排液閥 的英文怎麼說
中文拼音 [bèiyèfá]
排液閥
英文
drain valve-
The rundown of stripper bottom product is by level control acting on the fractionator furnace pass control valves
汽提塔底產品的排出由液位控制，該液位控制調控分餾塔加熱爐通道控制閥。The factory is specialized in the manufacture of the whole set of testing equipment fo gas - vase ( do not sew, fuse, liquefied petroleum gas, natural gas etc. spirit bottle ), various air infuses set, remitting to flow row and to infuse tongs ; the stainless steel is four fluorine soft tubes, the industrial air ( the pack ) gathers to pack, modernizing industrial factory premises concentration to provide spirit system and assisting a piece : decompression machine, safe valve, allotment box ; and standard air, hybrid air, special kind air, high install craft device purely and gaseously ; the automation cuts over, going together with to compare to equip automatically ; various air valve door and accessories, spirit bottle enclosure ; the low temperature equipments liquid pump ; vaporize a machine ; the low temperature closes valve ; the ripples takes care of to wait a series product
本廠專業設計生產製造各種氣瓶檢驗成套設備（無縫，溶解，乙炔，液化石油氣，天然氣等氣瓶） ，各種氣體充灌臺，匯流排及充灌夾具;不銹鋼四氟軟管，工業氣體（充裝）集裝箱，現代化工業廠房集中供氣系統及輔件:減壓器，安全閥，分配箱;以及標準氣體，混合氣體，特種氣體，高純氣體的配置工藝裝置;自動化切換，自動配比裝置;各種氣體閥門及配件，氣瓶附件;低溫設備液體泵;汽化器;低溫截止閥;波紋管等系列產品The telescopic butterfly valve can be used as closing and throttling units on pipline with such media, as all kinds of corrsive and incorrosive gases, liquids semifluid and solid powder in them with belong to the system of petroleum, chemical, textile, shipbuilding, and metallurgic industries, of food medicine and paper manufactures, and of water and electricity, water supply and drainag and energy servies
本蝶閥適用於石油、化工、給排水、食品、醫藥、冶金、造紙、電站、煤氣、通風、供熱、環保、船舶、能源等工業系統一切腐蝕和非腐蝕性氣體、液體、半流體和固體粉末的管路上作接流和調節用。Air vacuuming : to turn two stop - valves of solar panel loose completely to allow air to expel from low - pressure tripe - pipe - valve of outdoor parts
排除空氣，要將太陽能集熱轉換器上的兩個截止閥完全打開。從室外機組的低壓三通閥的加液口排出空氣。Hydraulically actuated exhaust valve mechanism
液力致動排氣閥機構Side drain vent valve at the under part of flanged
法蘭側面排氣排液閥在下部Side drain vent valve at the under part of flange
法蘭側面排氣排液閥在下部Drain vent valve at the face of flanged back
排氣排液閥在法蘭後部端面Side drain vent valve on the top of flanged
法蘭側面排氣排液閥在上部Drain vent valve at the face of flange back
排氣排液閥在法蘭後部端面Side drain vent valve on the top of flange
法蘭側面排氣排液閥在上部Side drain vent valve under of the flange
法蘭側面排氣排液閥在下部Water shutoff agent dsz - a is composed of inorganic particle. its specialities are low cost, easily flow, high strength and long valid period. the agent suits non - selective water shutoff in sand formation. dsz - a not only can plug high water - bearing formation, but also can plug case leakage. dsz - a has been applied on site and gotten good effect. it is a agent which has wide prospect
井下護泵除砂裝置主要用於產液氣量高，出砂能力大，利用常規裝置、常規方法很難治理的井.它的設計是建立在丟手封隔器卡封的基礎上，將液體攜砂能力由地層進入泵管轉變為先過濾（雙層激光割縫篩管部分） ，再在除砂器內靜態沉澱、由單流閥排入井底等一系列除砂護泵優點.本文著重介紹了井下護泵除砂裝置的工作原理與應用情況A new type of automatic apocatharsis valve on settling centrifuge device was designed, so that the separation and automatic apocatharsis of the liquid and suspended substance were done continuously
摘要設計了一種新型的自控排液閥，來實現沉降離心分離裝置中液體和懸浮物的連續分離和自動排出。This paper shows that the valve made the settling centrifuge device a little size, a simple structure, a high efficiency and a continuous work
設計的自控排液閥可使懸浮物的分離裝置結構簡單緊湊，實現高效、可靠的連續作業。Model and suffix codes e. g. hgssty - 1702m1b3d2e1g2f22 01mpa means : high intelligence mode digital sensor. whith linear indicator, pipe curving bracket, liquid discharge valve down. general cable connector, sensor connector uses the welded pipe connector, construction material all adopts 316 stainless steel, measuring range of 01mpa means the pressure of gauge
型號選型舉例如下： hgssty - 1702m1b3d2e1g2f22 01mpa ，表示高級智能型全數字傳感器帶線性指示表頭管裝彎支架排液閥在下部，普通電纜接頭傳感器接頭採用焊管接頭結構材料採用316l不銹鋼量程為0 mpa表壓壓力。Liquid cylinders designed to dispense gaseous oxygen have valves equipped with standard compressed gas association ( cga ) outlets
設計用來輸出氣態氧的液體鋼瓶上裝有配有標準的壓縮氣體協會排氣口的閥門。Drain vent valve
排氣排液閥The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure
建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure
文摘:建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制分享友人