慣性級 的英文怎麼說

中文拼音 [guànxìngjí]
慣性級 英文
inert stage
  • 慣 : Ⅰ動詞1 （習以為常 積久成性; 習慣） be used to; be in the habit of 2 （縱容; 放任） spoil; indulge...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 級 : Ⅰ名詞1 （等級） level; rank; grade 2 （年級） any of the yearly divisions of a school course; gra...
  • 慣性 : [力學] inertia; inertance; sluggishness; the force of inertia
  1. So this base isolation technique has profound prospects. unfortunately there exist definite difficulties in the calculation because of the nonlinear of the base friction force. now, both the equivalent damping method and the numerical calculatin of the vibration response of the base - isolated buildings are frequently used in the calculation of the seismic response of the base - isolated building. however both of them have certain drawbacks. in this paper, the response of the building with base - isolation system is derived by the method of fourier expansion for the friction force and the earthquake response. at the same time, the sliding vibration character of inertia of a single mass structure and the sliding vibration response of a muti - mass structure are discussed. the stable condition of the sliding base isolation system of a structure is given. in the end, two circes of base fixation and base sliding are analyzed by adopting ansys

    本文利用對摩擦力和地震響應進行付氏級數展開的方法導出了基底具有摩擦隔震系統的地震反應。同時，文中從研究單質點結構的滑動振動慣性力入手，進而對多質點結構體系滑動振動反應進行探討，分別給出了結構滑動隔震的自身穩定條件。最後，本文利用ansys對基礎固定和基礎滑移隔震兩種工況進行了動力模擬模擬分析，進一步證實了基礎滑移隔規律。
  2. This paper reports the application of classifiable fuzzy control for the object which is changeble on characteristic, with long timedelay and large inertia

    摘要研究了對象特性變化以及時滯和慣性較大對象的分級模糊控制。
  3. Abstract : three - stage dust removal system of impinger, centrifugal dust collector, wet fibre - grid scrubber applying to dust collecting of driller in opencut mine is reported in this paper. the operational results show that this system has stable operation, higher dust removal efficiency, less drop pressure and dust concentration of outlet of the system meets emission standard

    文摘:介紹了用慣性除塵器、旋風除塵器、濕式纖維柵除塵器組成的三級串聯除塵系統進行露天礦的鉆機收塵，運行結果表明該系統運行可靠，阻力小，除塵效率高，系統出口含塵濃度達到排放標準。
  4. Abstract : the compound multi - cyclone, which combines initial sedimentation with multi - entry cyclone to collect dust, is applied to pulverized coal fired boiler in power plant instead of the prior mulri - cyclone

    文摘:把具有慣性沉降除塵和多進口旋風子除塵兩級除塵一體的復合多管除塵器用於電廠煤粉鍋爐煙氣除塵，以替換原有的多管旋風除生器。
  5. In water hydrostatic bearing lubrication, however, more accurate research results can be obtained as long as inertia of water flow is considered, because inertia item almost has the same quantitative level as the viscous one

    然而，在水靜壓支承潤滑中，水的流動慣性項幾乎與粘性項具有相同的數量級，對水膜的流速及壓力分佈具有一定的影響，因此應予以考慮，才能得出更加準確的研究結果。
  6. Reciprocating inertia force, 1st order

    一級往復慣性力
  7. Advanced weaponry and new tactical capability and communications combined with an increased weapons load of mark 48 anti - submarine torpedoes, harpoon missiles and tomahawk cruise missiles, which allow seawolf to operate from under arctic ice to shallow water close to shore. the seawolf was a product of the cold war, conceived to maintain the usa acoustic advantage over soviet submarines. with the end of the cold war and the change of emphasis to littoral operations, the cost of the seawolf submarines was judged prohibitive and the programme was curtailed in favour of the smaller and cheaper virginia class new attack submarines

    「海狼」級擁有強大的攻擊力：為了能夠獲得並保持戰場的主動權，該艇裝備有8具660mm魚雷發射管，攜帶的武器有： slam陸攻型戰斧式巡航導彈，射程485海里， ssm反艦型戰斧式巡航導彈，慣性制導主動雷達反輻射制導，航速0 . 7馬赫，射程250海里，魚叉反艦導彈，航速0 . 9馬赫，射程70海里mk48adcap魚雷，直徑660mm ，有線制導，航速55節，射程27海里。
  8. Added with the inertia of class struggle, the instructing thought of cpc went to the wrong way, and the construction cause of socialism was defeated greatly

    再加上傳統階級斗爭思維方式的慣性作用的影響，黨的指導思想逐漸走入迷途，社會主義建設事業遭受巨大挫折。
  9. Dynamic matrix control ( dmc ) can directly treat with objects with pure delay, has strong adaptability to large inertia, approved tracking performance and better robustness, but primary steam temperature object and boiler fuel regulating object are both intricate objects with large inertia and time delay, which are difficult to obtain perfect control effect using routine pid cascade control

    由於動態矩陣控制（ dmc ）能直接處理帶有純滯后的對象，對大慣性有很強的適應能力，有良好的跟蹤性能和較強的魯棒性，而主汽溫對象和鍋爐燃料調節對象均是具有大慣性大延遲的復雜對象，用常規pid串級控制難以取得理想的控制效果。
  10. By analyzing the engine driving torque characteristics and the transmission inertia torque while speed ratio is changed under transient condition, a new synthetic control algorithm is developed which can approach engine target torque by compensating engine output torque with transmission system inertia torque

    通過研究無級變速傳動速比變化時的慣性矩，提出了一種新的控制演算法，採用傳動系的慣性矩來補償發動機的輸出轉矩，以獲取目標驅動轉矩。
  11. Using a special experimental wind tunnel, large number of experiments were carried out to study the resistance and efficiency performance of the inertial stages, he multilayer gauze stages, the two stages and three stages monisture separator. the numerical simulation results were verified

    利用專門的實驗風洞進行慣性級、網墊級、復合兩級以及復合三級濾清器的阻力特性和效率特性的實驗研究，並對數值模擬結果加以驗證。
  12. It is composed of thirteen functin ? components including two 3 - db y - junction power splitter, two directional couplers, two waveguide attenuators and one polarizer of waveguide itself. the prominent feature of the device is that it has a beat detection function with respect to the single y - branch mioc device, and it plays an important role in improving the inertial - grade and the high precision steady - aim system because of the beat detection function. farthermore it has direct influence on the improvement of the high flexibility, shockproof and overload - resistance for the steady - aim system

    器件的工作波長為1 . 3 m ，集分束器、合束器、起偏器/檢偏器、相位調制器、波導吸收器等十三個功能單元於一體，除了單y多功能集成光路器件具備的功能外，它還具有拍頻檢測功能，因而對提高慣導級和高精度穩瞄系統起著重要的作用，並直接影響著穩瞄系統的高機動性、抗沖擊力和過載能力的提高。
  13. Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system. special analysis about simultaneously operating multi - actuators with different inertia loads is made. finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient

    第三章介紹了基於執行器進油側流量反饋的分流控制的原理，並針對大小慣性執行器同時起動時採用該分流控制方法進行了具體分析；最後通過模擬說明該分流控制方法能在大小慣性執行器同時起動並在泵輸出流量不足的情況下有效提高泵輸出流量的利用率，並能實現優先級和分流比混合控制。
  14. The numberical simulating of the flow fields in the two stages and three stages monisture separator. based on the method of numerical simulation of the inertial stages and the multilayer gauze stages, and taking into account the structure of the two stages and three stages monisture separator, making appropriate mathematical model obtained results include the resistance and efficiency performance

    復合兩級、復合三級濾清器流場的數值模擬。以慣性級和網墊級數值模擬方法為基礎，兼顧復合級濾清器的結構特點，建立合適的數學模型，獲得了包括阻力特性和效率特性在內的計算結果； 4
  15. Not only the uniformity of laser energy on the target surface, but also the high uniformity of laser intensity at any time is needed for icf ( inertial confinement fusion ), so power balance is the important stage of the precision upgraded modification to multi - beams high power laser driver

    慣性約束核聚變不僅對輻照靶面的激光能量均衡性而且對任意時刻的功率均衡性都有很高的要求，因此功率平衡是多路激光驅動器精密化升級改造的重要環節。
  16. It needs more manpower and material resources as well as longer experimental period to realize characteristic of the different inertial stages and multilayer gauze stages absolutely by model experimentation, so numerical simulation studying method has important meaning

    完全通過模型實驗來了解不同慣性級和網墊級的特性既耗費較大的人力物力也需要較長的實驗周期，因此，用數值模擬方法進行研究具有重要意義。
  17. Systematic calibration for inertial instruments errors in laser gyro strapdown inertial navigation system

    激光陀螺捷聯慣導系統中慣性器件誤差的系統級標定
  18. Through the model the inverse dynamic problem of stewart platform is solved and a foundation is made for stewart platform control used for 500m lt. meanwhile all the restrained forces acted at joints are found which provide analysis condition for the mechanism design. a simplified resultant force acted on the cabin by stewart platform is given which makes it possible to eliminate the dynamic coupling between the two subsystems by means of active vibration control

    基於newton - euler方法，建立了充分考慮動平臺慣性、支腿慣性、關節摩擦等因素的stewart平臺控制動力學模型，解決了已知動平臺運動規劃，求關節驅動力的動力學逆問題，為準確實現lt500m原型stewart平臺控制奠定了基礎；解出了各關節處的約束反力，為平臺機構設計提供了力分析條件；簡化給出了平臺對饋源艙的反作用力，使得採用振動主動控制技術消除兩級子系統之間的動力耦合成為可能。
  19. The numberical simulating of the flow fields in the inertial stages

    慣性級流場的數值模擬。
  20. After that, on the non - inertial coordinate, the other part flow field, of the complex cylinder, which is composed of three basic flow field, is simulated by the same method as above

    然後，在非慣性坐標系下，對具有兩個動邊界一個定邊界的多級缸上一級流場，採用投影法加變換，在共有邊界上耦合的方法進行求解。
分享友人
分享到 Line

分享到臉書