剩餘油飽和度 的英文怎麼說

中文拼音 [shèngyúyóubǎohédù]
剩餘油飽和度 英文
remainder oil saturation
  • 剩 : Ⅰ動詞（剩餘） be left over; remain Ⅱ形容詞（剩餘的） surplus; remnant
  • 餘 : Ⅰ同「余」Ⅰ-Ⅳ1. Ⅱ名詞（姓氏） a surname
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 剩餘 : overplus
  • 飽和度 : saturation level; saturation; degree of saturation飽和度控制 saturation control; 飽和度數值 satur...
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  1. In order to understand the remaining oil distribution, and provide evidence for numerical simulation of polymer flooding and comprehensive adjustment, a study on the numerical simulation on the water flooding of pu 1 - 2in western south central block is performed

    模擬結果表明，剩餘油飽和度分佈不均勻，西部過渡帶和注采系統不完善的斷層附近含油飽和度比較高，葡1油層動用狀況較差；南中塊西部葡2 （下標2 ）和葡2 （下標3 ）沉積單元發育較好，動用程度較大，最終採收率可達39 . 6 % ~ 43 . 5 % ，而葡1單元則相對較差，最終採收率只達到28 . 1 % 。
  2. The obvious effects have been made in the adjustment of injection to - producing and water blocking by applying comprehensively the log information of degree of saturation and profile - log and tracer survey information to tap the zone of enrichment of remaining oil potential, analyze the direction of injected water streamline and guide the measures for tapping potential in tuo 7 fault block

    摘要總結了坨七斷塊綜合應用飽和度測井資料、吸水剖面資料、水井注示蹤劑資料，發掘剩餘油潛力富集帶、分析注水流線方向，指導油井措施挖潛、注采調整和堵水調剖工作所取得的明顯效果。
  3. Specially, the method of permeability - saturation - waterflood curve, which takes account of both relative permeability curve and waterflood curve, makes up the shortcoming of over - idealize only on pure theory and over - simplistic only on production date. ( 3 ) streamline - model technique is introduced into the research of inter - well remaining oil distribution, which realizes characterizing reservoir properties dynamically and explaining inter - well remaining oil saturation quantitatively on the micro - computer

    滲飽-水驅曲線法的應用綜合考慮了相滲曲線特徵及水驅特徵曲線，彌補了單一使用理論方法求解剩餘油飽和度過于理想化、單靠生產數據求解剩餘油過于表面化的缺陷，計算結果更為合理； （ 3 ）在井間剩餘油研究中引入了流線模型技術，實現了利用微機進行井間剩餘油參數的表徵和剩餘油飽和度的定量解釋。
分享友人
分享到 Line

分享到臉書