, the complex feature of pressure distributions can be found on the downstream building surfaces for building group arrangement at certain angle of wind attack. some area of the interfered building for such configuration, in comparison with one single building ' s, may undergo very strong positive or negative pressures
文摘:通過風洞實驗研究了風向對兩個和三個鄰近建築風壓分佈的影響特性.實驗結果給出了在不同風向角下，作用於受擾建築上的平均和脈動風壓系數.當受擾建築處于下游位置時，建築之間的干擾效應主要表現為遮擋影響，建築物上的總體風壓系數不是很大，但在建築物表面上有時會產生局部較大的負壓系數.另外，在某些風向角下由於受到上游分離氣流的影響，在下游建築的局部表面又會出現較大正壓.這些結果可供建築布置和結構設計時參考 -
Based on the idea of the measured displacement can be divided into elastic and plastic parts, elastic parameters can back analyzed by the elastic displacement, which is the measured instant after blasting excavation. the strength parameter can be got by plastic deformation, which is the measured during the period of construction loop without blasting excavation. lastly, depending on fenner formula, a new and valid evaluating criterion for tunnel stability is presented and the effect of deformation modulus, cohesion, internal friction angle and overburden can be considered
以解析理論為基礎提出一種實用而簡便的圓形洞室彈性反分析方法，且將其應用推廣到其它洞型、分步位移等不同情況；提出一種圍巖強度參數反演方法，並對其可靠性進行了初步研究； （ 4 ）依據芬納公式提出了能夠考慮圍巖變形模量、強度參數、埋深等主要因素的、新的、有效的圍巖穩定性評判方法。 -
Based on traditional bracing system of wind tunnel testing, a system of hanging brace of large angle of attack was designed, which can reduce frame interference
基於傳統的風洞試驗支撐系統，設計了能減小支架干擾的大攻角張線式支撐系統。
分享友人