接觸液 的英文怎麼說

中文拼音 [jiēchù]
接觸液 英文
contact fluid
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • : 名詞(液體) liquid; fluid; juice
  • 接觸 : 1. (交往) come into contact with; get in touch with 2. (沖突) engage 3. (挨上; 碰著) contact; touch
  1. Test methods for primary wound dressing - part 1 : aspects of absorbency

    性創面敷料試驗方法.第1部分:體吸收性
  2. Test method for stress crazing of acrylic plastics in contact with liquid or semi - liquid compounds

    丙烯塑料在與態或半態化合物中產生的應力裂紋的試驗方法
  3. Animalcules could never appear unless new air somehow entered the flask and came in contact with the infusion.

    除非有新的空氣進入容器並與汁,微小動物就絕不可能出現。
  4. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先,對體介質的靜電霧化機理作了初步的探討,理論上分析了體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對體荷電方法進行了研究分析,對于高電導率的體,場致荷電和荷電可以使其霧化,而對于電導率較低的絕緣體,需用浸潤電極荷電和感應荷電方法使其充分帶電;最後,根據前面的研究分析,設計和組裝試驗裝置,在同一環境下對煤油、乳化劑、酒精三種不同體介質進行高壓靜電霧化試驗,並對試驗結果進行分析處理,總結出體靜電霧化與體表面張力、電導率和粘度的關系及電壓對體靜電霧化的影響等,得出高壓靜電場中體霧化的一般規律。
  5. 4. when the chloramines disinfection water is combined with the liquid chlorine disinfection water and reaches some stable ratio for a long time, the great reduction of the remained and total chlorines in the piped system will be obtained

    4 、氯胺消毒處理后的水與氯消毒后的水在管網中混合達到一定比例,長時間穩定,將會出現管網水余氯、總氯大幅度降低的現象。
  6. The cause that it produces is to there exist a thin layer in the surface that liquid and the gas contact, to be called a surface layer, molecule inside the surface layer is more sparse than the inside of liquid, molecule room distance is a few bigger than the inside of liquid, molecule room coactions shows for the gravitation

    它產生的原因是體跟氣體的表面存在一個薄層,叫做表面層,表面層里的分子比體內部稀疏,分子間的距離比體內部大一些,分子間的相互作用表現為引力。
  7. Blood coagulates when it meets air

    空氣就會凝結。
  8. Depressed of spirit of prodromal stage expression, happy event is afraid of light is dark, unresponsive, do not listen to host to call, do not wish to contact a person, appetite abnormality, happy event bite take a foreign matter, deglutition crane is difficult, salivary grow in quantity, hind drive is faint, pupil comes loose big

    前驅期表現精神沉鬱、怕光喜暗,反應遲鈍,不聽主人呼喚,不願人,食慾反常,喜咬吃異物,吞咽伸頸困難,唾增多,后驅無力,瞳孔散大。
  9. Laiwu hydrothermal metasomatic iron deposit is located at contact zone of ordovician carbon - ate rock ( majiagou formation ) and late yanshanian diorite or nearby

    摘要萊蕪交代熱鐵礦賦存於奧陶系馬家溝組碳酸鹽巖與燕山晚期閃長巖的帶及其附近。
  10. The liquid surface is not distorted upon contact with the solid.

    體與固體體表面不受干擾。
  11. Most author agree that they include interactions at the contact of solid particles and electrolytic solution which exist in the ground.

    大多數作者認為,它們包括了地層中固體顆粒與電解質溶面上所發生的相互作用。
  12. To avoid contact with sick or dead animals and their excreta or body fluid

    避免染病或死去的動物,及他們的排泄物或體
  13. It could be used for simulating study in aeronautical weapon. there is a set of hold - range transfer mechanism and friction drive system in the equipment. it also used a set of hydraulic system to drive the equip in right position for multiple parameters detecting and made extrusion stress in limited range

    在裝置中,採用了同步帶傳動機構及摩擦驅動裝置,並採用了制系統進行驅動檢測參數要求的換位和摩擦輪的壓力調節,保證了檢測裝置的正確位置和摩擦輪正壓力的有效工作范圍。
  14. Polyvinyl chloride and polyvinyl chloride can resist to be oxidized. soapnated cellulose acetate can prevent dissolved ferrate ( vi ) penetrating toward the anode and prevent dissolved cathode ' s discharge products penetrating toward the cathode

    ( 1 )壓製成型的正極經過相同的存放時間,不與電情況下k _ 2feo _ 4的分解比例,比與電情況的小。
  15. Ehl of line - contacted spherical bearing pair in hydraulic motors

    壓馬達線球鉸副的彈流分析
  16. Wetted parts : all austenitic stainless steel and stellite 6

    接觸液體的部件:奧氏體不銹鋼和鎢鉻鈷合金6 。
  17. Pump touch with the liquid part is the fluorine plastics, but crust is metal stuff, so the pumpbody is enough to support the weight of pipepad and repel mechanically concussion. imd multilevel magnetic force pumps is electrical engine direct link pattern, by centernog prop up, teardown and maintenance is convenient, the structure is tightly, safety and economize energy, one man can put up check - fixing the part inside and replace it easily, consumedly convenient the usual maintain of customers work

    接觸液體部分是氟塑料,但外殼是金屬材料,故泵體足以承受管道的重量及抵受機械性沖擊。 imd系列磁力泵為電機直聯式,由中間支架支撐,安裝拆卸方便,結構緊湊安全節能,一人便可以輕松的進行內部檢修和零件更換,大大方便了用戶日常的維護保養工作。
  18. Standing form centrifugal pump of long axis, the parts of touching liquid all made of fluorine plastics alloy to press, it has trait of broad bound of resisting causticity high efficiency ethereal weight and can transport neednt to fill liquid expediently maintain etc

    長軸立式離心泵,其接觸液體部分全部由氟塑料合金模壓成型工藝製造,具有耐腐蝕范圍廣效率高重量輕,不需灌即能抽送維修方便等特點。
  19. Fyh fluorine plastics alloy below liquid pump is standing form centrifugal pump of long axis, the parts of touching liquid all made of fluorine plastics alloy to press, it has trait of broad bound of resisting causticity high efficiency ethereal weight and can transport neednt to fill liquid expediently maintain etc

    Fyh型氟塑料合金下泵是長軸立式離心泵,其接觸液體部分全部由氟塑料合金模壓成型工藝製造,具有耐腐蝕范圍廣效率高重量輕,不需灌即能抽送維修方便等特點。
  20. Pump touch with the liquid part is the fluorine plastics, but crust is metal stuff, so the pumpbody is enough to support the weight of pipepad and repel mechanically concussion

    接觸液體部分是氟塑料,但泵外殼是金屬材料,故泵體足以承受管道的重量及抵受機械性沖擊。
分享友人