壁面剪應力 的英文怎麼說

中文拼音 [bìmiànjiǎnyīnglì]
壁面剪應力 英文
wall shear stress
  • 壁 : 名詞1 （墻） wall （of a house etc ） : 銅墻鐵壁 bastion of iron2 （作用像圍墻的部分） wall of st...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 剪 : Ⅰ名詞1 （剪刀） scissors; shears; clippers2 （姓氏） a surname Ⅱ動詞1 （用剪刀等使細的或薄片的東...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 壁面 : wandung
  1. The research object in this text is the actual project - - the mansion of yatingyuan ( 40 layers above the ground, 125. 4 meter high ). the structure - design is by satwe and the analysis of the structure dynamic characteristic and earthquake response by sap2000, whose calculation models are set up according to the actual size of the structure. in satwe, the analysis model of beam and column is simulated by frame - element, slab is plane - element, shear - wall is wall - element and slab is infinitely rigid in the internal and zero in the external ; in sap2000, beam and column is frame - element, slab and shear - wall is shell - element and slab is elastic floor

    本文以實際工程項目? ?雅庭園商業中心大廈（地面以上40層，建築總高度為125 . 4米）為研究對象，結構設計採用satwe ，結構的動力特性和地震反應分析採用sap2000 。結構satwe和sap2000分析的計算模型均按結構的實際尺寸建立， satwe分析模型的樑柱採用桿元模擬，樓板用薄壁殼元模擬和剪力墻用墻元模擬，樓板平面內無限剛、平面外剛度為零； sap2000分析模型的樑柱採用桿元模擬，樓板和剪力墻用殼元模擬，樓板為彈性板。
  2. The turbulent characteristics of high - velocity sediment - laden and aerated flow are more other than the clear water flow of single - phase and current of low speed. in a special circulating system with high velocity flow, some flow parameters such as boundary shear stress and pulsation pressure are measured. an investigation is made on the turbulent characteristics of the three - phase flow of water, air and sand

    本文針對高速含沙摻氣水流的運動規律有別于低速水流及清水單相流，在自己研製的高速渾水循環系統中，通過對高速含沙摻氣水流壁面剪切應力和脈動壓強等參數的量測，分析了水沙氣三相流的紊動特性，探索了泥沙對固壁的磨蝕機理及減蝕措施，其主要內容包括以下幾個方面： 1
  3. The demarcation point of, which is the parameter in erf ' s yield stress equation, is 2. 0. for, the dynamic characteristics of the clutch are remarkably different from those for. thirdly, the linear stability of plane shearing flow with non zero pressure gradient is studied

    論文第三部分對電流變液非零壓力梯度平板剪切流動的穩定性進行了分析，提出流場對屈服應力達到飽和的概念；並得出平板壁面剪切運動以及電流變液屈服應力的提高，都將使流動穩定性增強的結論。
  4. The method for improving the measuring accuracy of the wall shear stress by electrochemical technique

    提高電化學法測試壁面剪應力精度的方法
  5. It is found that drag reduction occurs with adequate wavenumbers and grows with an increase of h. the mechanisms are revealed through variations of velocity profile and the decrease of wall shear stress

    分析減阻機理是流速分佈曲線及近壁區速度梯度介於層流與湍流之間， h值增大引起壁面剪應力顯著下降。
  6. The results show that the frictions caused by the wall of shear box will influence the distributions of stresses in specimens and the normal pressure stresses on the shear plane

    結果表明，剪力盒壁摩擦力將會影響試驗土樣中的應力分佈和剪切面上的正壓應力值。
  7. 4 were calculated in curved tube with permeable arterial wall and effects of parameters, such as shear stress, mass flux of arterial wall, on mass transfer were studied. it was found that steady laminar flow become unsteady with the increase of de. the concentration in inner section of transverse section of the tube is higher than other areas, and with the increase of de and pe, the concentration there increase obviously. it indicates that for the permeable arterial wall, the macromolecules are likely to gather in the areas where axial velocity and shear stress are relatively low, thus indicates why location of atherosclerosis frequently occurs at inner side of curved tube

    4 ，在可滲透邊界條件下彎曲血管內的濃度場分佈，並分析了諸如壁面剪應力及跨壁流量等參數對傳質的影響。計算表明隨著dean數的增加，定常層流開始失穩。血管截面內側區是濃度分佈較高區域，並且隨著dean數和peclet數的增加，內側區濃度明顯增大。
分享友人
分享到 Line

分享到臉書