排液分離 的英文怎麼說

中文拼音 [bèifēn]
排液分離 英文
lent segregation
  • : 排構詞成分。
  • : 名詞(液體) liquid; fluid; juice
  • : 分Ⅰ名詞1. (成分) component 2. (職責和權利的限度) what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] (料想) judge
  • : Ⅰ動詞1 (離開) leave; part from; be away from; separate 2 (背離) go against 3 (缺少) dispens...
  1. In the first trial, combination of enzymatic digestion was used to prepare suspensions of spermatogenic cells from adult mouse testis, and then a modified discontinuous percoll gradient centrifugation method ( 15 %, 22 %, 30 %, 40 %, 50 %, 60 % ) was introduced to isolate spermatids from the cellular suspensions. the content of spermatids in each isolated fraction by percoll method was determined by morphology ( wright - giemsa stain ) and flow cytometry analysis, and the viability of spermatogenic cells was assessed by using eosin y exclusion test

    在第一部試驗中,首先利用連續3次組合酶消化成年小鼠睪丸制備睪丸細胞懸,然後經6層非連續percoll梯度心法( 15 、 22 、 30 、 40 、 50和60 ),通過形態學和流式細胞術鑒定南京醫科大學碩士學位論文各個percoll組中精子細胞的含量,並以伊紅y斥試驗測定細胞的存活率。
  2. The centrifuge should be run in barite recovery mode with the centrate returned to the reserve pit for flocculating

    用回收重晶石的方式使心機運轉,把二級出的入絮凝池。
  3. 3. a dimensionless parameter i. e. breaking symmetry a is defined which reflects the characteristic of molecular arrangement in non - symmetric lc cell, the expression is where d is the distance between the maximal tilt angle 0m and the below substrate, l is the thickness of lc cell

    定義了一個反映不對稱晶盒列對稱性特點的無量綱量? ?對稱破缺,定義式為= ( d - l / 2 ) / ( l / 2 ) ,其中d為傾角最大值_ m距下基板的距, l為晶盒的厚度。
  4. This machine has high rotational speed, it is based on the common centrifugal separator, its novel design great enhances the speed of lowing the supplies. main applies : this machine is called throw liquid centrifugal separator, is suitable for clarifying drizzle drops of liquid that has floated, now it has been widely applied in the industries of medicine, chemistry and food industry, it can be used to separate materials before the process of the centrifugal separator of pipe type

    該機適用於對固相為顆粒狀的懸浮物的過濾,也可用於纖維及其紡織印染洗滌後有脫水,物料從頂部加入,由專用雙速電機通過三角膠帶,實現低速啟動,高速,使轉鼓形成心力場,相通過固相和濾網由下部出出,固相停機後由上部取出。
  5. ( 3 ) the thickness of the liquid crystal and the arrangement of liquid crystal molecule are flexible, there are no deviation in the outgoing beams

    摘要第2頁3 、濾光片中的晶厚度、子的列方向比較靈活,輸出光束不發生偏
  6. A new type of automatic apocatharsis valve on settling centrifuge device was designed, so that the separation and automatic apocatharsis of the liquid and suspended substance were done continuously

    摘要設計了一種新型的自控閥,來實現沉降裝置中體和懸浮物的連續和自動出。
  7. This paper shows that the valve made the settling centrifuge device a little size, a simple structure, a high efficiency and a continuous work

    設計的自控閥可使懸浮物的裝置結構簡單緊湊,實現高效、可靠的連續作業。
  8. The 16 - member medical team was able to separate the shared system of veins that drained blood from the brothers ' brains

    16人醫療小組能夠這個公用的紋理系統(求助) ,這個系統可以把血從這對兄弟的大腦中
  9. Emission is inducted evenly into the reactor, and effectively interact with recovery solvent sprayed down from top in the filler layer, then passes through the gas and liquid separation system to eliminate moisture for releasing clean air

    廢氣由塔槽底部均勻進入洗滌塔,並在填充層與由上端噴流而下的洗滌作有效的交換洗滌,再經由氣系統去除水氣,清潔的空氣由出口出。
  10. Sg three column manual bottom discharge type of centrifuge by scraper automatically is the basic type of centrifuge for solid liquid separation. it contains basket which is dynamically balanced in which a filter bag is placed which retains the solid within the basket. the arrangement for the discharge of the solid cake is provided at the bottom which is done by scraper automatically

    的懸浮從頂部加料管進入轉鼓,落在布料盤上,在心力的作用下,流向轉鼓壁,相經轉鼓壁上的濾網與濾孔拋向機殼空間,匯集在底盤內,經出,而固相存留在濾布的內側。
  11. Main separation mechanism of high performance liquid chromatography contains absorption, distribution, ion exchange and exclusion function

    高效相色譜法的主要機制有吸附、配、子交換和阻作用。
  12. Through the competition of ionization equilibrium of zno22 - and precipitation reaction, the nucleation and growth process of znse have been adjusted, and monodispersed znse semiconductor hollow microspheres are obtained. these microspheres were found to form through aggregation of small znse nanocrystals sizes of which could be finely tuned by temperature control. a novel gas - liquid interface aggregation mechanism was proposed and this idea might be generalized in other systems

    以zno22 -陰子提供鋅源,利用它在強堿性溶中緩慢釋放出zn2 + ,並與se2 -之間的電荷斥作用,成功地調節了反應動力學,獲得了尺寸和散性都非常均勻的微米級znse空心球,並實現了空心球內部粒子尺寸的調控,提出了新穎的氣界面團聚機理。
  13. Full - stainless stell ; oil - water separator, liquid heating ; auto - matic constant tempertature ; outside - jiint water or air cooler ; solution recobering system to keep the solution clean for a long time ; level auto - control ; fast cooling and drying ; convenient draining ; double protecting debice ; auto - reset function

    全不銹鋼結構,內置油水器,體加熱與自動恆溫,外接冷水機,或冷氣機組,溶劑回收再生,使清洗劑長期清潔,具有位自動控制,快速冷卻乾燥,污方便,雙重保護裝置,自動復位功能。
  14. Automatic drain separator

    自動排液分離
  15. We used the icr and kunming mice and got the embryos of 3. 5dpc by means of superovulation, then cultured the embryos on the feeder layer derived from icr or kunming mice, dispersed the inner cell masses ( icms ) or es cell colony in the appropriate time. in this period, we analized the effects of feeder layer, trypsin and embryos isolated from uteri of different varietal mice on the es cell lines

    以icr小鼠和昆明小鼠為實驗對象,採用超數卵的方法獲得小鼠胚胎,培養在用絲裂黴素c處理過的icr小鼠和昆明小鼠mef細胞飼養層上,選取適當時間散增殖的icm和類es細胞集落,析了在小鼠es細胞建系過程中,飼養層細胞、消化及不同品系來源的胚胎的影響。
  16. Let the air dissolve for over 2 minutes. after the pressurized saturated liquid is fully mixed with the wastewater in the stagnant mixer, discharge the mixture into the floatation tank for solid and liquid separation and achieve the goal of grease and waste removal

    鐘以上,經加壓之飽和污水于靜態攪拌管中與待處理之污水充混合後入浮除槽進行固,而達到去除油脂或其他污物之目的。
  17. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗,得出式熱管有一最佳充率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對式熱管的凝結換熱僅影響冷凝段下部較小部,通過氣閥出不凝性氣體可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性氣體對式熱管冷凝段的影響減少.這些結論可用於式熱管換熱器的工程設計和控制
  18. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空氣冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗,得出式熱管有一最佳充率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對式熱管的凝結換熱僅影響冷凝段下部較小部,通過氣閥出不凝性氣體可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性氣體對式熱管冷凝段的影響減少.這些結論可用於式熱管換熱器的工程設計和控制
  19. It is angry to block the petroleum in the petroleum trade, the oil - polluted water is filtered ; firm liquid separating, gas purifying, noise elimination of the noise that water treatment and various kinds of exhaust in pharmacy, food, making, environmental protection, electron trade, dust removal of high - temperature exhaust gas, etc

    在石油行業中對石油攔生氣含油污水過濾在制藥食品釀造環保電子行業中的固氣體凈化水處理及各種氣噪聲的消聲,高溫煙氣除塵等設備中。
分享友人