拉伸剪切試驗 的英文怎麼說
中文拼音 [lāshēnjiǎnqiēshìyàn]
拉伸剪切試驗
英文
tensile shear test- 拉 : 拉構詞成分。
- 伸 : Ⅰ動詞(展開) stretch; extend Ⅱ名詞(姓氏) a surname
- 剪 : Ⅰ名詞1 (剪刀) scissors; shears; clippers2 (姓氏) a surname Ⅱ動詞1 (用剪刀等使細的或薄片的東...
- 切 : 切Ⅰ動詞1 (合; 符合) correspond to; be close to 2 (用在反切后頭 表示前兩個字是注音用的反切)見 ...
- 試 : 名詞(古代占卜用的器具) astrolabe
- 驗 : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
- 試驗 : trial; experiment; test
-
Methods of test for ancillary components for masonry - determination of shear load capacity and load displacement characteristics of shear ties and slip ties couplet test for mortar joint connection
圬工輔助砌塊的試驗方法.剪切桿和滑動桿的拉伸和壓縮負載容量和負載轉移特性的測定Standard test method for thick - adherend metal lap - shear joints for determination of the stress - strain behavior of adhesives in shear by tension loading
拉伸載荷法測定剪切中膠粘劑應力-應變性能用厚被粘物金屬搭接-剪切接頭的標準試驗方法When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set
當膠粘劑中填料為其它物質(未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合)時,通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時,膠粘劑的拉伸剪切強度最高;同時進行了沖蝕磨損試驗,通過比較得出,當膠粘劑塗層中有機化蒙脫土含量達到5時,塗層的耐沖蝕磨損性能最佳,並對沖蝕磨損試樣在掃描電子顯微鏡( set )上進行觀察。The method of creep properties of adhesive in shear by tension loading metal to metal
膠粘劑拉伸剪切蠕變性能試驗方法Adhesives for load - bearing timber structures - test methods - part 1 : determination of bond strength in longitudinal tensile shear strength
承重木構件用粘接材料.試驗方法.第1部分:縱向拉伸剪切強度中粘結強度的測定Standard test method for strength properties of adhesives in two - ply wood construction in shear by tension loading
用拉伸負荷法測定雙層膠合板結構中膠粘劑剪切強度特性的標準試驗方法Testing methods for tensile shear strength of wood - to - wood adhesive bonds
木材和木材膠粘劑粘合點的抗拉伸剪切強度的試驗方法Standard test method for determining the tensile shear strength of pre - fabricated bituminous geomembrane seams
預制瀝青土工薄膜接縫的拉伸剪切強度測定的標準試驗方法Adhesives for load bearing timber structures - test methods - determination of bond strength in longitudinal tensile shear strength
承重木結構用膠粘劑.試驗方法.縱向抗拉伸剪切強度中粘結強度的測定Standard test method for strength properties of tissue adhesives in lap - shear by tension loading
通過拉伸載荷測定搭接剪切狀態下組織粘合劑強度特性的標準試驗方法Methods of tensile and shear tests for brazed joint
硬釬焊接頭抗拉伸及抗剪切試驗方法Simultaneity, various single fiber strength tests ( sft ) and the single fiber fragmentation techniques were discussed, and the influence of fiber surface treatment on the single fiber strength and the interface load - transfer were discussed in detail. the two parameters weibull statistic theory was used to evaluate the scattering of the tensile strength test results of three types of single fibers with different surface treatments. the following conclusions can be drawn based on the analysis of the results
同時,文中詳細討論了單纖維強度測試實驗( sft )和單纖維復合材料斷裂實驗( sfc ) ,重點討論了纖維表面處理對單纖維拉伸強度和界面載荷傳遞能力的影響;採用兩參數weibull統計理論對經過三種不同表面處理的單纖維拉伸強度的測試結果的分散性進行了評價,獲得了理想的實驗結果;分析實驗結果可得到如下結論, sft實驗與sfc實驗獲得的界面剪切強度吻合良好;經過表面處理的玻璃纖維的界面粘結情況較未經處理的玻璃纖維好;經過表面處理的玻璃纖維的界面粘結強度和單纖維拉伸強度均高於未經表面處理的玻璃纖維。Testing methods for in - plane shear properties of carbon fiber reinforced plastics by plus and minus 45 degrees tension method and two pairs of rails method
用加減45度拉伸法和兩對軌法測定碳纖維增強塑料的平面剪切性能的試驗方法Standard test method for strength properties of adhesively bonded plastic lap - shear sandwich joints in shear by tension loading
用拉伸負荷法測定膠粘劑粘接塑料搭接接頭剪切強度特性的標準試驗方法Adhesives. test methods for fatigue properties of structural adhesives in tensile shear
膠粘劑.拉伸剪切結構膠粘劑疲勞性能的試驗方法Adhesives - test methods for fatigue properties of structural adhesives in tensile shear
膠粘劑.拉伸剪切時結構膠粘劑疲勞性能的試驗方法Adhesives - determination of shear behaviour of structural bonds - part 2 : thick - adherent tensile - test method
膠粘劑.結構粘結剪切特性的測定.第2部分:厚度粘結拉伸試驗方法Furthermore, shearing and tension tests were performed on grouted cable assemblies in order to simulate the field situation. compared with direct shear tests on coaxial cable, the experimental data were analyzed and valuable conclusions were proposed on the coming application of tdr technology in slope monitoring
為模擬實際工程情況,對澆築於水泥砂漿填充體中的同軸電纜tdr剪切與拉伸試驗特性進行了研究,總結了tdr波形的變化規律,並將試驗數據與同軸電纜直剪試驗相比較,為tdr技術的實際工程應用提供了依據。Aerospace - fibre reinforced plastics - testing of unidirectional laminates ; determination of shear strength and shear modulus in tension
航空航天.纖維增強塑料.單向層壓製品試驗.拉伸剪切強Iso adhesives - test methods for fatigue properties of structural adhesives in tensile shear iso 9664 : 1993 ; german version en iso 9664 : 1995
粘合劑.拉伸剪切結構粘合劑疲勞性能的試驗方法分享友人