吞吐量比率 的英文怎麼說

中文拼音 [tūntǔliángbǐlǜ]
吞吐量比率 英文
tr throughput ratio
  • 吞 : Ⅰ動詞1 （整個兒地或成塊地咽下去） swallow; gobble; gulp; devour 2 （并吞; 吞沒） take possession ...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 吞吐量 : cargo-handling capacity
  • 吞吐 : 1 （大量進出） swallow and spit; take in and send out in large quantities 2 （含混不清） hem and ...
  • 比率 : ratio; proportion; rate比率計 ratio meter
  1. The directional routing protocol ds _ dsr put forward by the author is the improvement of the current protocol dsr, complete routine discovery and maintenance by directional neighbor nodes routing table, source routing and directional steering. the research discovers the application of the directional antenna, compare the omnidirectional antenna can increases the networks " total throughput, obviously reduces the co _ channel interference ( cci ), multiple access interference ( mai ), enlarges the nodes " signal and interference to noise ratio ( sinr ), and because of the high gain of directional antenna can realize the communication with farther distance and less jump, end to end delay can decrease deeply, simultaneously, security of networks can be improved partially, the node energy also can be saved easily by power control

    本文提出的定向路由協議ds _ dsr是基於對現有協議dsr的改進下實現的，通過定向鄰節點路由表、定向源路由和定向搜索來完成路由發現與維護。研究發現，定向天線的應用，相比全向天線可明顯提高網路的總的吞吐量，減少通道干擾、多址干擾，提高信干噪比，且由於定向天線的高增益可實現較遠距離、較少跳數的通信，減少了路由發現時間，這樣大大減小了傳輸時延，網路的整體性能得到了不同程度的提高，同時部分地解決安全問題，通過功率控制還可較容易的實現節能的目的。
  2. This dissertation is faced to the process of steel rolling to found network of manufacture material flow, basing on it founding guide line evaluation system of the cost of unit standard producing working procedure, guide line evaluation system of the quality cost of unit standard producing working procedure and guide line evaluation system of performance and efficiency ; and base on the cost data of all kinds of material flows, manufacture flow, flux data, manpower, energy consume, material consume, capital asserts occupied, fund occupied, and the production in working procedure, throughput of the materials in working procedures in the flow and countercurrent flow in the network of material flow of recorded in working procedure producing, using the “ whole closed down lane ” model to describe network of manufacture material flow of steel rolling, found the cost analyzing model system of the network faced to producing process. make the cost increasing of the producing by abnormity material flow in working procedure, and even the cost increasing of the producing procedure as the cost of the management behavior of working procedure fallen under cost evaluation guideline in responsible working procedure, so as to ration measure the factors fast correlated with management behavior by measuring the cost

    在企業管理信息化輔助工具所建立的數據平臺基礎上，建立了以基準物流圖模型為基礎的軋鋼生產主流程物流網路拓撲圖，根據圖論的理論求解最大流量和最小費用;計算每個生產節點的加工成本，分離質量成本，克服了單純財務數據進行成本核算所帶來的缺陷;建立了軋鋼生產主流程工序含鐵物料吞吐能力基準圖模型，並根據此模型建立了軋鋼生產主流程工序激勵物流協調性和匹配性、工序響應物流協調性和匹配性分析的過程能力指數計算方法;通過引入決策單元綜合投入與綜合產出效率最優原則的模型和基於投入不變、分析產出是否有效或基於產出不變、分析投入是否有效的模型，實現了對多個績效指標在不同績效值集合之間的相對比較，並可根據投入產出效率準則、或者投入（產出）有效性準則進行排序。
  3. Compared to its commercial counterparts, the proposed scheme can improve the instruction throughput by 23 %, while maintaining the hardware and power consumption

    實驗表明，相比商業化的處理器，該策略下的超標量結構在保持電路和功耗開銷的同時，指令吞吐率平均有23 %的提高。
  4. Combined with the adaptive modulation and coding technology, this algorithm reallocates the residual power by effectively utilizing the discrete modulation orders according to the different priorities of sub - channels under the limitation of quality of service over the block fading channel

    在滿足服務質量要求的前提下充分利用星座圖尺寸的離散性，將殘余功率按照各子通道的不同優先級進行二次分配，並結合自適應調制編碼技術改善低信噪比時的系統吞吐量。
  5. But this testing is sometimes limited to the measurement of one value, say, throughput rate or response time

    然而，測試往往局限於對某個值的測量，比如吞吐率或者響應時間。
  6. And some effective techniques are discussed to lower the clock period and cpi ( cycles per instruction ) of the pipeline. to eliminate the clock frequency limitation by some complex instructions " long executing time and achieve single - cycle throughput, a scalable super - pipelining extension technique together with a high performance / cost pipeline shift mechanism is presented in this paper

    為避免流水時鐘頻率受制於某些復雜運算指令較長的運算時間，又要達到單周期完成一條運算指令的吞吐量指標，本文提出對ex級進行可伸縮超流水擴展的思想，提出並實現了一種高性加比的切換控制方案。
  7. Future mobile communications have to support the transmission of high rate data and multimedia applications in the radio spectrum, which is already extremely scarce. the basic idea of adaptive coded modulation is to maintain a constant throughput by varying the transmitted power level, symbol transmission rate, constellation size, coding rate or any combination of these parameters. thus, without sacrificing bit - error rate ( ber ), these schemes provide high average spectral efficiency by transmitting at high speeds under favorable channel conditions, and reducing throughput as the channel degrades

    自適應編碼調制（ adaptivecodedmodulation ， acm ）的基本思想是在不犧牲系統傳輸性能（比如ber ）為代價的前提下，通過單獨改變發送功率、波特率、編碼方案、碼率、調制方式，或者是綜合改變前面所述的各種參數，在有利的通道條件下，獲得較大的吞吐量，當通道質量下將時，相應地降低傳輸速率，最終達到提高平均頻譜效率的目的。
  8. In this paper, we create the network, node and process model using opnet software to simulate throughput performance of aos packet service, and choose various combinations of source packet length, transfer frame length and channel error rate to form different simulation scenarios. by analyzing the throughput - packet length, throughput - frame length simulation curves at different channel ber we get the optimal packet length and frame length configurations, and give some advice for the optimization of protocol configuration parameters according to throughput performance metric ; the complete node and process model of aos protocol have been built by opnet software, and a simple network scenario has been built to simulate and verify the validation of the protocol model

    本文在建模模擬方面，用opnet軟體建立模擬aos協議包業務吞吐量性能的網路、節點、進程模型，選取不同的包長、幀長與通道誤比特率組合建立模擬場景進行模擬，得到不同誤比特率條件下吞吐量-包長、吞吐量-幀長關系曲線，經過分析得出最大吞吐量對應的最佳幀長、包長配置，給出以吞吐量性能為指標優化協議配置參數的建議;用opnet軟體搭建aos協議封裝節點模型和各個進程模型，建立簡單網路場景進行模擬驗證協議封裝節點模型的有效性。
  9. The paper studied various algorithms of window - based tcp congestion control in depth, analyzed the algorithms in detail, and compared their validity and fairness based on simulation experiment. the paper also studied the throughput model of tcp and rate - based, tcp - friendly congestion control protocol tfrc was studied based on the model

    論文詳細研究了基於窗口的tcp擁塞控制演算法，對各種演算法的協議實現進行了較為深入的分析，並通過模擬實驗對各自的有效性和公平性進行了對比研究；分析了tcp公平的數據吞吐量模型，在此基礎上研究了基於速率的tcp公平的擁塞控制演算法tfrc並進行了詳細模擬。
  10. Aiming at the wireless optical channel and operation characteristics, carrier sense multiple access / collision avoidance ( csma / ca ) mac protocol is put forward taking into account the bit error rate ( ber ). this paper studies the protocol theory, access mechanism detailedly, and models the throughput performance, simulates and analyzes the performance. the paper analyzes the performance influence factors such as ber, transmit probability, number of the terminals, initial windows, retry limit and so on

    （ 2 ）針對無線光局域網的通道特性及業務特徵，在考慮通道誤碼率影響的基礎上，分析了基於載波監聽/沖突避免（ carriersensemultipleaccess / collisionavoidance ， csma / ca ）接入的無線光局域網mac協議，詳細闡述了協議原理和接入機制，用馬爾可夫模型對mac吞吐量性能進行了建模，並進行模擬計算和分析，詳細討論了在基本接入機制和rts / cts接入機制下，通道誤碼率、終端發送概率、終端數、初始化窗口、重傳極限等參數對吞吐量性能的影響，同時對兩種接入機制性能進行了比較分析。
分享友人
分享到 Line

分享到臉書