within (maximum) 中文意思是什麼

within (maximum) 解釋
在之內
  • within : adv. 1. 在內，在里頭；在戶內，在屋內。2. 在心中，心裏是。n. 內部，裏面。 The door opens from within. 這扇門從裏面開。
  • maximum : n （pl maximums ma ） 極點，最大，最高，最高額，最大值；最高點；最大限度；【數學】極大（值）（opp...
  1. Using paralled mathematic induction method it proved that maximum plane graph with any degree which is contructed by way of " adding point within plane " or " adding point at the edge " is 4 - colorable

    運用「并行（或平行）數學歸納法」證明了由「面內加點」或「邊上加點」方法所構造的任意階極大平面圖是可四著色的。
  2. During the effective period of the rider, if the insured suffers from a disease or has an accident abroad, and consequently dies within 30 days for this immediate and separate reason, the company will pay a funeral benefit to the beneficiary for the death benefit according to the actually paid funeral fees for the insured, but subject to a maximum of the basic sum assured as stated in the rider

    若被保險人身處境外時因遭受合同定義的意外事故或患疾病，並以此為直接且單獨原因導致其在30天內身故，本公司按已實際支出的被保險人之喪葬費用給付喪葬保險金予身故保險金受益人，最高給付金額以本附加合同基本保險金額為限。
  3. If during the period of insurance the insured shall suffer bodily injury within the territory of guangdong province, p. r. c. resulting solely and directly from accident caused by violent external and visible means which shall be directly and independently of any other cause result in emergency medical expenses, then china communications insurance will indemnify the insured against the necessary and reasonable costs of such emergency medical expenses charged by a legally qualified medical practitioner, physician, nurse and / or hospital up to the maximum limit of benefits specified in this policy

    在保險有效期內，若被保險人在中國廣東省境內發生確屬明顯外來意外事故所直接引致之明顯身體損傷，而需要緊急救治醫療，在本保險單之最高保障限額之內，中國交通保險將為被保險人支付由法律上合格的醫師、醫生、 ?士及醫院因施救所繳收的必要及合理救治費用。
  4. The analysis of the repeated test data shows the maximum deviation of air drag coefficient is less than 0. 88 % and the deviation of the most surface pressure data is within 1 %, it illustrates the test data is reliable

    重復試驗的數據分析表明，空氣阻力系數數據的最大偏差小於0 . 88 ，絕大部分測壓試驗數據的偏差均在1以內，這說明客車模型風洞試驗數據的精度較高。
  5. The maximum tangential compressive reaches 2221, which is about 76. 6 % of the ultimate compressive strain, within safe status

    在龍固副井施工中，井壁環向最大壓應變達2221 ，約為極限壓應變的76 . 6 % ，處于安全狀態。
  6. A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle

    試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。
  7. In ported trials, wu gave the minimum tr of all plants, and its diurnal maximum tr persisted stability the most within the range of soil moisture 20. 4 % - 6. 4 %. ; nx lowered its tr and shrank its high - low lines after had experienced irregular wet - drought hardening period during culturing ; kerqin performed a plasticity as compared to field ; c. lanata also stood the most stability but on the basis of middle - high maximum tr level ; tr by caragana korshinski was high when soil water was abundant, but was lowest for lack of water ( 6. 4 % )

    盆栽試驗表明，華北駝絨藜蒸騰最弱，且在土壤含水量20 . 4 6 . 4的范圍內最高蒸騰速率穩定性最強；經脅迫鍛煉寧夏駝絨藜蒸騰降低，變幅減小；科爾沁駝絨藜與大田相比蒸騰可塑性較強；土壤水分變化中，北美駝絨藜蒸騰在中高水平上維持穩定的能力最強；水分良好時檸條蒸騰很強，水分脅迫中蒸騰極大降低。
  8. Under the control of a current loop, the system can make advantage of the motor ' s ability of over - current with a maximum limit, as a result, the motor can implement constant - current staring under a maximum let - through current. therefore, the motor ' s rotational speed can rise at a maximum acceleration and reach the given speed within the shortest time

    在電流環的控制下，系統在起動的時候能夠最大限度的發揮電機的過流能力，使電機以最大允許的起動電流恆流起動，則電機轉速可以以最大的加速度上升，並且以最快的時間達到給定轉速。
  9. The principal stress value arised alteration, the magnitude of stress closed to 25 ~ 32mpa, its influence scope was within the scope outside of tunnel opening 10 ~ 15 meter, maximum tense focused at vault and middle of floor about half meter. shearing stress focused at corner of vault and wall, always been sheared

    主應力量值也發生了較大改變，壓應力可達25 32mpa ，其影響范圍在隧道邊墻外10 15m ；拉應力集中在拱頂和底板中部約0 . 5m范圍內，最大可達10mpa ；在拱腰和墻腳常為剪應力集中區，易發生塑性剪切破壞。
  10. This is the maximum output source or sink current that can flow safely into an output terminal of the device at voltages within the normal operating range

    持續輸出電流是指器件的輸出端可以安全地注入或泵出的最大電流。
  11. By adjusting the fuel rectifying screw and then increasing the fuel quantity per cycle, the loss of the maximum power of e30 engine ca n ' t exceed 10 % of the maximum power of diesel, and the loss of the maximum torque can be controlled within 2 percent

    通過旋出油量校正螺釘，增大燃料供給量，可以使e30混合燃料發動機的最大功率損失控制在10以內，最大轉矩損失控制在2以內。
  12. It is expected that students will graduate within 4 years however, 8 years is the maximum allowed by the ministry of education

    一般而言學生在校修業四年即可畢業然而文部科學省規定八年為最大修業年限。
  13. Maximum paper size : 320x457mm. one - sided and two - sided coated stock acceptable within weight range

    最大紙張尺寸320457mm ，在重量范圍內接受單面及雙面塗層紙
  14. 9. some detail requirements, such as the maximum axial load ratio in columns, the minimum of confined transverse reinforcement within yield hinge regions and so on, are also proposed to modify chinese code ( gbj1o - 89 )

    本文還討論了現行《混凝土結構設計規范》 （ gbj10 ? 89 ）關于軸壓比限值及柱端加密區約束箍筋最小要求等構造方面存在的問題，提出了相應的修正建議。
  15. So far as the mixing material for building the earth - rock fill dam with clay core for shiquanhe hydropower station is concerned, the effect from the variation of the sand content for the filter material on the maximum dry density and the relevant parameters are to be determined within the variation area of the mixing mass ratio of ( 46 ~ 54 ) : ( 54 ~ 46 ) through this experiment, due to the max, dry density is largely influenced by the mixing ratio of both the lifter material and the clay and the sand content of the filter material, so as to determine the actual filling compactness of the mixing material of the core

    摘要由於獅泉河水電站粘土心墻土石壩摻合料的最大幹密度受反濾料與粘土料的摻合比例、反濾料含砂率的影響較大，因此擬通過本試驗確定摻合質量比在（ 46 ~ 54 ） : （ 54 ~ 46 ）范圍變化時，反濾料含砂量變化對最大幹密度的影響程度及相關參數，從而確定心墻摻合料填築的實際壓實度。
  16. A bearing surface transmits the interaction between an arch dam and its foundation, the strength of which directly affects the constraint of the bedrock to the dam, and thus affects the stress and deformation of the dam. the influence is studied in this paper with nonlinear finite element method, as an example, for a high arch dam in design. the results show that the influence on stress is only limited within the local area near the bearing surface, larger on the maximum principal tensile stress than on the principal compression stress, and the decrease of the strength does not cause unlimited increase of the maximum stress. the influence on the displacement of the top of the dam is smaller than that of the bottom of the dam, especially the relative downstream displacement. at the lower strength of the bearing surface, the relative downstream displacement at the bottom of the dam increases with the decrease of the strength

    建基面是傳遞拱壩和基巖相互作用的紐帶，它的強度直接影響基巖對壩體的約束，從而影響壩體的應力和變形.採用非線性有限單元法，以設計中的某高拱壩為例，分析建基面強度對壩體應力和變形的影響.結果表明建基面強度對壩體應力的影響僅限於建基面附近的局部范圍，對最大主拉應力的影響要大於對最大主壓應力的影響，建基面強度的降低不會無限地增大壩體的應力數值；建基面強度對壩頂位移的影響較小，但對壩底位移（尤其是順河向相對位移）的影響較大，當建基面強度較低時，壩底順河向相對位移隨建基面強度的降低而增大
  17. For maximum portability, result set columns within each row should be read in left - to - right order, and each column should be read only once

    建議最好讀取的時候按照記錄檢索時的順序從左向右讀取，而且只讀取一次。
  18. 4 if the seller has failed to perform his duties under article 11. 3 by the date on which the buyer becomes entitled to the maximum amount of liquidated damages according to that article, the buyer may give notice in writing to terminate the contract as regards the non - conforming goods unless the supply of replacement goods or the repair is effected within 5 days of receipt of such notice by the seller

    4如果賣方在買方依照第11 . 3條的規定有權獲得最高額約定的賠償金之日為止，未能依照第11 . 3條的規定履行義務，買方基於貨物與合同不符，有權書面通知賣方解除合同，除非賣方在收到該通知之日起5日內提供了替代貨物或修復了貨物。
  19. 3 when article 10. 2 does not apply and the seller has not delivered the goods by the date on which the buyer has become entitled to the maximum amount of liquidated damages under article 10. 1, the buyer may give notice in writing to terminate the contract as regards such goods, if they have not been delivered to the buyer within 5 days of receipt of such notice by the seller

    3當第10 . 2條不適用，並且賣方在買方依照第10 . 1條的規定有權獲得最高數額的約定賠償金日為止仍未能交付貨物時，如果貨物未在賣方收到該通知之日起5日內交付給買方，買方基於這些貨物的原因有權書面通知賣方解除合同。
  20. Any sums which the buyer are liable as penalties for which no provisions are made in this contract are made against invoice issued by seller and by bank transfer within maximum 10 banking days as for the submitted invoice date

    除非合同里有相關規定，對于要求買方支付的任何罰金，賣方須向其出具相應金額的發票，買方須在發票日期之後的10個銀行工作日內通過銀行匯款予以支付。
分享友人
分享到 Line

分享到臉書