幀狀態 的英文怎麼說

中文拼音 [zhèngzhuàngtài]
幀狀態 英文
fs frame status
  • : 量詞(幅, 用於字畫)
  • : Ⅰ名詞1 (形狀) form; shape 2 (情況) state; condition; situation; circumstances 3 (陳述事件或...
  • : 名詞1. (形狀; 狀態) form; condition; appearance 2. [物理學] (物質結構的狀態或階段) state 3. [語言學] (一種語法范疇) voice
  • 狀態 : status; state; condition; state of affairs: (病的)危險狀態 critical condition; 戰爭狀態 state o...
  1. Further investigated and analyzed composition structure and flow data that dsa ' s formation of image is systematic at first in this paper, carried on intact summing up to the data in the system, having given out the plan of design of high speed and large capacity data channel of digital formation of image system of x - ray ; deeper discussion of control way on sdram, give solution that many pieces of sdram works togetherses of realizing heavy capacity, designing of heavy capacity deposit board realize storing at a high speed to vision data by frame on the basis of this ; through further investigations of interface of pci bus, optimize back end state machine design and urge procedure making with lower, giving intact pci interface scheme that realize high speed dma data transmission and satisfy request of video transmitting ; further investigate the figure systematic design method of programmable logic devices, due to the difficult point of drifting about of enabled signal in fifo in common use and setting up and keeping of output signal, method has been proposed of improving stability of system making use of signal utilizing the phase locking ring in fpga to offer a lot of clocks to move thus realize coordinating the data between every module of system to transmit at a high speed by making use of fifo

    本文首先對數字減影血管造影( dsa )成像系統的組成結構和數據流向進行了深入研究和分析,並對系統中的數據流向進行了完整的歸納和總結,給出了x線數字成像系統中的高速大容量數據通道的設計方案;在對sdram的控制方式做了深入探討后,給出了實現大容量多條sdram共同工作的解決方案,在此基礎上設計了大容量存板實現對圖象數據進行高速存儲;通過對pci總線介面的深入研究,優化後端機設計和低層驅動程序開發,給出了完整的pci介面方案實現高速dma數據傳輸,完全可以滿足視頻傳輸要求;深入研究了基於大規模可編程器件的數字系統設計方法,針對通用fifo使能信號漂移、輸出數據難于建立和保持等設計難點,提出了利用fpga中的鎖相環提供多個時鐘相移的信號來提高系統穩定性的解決方案,從而實現利用fifo來協調系統各模塊之間的數據高速傳輸。
  2. The system is consist of the main data processing board which is based onthe fpga device and fast ethernet phyceiver rtl8201l and a - law pcm data encoder and decorder chip msm7702 - 3, and the dial - up and display board which is based on mcu. the main board would carry out the core task of data processing, such as voice data packing and unpacking, the ethernet frame processing, protocol processing, call processing, etc. the dial - up and display board would carry out the task of display the ip address which is input by consumer and status of network during talk period from the main board, and so on. in the paper the system of lan ip telephone and the tcp / ip protocol is introduced firstly, then the fpga device is stated. after that the fpga - based hardware scheme is introduced in detail in chapter four

    系統以altera公司的acex1k系列的fpga和快速以太網控制器rtl8201l和語音編解碼晶元msm7702 - 3為核心構建了數據處理主板和以單片機為控制器的撥號顯示子板組成。數據處理主板的核心任務,包括語音數據處理、以太網處理、協議處理、呼叫處理等。撥號顯示子板則完成通話前的顯示用戶所撥過的ip地址,通話期間網路的顯示等等。
  3. The frame picking - up, sum checkout and decoding techniques of nmea0183 information in software design are discussed. the frame picking - up program for nmea0183 information is designed based on the finite state machine theory

    研究了程序設計中nmea0183格式數據的提取、和校驗及解碼技術,基於有限機理論設計了nmea0183格式數據的提取程序。
  4. This trade - off is application dependent ; if you use more than a 1000 set calls per frame, you should consider taking advantage of the redundancy filtering that is done automatically by a non - pure device

    是否手動設置是依賴于應用程序的,如果你每使用超過1000次設置,你應該考慮濾除冗餘設置,雖然這種操作會在使用非純設備時會被自動執行。
  5. The status bar contains a frame - per - second measurement to illustrate the performance differences

    欄包含每秒數的度量,以闡釋性能差異。
  6. According to the information that reflected the condition of channel, this thesis classified acm into heuristic acm and snr - estimation acm. the system that using the first one of acm decide the scheme of modulation and coding according to the frame error ratio that reflected indirectly the condition of channel, while it using the another of acm decide the scheme according to the snr estimation

    根據反映通道的信息不同,本文將自適應編碼調制技術分為基於探索的自適應編碼調制技術和基於通道信噪比預測的自適應編碼調制技術,前者根據間接反映通道條件的誤率和重傳次數信息來決定編碼調制方式,而後者根據通道信噪比預測的結果調節編碼調制方案。
  7. Embedded technologies, multi - way technologies and sampling technologies are used to reduce the sampling rate by software, so that the system can provide appropriate image format according to the condition of network and can eliminate aliasing noise. the system also uses motion detection to control the frame rate. therefore, the system can save transmission bandwidth effectively and design to provide multiple degrees qos according to the network condition

    本方案採用了嵌入式技術和多路技術,並從采樣技術入手,軟體調整采樣率,使得系統能夠根據網路提供適當格式的圖像,消除欠采樣噪聲,而且通過運動檢測來控制率,從而可以有效地節省傳輸帶寬,達到根據網路情況自適應地提供多種qos服務等級的目的。
  8. Qe1 achieve the whole synchronization by software and hardware. during the course of the initialization of the qe1 system, the chip pm4354 can accomplish the task of synchronization of bit, frame and multiframe after the chip initialization by the software. after pm4354 accomplishes the bit synchronization, qel will read the status registers of the pm4354 to get the status of each el circuit and choose recovered clock of the specified the el circuit as the external timing source of the whole htc - 5200an equipment

    Qe1系統在系統初始化時,通過軟體完成對硬體晶元pm4354的初始化工作后,便可利用該晶元完成4路e1的同步(位同步、同步和復同步) ;在pm4354完成時鐘提取的任務后, qe1通過不斷地訪問pm4354的寄存器,獲得每路e1的信息,在時鐘源的選擇原則下,選擇指定e1線路的恢復時鐘作為整個htc - 5200an節點設備的外部參考時鐘,從而解決了htc 5200an的中繼板卡由e1變為qe時所帶來的網同步時鐘源。
  9. ( 3 ) presenting in - depth research and discussion on the solution of the 2 puzzles by taking ais information as the data - source of aas. ( 4 ) researching on the acquisition and processing method of basic navigation data from ais, such as relative course, relative speed, distance, bearing, cpa and tcpa of target ship. ( 5 ) designing the abaas ( ais based automatic anti - collision system ) collision avoidance scheme and establishing the principle of collision avoidance of own ship and designing the new principle of actions for the collision avoidance using the news data of ais according to the international regulations for preventing collisions at sea, 1972, by calculating the risk of collision and consideration of the division of the three kinds of ship encounter

    對于基於ais的自動避碰決策方法進行了深入研究,分析了國內外專家對于碰撞危險度的研究成果,並提出了確定碰撞危險度的方法;借鑒國內外專家的見解,對避碰規則規定的三種會遇局面進行了定量的分析並對避碰行動局面進行了劃分;提出了互見條件下兩船會遇中本船避碰責任和行動判斷的原則;制定了兩船會遇避碰方案和多船會遇避碰方案;針對從ais得到的他船航行信卜汕燈運學1 ; t卜學位論義杜十川s的船舶自動避隴決策系統的應用研究,以設zf了符合現則欲八條大十船舶m災仟的避碰原則方沾。
  10. Introducing and comparing the difference within the conception of area segmentation, motion segmentation and moving object segmentation vop extraction, and their application in content - based video sequence image coding. analysis the relationship between the frame difference image and its relative frame gray level image. then a new automatic moving object edge tracking and extracting method, based on the high correlation between the edge of frame difference and the edge of gray level image, was proposed. using the close of moving object edge to get the real moving object

    介紹比較區域分割運動分割和物體分割的概念及其在視頻序列圖像分割中的應用。分析說明各種運動差圖像與相應灰度圖像的關系。提出了基於差圖像邊緣與灰度圖像邊緣之間強相關性的運動物體邊界自動跟蹤提取演算法。
  11. Suppose we want to embed a tool bar and a status bar in a child frame

    假設我們需要在子控制項中嵌入一個工具條和一個條。
  12. Because of the complicated flight state of the aircrafts, there rests a critical demand for high speed operation of flight data in the synthetical graphical display system : we must finish all computations of the flight data and send them into the display panel in a very short time which is critically specified by the display instruments

    在機載綜合顯示系統中,由於飛行復雜,對飛行數據的處理和顯示都提出了比較嚴格的時間要求:需要在顯示器的一時間內完全計算數據並完成顯示任務。因而在工程中,硬體設計的運算速度成為至關重要的因素之一。
  13. Srf status report frame

    報告
  14. Then, it fully describes the set - up of the system, including a detailed introduction of the system of hardware platform, the data interface of the hard and software, the data structure, the relevant controlling order of system hardware, the switch of the work mode, and the communication between computer and servo

    接著,介紹了跟蹤系統的系統設置,其中包括了對遙測系統的硬體平臺的概述,通過系統硬體與軟體的數據介面和數據格式對硬體進行工作的設置,並且還講述了系統的工作模式的切換方式,以及信號處理機與伺服器的工作通信。
  15. Sif status information frame

    信息
  16. This paper analyzed p - persistent csma / cd protocol and proposed a new adaptive algorithm for the adjustment of the coefficient p by real - time channel traffic sensing based on the feedback control theory, i. e., changing the value of p dynamically through the analysis of networks " flow to control the behavior of the stations sending data frames in the same collision domain, to keep the media channel in an optimal state and to enhance the channel transmission efficiency

    該演算法基於對網路流量的分析,在osi物理層通過通道信息量的在線實時檢測,根據反饋控制的原理,在數據鏈路層動地調整控制輸入參數p ,從而控制站點發送分組數據的行為,使通道處于最佳的傳輸,提高通道的效率。
  17. So, in this paper, the theory and algorithm of vr are being developed. in this paper, several key problems in vr process are being discussed both in theory and application, which include pre - processing, frame decomposing of raw voice signal, characteristic selection and calculation, dynamic mapping of characteristics. linear prediction model, model coefficients ( lpc ), as well as cepstrum coefficients are well analyzed both in analysis and calculation aspects

    作者在本論文中,對國內外語音識別技術發展況做了較全面的總結分析,對語音信號產生模型、線性預測編碼方法、求解lpc正則方程的德賓遞推演算法、語音信號同處理方法、 lpc倒譜特徵計算、動特徵匹配等語音識別的關鍵環節的技術問題進行了深入的理論分析和模擬研究,用matlab語言編寫了語音信號濾波、分、特徵計算和匹配軟體,並給出了模擬計算結果。
  18. The control frame in a response message is the status frame

    響應消息中的控制
分享友人