振動進料器 的英文怎麼說

中文拼音 [zhèndòngjìnliàoqì]
振動進料器 英文
oscillating feeder
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 進 : 進構詞成分。
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 振動 : vibrate; vibration; vibrance; vibrancy; vibra; vibes; shaking; rumble; jitter; chatter; sway; jar...
  1. Based on the geophone vibration formula, this paper presents the affective factors to the seismic data from high resolution geophone arrays and its main property specifications, such as natural frequency, damping coefficient, sensitivity, harmonic distortion, and alias

    為此，從檢波器的振動方程出發，對高解析度地震檢波器性能指標（如自頻率、阻尼系數、靈敏度、諧波失真、假頻等）以及檢波器組合的連接方式對地震資料品質的影響進行了分析。
  2. In this thesis, the dynamic models of a specific precise instrument in spacecraft are established and an active vibration isolation system based on piezoelectric intelligent structures is constructed. theoretical analysis and numerical simulation on this system has been carried out. piezoelectric intelligent structure is applied to civil engineering. the piezoelectric intelligent control devise is used for the control of translation - torsion coupling responses of multi - story frame structure suffered from earthquake

    本文還將壓電智能結構主動隔振的理論和控制方法應用到土木工程領域，利用一類壓電材料控制器對平移-扭轉耦聯的框架結構進行了主動隔震，模擬結果顯示：結構各層的平移和扭轉均得到顯著減小，表明將智能結構系統用於結構地震反應主動控制中的可能性。
  3. The resonant characteristics are analyzed using elastic mechanics theory. using fea method, the model of the resonant component is built up and the effects of different beam materials and chip structures on the performance of the chip are studied

    從彈性力學角度對傳感器的特性進行了理論分析；並用有限元方法，建立計算機模型，分析了不同材料、結構對梁的振動和敏感特性的影響。
  4. Piezoceramics have been used successfully for many years in the field of vibration control, owning to its high forces into the range of kilo - newtons and short reaction times in the order of a few microseconds

    壓電材料由於其自身的壓電效應和逆壓電效應而被製作成壓電傳感器和壓電驅動器來對結構的振動進行控制。
  5. According to practical engineering demand in the military field, and after gaining lots of data about transducers oversea and inland, and with conbining the domestic fact, the whole design project of the micro triaxial vibration transduser was presented and demonstrated

    本文以某實際軍事工程項目為背景，在查閱國內外大量傳感器方面資料基礎上，結合國內實際情況，提出了微型三軸振動傳感器的總體設計方案，並對該方案進行了論證。
  6. As an example of 3d program with high quality mesh, proper boundary & initial conditions and ingenious simulation strategy, numerical analysis of flow - fields in hylte nozzle and cavity of dfcl running on fuel system of ( nf3 + h2 + he ) / d2 and experimental stagnation parameters, has been performed using vibration - state - unbalance & rotation - state - balance model, and a detailed kinetic model including 111 one - way primary reactions expressing by finite rate equations between thirteen species. the coefficients of transportation used in the analysis are calculated by employing the formulas of molecular kinetics

    新建立的三維程序在高質量網格、合理的初邊值以及模擬方案基礎上，採用振動非平衡?轉動平衡模型和有限速率方程表達的111個單向基元反應的化學動力學模型，利用分子運動理論計算的輸運系數和工程實驗採用的滯止參數，對運轉（ nf _ 3 + h _ 2 + he ） d _ 2燃料體系的df激光器的hylte噴管和光腔進行了數值模擬分析。
  7. Two kinds of modeling methods, finite element method ( fem ) and experimental identification methods based on modal analysis theory, are applied to get the models of the dynamic systems. using the finite element model for the composite material structures with piezoceramics embedded and the technique to reduce the number of degrees - of - freedom of fem model, a reduced and appropriate model for online control is also introduced

    通過對埋有壓電作動器和壓電傳感器的智能復合材料結構進行有限單元分析，建立起了結構振動的有限單元模型，並介紹了對有限摘要單元模型進行模型降階的方法，使其適合於對結構的振動進行控制。
  8. The early studies are mostly focused on the method of gluing piezoceramics on structural surfaces, which has some disadvantages such as difficulties to protect the ceramics and the connection wires, bad coupling with only one surface glued on the base materials, low signal - to - noise ratio etc. these problems can be solved using the embedded piezoceramics, and furthermore, the piezoceramics can be placed in the optimal positions, especially in the optimal deepness for the piezo - actuators, according to an optimization algorithm befor e they are embedded, so the actuator effects and sensor signals are thereby enhanced

    早期的研究主要集中在表面粘貼壓電片的結構，表面粘貼壓電片具有一些無法克服的缺點。本文著重進行利用埋入復合材料結構的壓電傳感器和壓電驅動器對其振動進行主動控制的相關理論和實驗研究，並介紹其相應結果。埋入型壓電材料的優點主要是能保護壓電傳感器和作動器及其連線、增強壓電材料和基體材料的耦合、優化埋入壓電陶瓷的深度和厚度可增強壓電傳感器的測量信號並提高信噪比等。
  9. In this paper, the mechanics model and computer control method for electromagnetism vibration feeder are studied. the emphases are put on the seeking of optical motion states and the realization of these states by computer control. using labview ( laboratory virtual instrument engineering workbench ), a waveform generator is established to control the electromagnetic force

    本文對電磁振動給料機的力學模型與計算機控製做了比較深入的分析和研究，特別是給料機的力學分析與最佳運動狀態、電磁鐵的一些特性和用labview實現計算機控制，在與傳統的控制方法對照的情況下，建立了對比較周全的力學模型，提出了利用labview程序產生一個波形發生器，經過放大后對電磁鐵進行控制。
  10. Based on the routine test of rockfill, built indoor model experiment of it under the process of vibration compaction, the flat panel vibration machine was used to vibrate and compact the layered rockfill, the level instrument was used to observe the settlement of rockfill after vibration compaction, dynamical soil manometer was used to observe the pressure variety in the rockfill layer

    摘要在進行填石料常規土工試驗的基礎上，建立填石料振動壓實的室內試驗模型，採用平板振動器對填石料分層進行振動壓實，利用水準儀觀測填石料在振動壓實中的沉降量，利用動土壓力計觀測填石層內的壓力變化。
  11. This machine consists of bin, vibration chamber, coupling and motor. the vibration chamber is made up of eccentric wheel. rubber soft piece, main shaft and bearing. the adjustable eccentric hammering is transmitted to the centerline of main shaft by motor drive, and produce centrifugal force at unsteady state so as to change the strength of material and form vortex in the sieve. weghted regulator and amplitude can be adjusted as per different material and sieve mesh

    本機由料斗、振蕩室、聯軸器、電機組成，振蕩電腦內由偏心輪、橡膠軟體、主軸、軸承組成，可調節的偏心重錘經馬達驅動傳到主軸中心線，在不平衡狀態下，產生離心力，使物料強度改變在篩內形成漩渦，重錘調節器和振幅大小可根據不同物料和篩網進行調節。
  12. In experimental, static response and frequency response of coupling acoustic / vibration optic fiber sensor have been analyzed. the results indicate that the response of the sensor to static pressure has high sensitivity. because the resonant frequency of different materials and structure is different, the sensor has maximum sensitivity in specific frequency

    試驗研究中，對耦合型聲振動光纖傳感器的靜態響應特性和頻率響應特性進行了試驗分析，分析結果表明該類型傳感器對應變的響應非常靈敏，而對頻率的響應則由於材料及結構本身的共振頻率的差異有不同的峰值響應頻率。
  13. Abstract : a piezoelectric resonance - conveying machine is developed by using homemade piezoelectric ceramic chips, and the structural parameters of its main parts is optimized and researched. a intelligent and multifunctional power supply to drive resonance - conveying machines is also developed. the piezoelectric resonance - conveying machines are to take the place of resonance - conveying machines with their multinomial fine qualities

    文摘:用國產壓電陶晶片研製出壓電式振動給料器，並對其主要部件結構參數進行了優化研究，還研製出驅動壓電式振動給料器的智能化多功能電源，該壓電式振動給料器由於具有多項優良品質可望成為振動給料器的換代產品。
分享友人
分享到 Line

分享到臉書