換算參數 的英文怎麼說

中文拼音 [huànsuànshēnshǔ]
換算參數 英文
reduced parameter
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 參 : 參構詞成分。
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 換算 : [數學] matrixing; scaler; conversion; convert; translation換算表 conversion table; equivalent tab...
  1. Advances in study of hydraulic characteristic parameter conversion for low - lift pumping devices

    低揚程水泵裝置水力特性參數換算研究綜述
  2. Second, the paper in - depth discuss the reinforce foundation operation mechanism of technique of composite grouting, including spray incise action of high pressure spray flow to soil, mill metathesis concretion action, and penetrate, split, crush action of serum to soil, etc. third, the paper in - depth study design calculate of composite grouting, design of composite grouting technic parameter

    其次，本文對復合注漿法加固地基的作用機理進行了深入的探討，包括高壓噴射流對土體的噴射切割作用、漿液與土的攪拌置換固結作用以及漿液對土體的滲透、劈裂、擠密作用等問題。第三，本文對復合注漿的設計計算、注漿技術參數的設計進行了深入的研究。
  3. Based on the refrigerant state, divides a heat exchanger into three zones with zoned lump method, i. e. superheat, two - phase and subcooling zones, works out the temperature difference and heat transfer coefficients of the three zones

    採用分區參數法將換熱器按製冷劑狀態分為過熱、兩相、過冷三區，分別計算了各區的換熱溫差、傳熱系數等。
  4. Because geometry of formation of two satellites is very weak, the solution covariance is very big and unstable in order to resolve this problem, the measurement model was transformed from cartesian coordinate system to sphere coordinate system

    由於雙星編隊星座觀測的幾何結構弱，所以解算參數的協方差不穩定。為了解決這一問題，對測量方程進行球坐標變換。
  5. Based on a systematic discussion on the contents, characteristics and the up - to - now accomplishments of these three operations in cagd, we present our researches in three ways as follows : ( 1 ) efficient evaluation for parametric curves and surfaces based on generalized ball bases based on the generalization of mathematical model of surface lofting program in the consurf system, two generalized ball surfaces and the recursive algorithms for evaluating them are given. furthermore, the conversion algorithms from bezier form of a surface to these two generalized ball forms are presented

    在系統地論述cagd中此三類運算的內容、特點、已有研究成果的基礎上，就以下三方面給出了研究成果： （ 1 ）基於廣義ball基的參數曲線曲面快速求值以前英國航空公司consurf系統機身模線程序數學模型的推廣為基礎，定義了兩類廣義ball基曲面，給出了求值的遞推演算法，推導了b zier曲面到這兩類曲面的轉換演算法
  6. It should be found that in sphere coordinate system the solution covariance is stable and can be used to a simulation / covariance analysis

    經過這種變換后，解算參數的協方差是穩定的，可進行模擬協方差分析。
  7. Based on the fem program on fracture of plane structure developed by professor fu xiaoling of ho hai university, a two demension damage and fracture finite program package which is programed in fortran 90 language is developed. the paper adopts the plane - eight - nodes isoparameters element and compute the developing law of the damage and macro - damage of plane structure under load. considering the original damage and tension and compression damage at the same time, the paper adopts the more reasonable concrete constitute relation of two demension and exponent function model

    在河海大學符曉陵副教授所編制的平面結構斷裂有限元程序（ dl08p4 ）基礎之上，本文用fortran90語言編制的二維損傷-斷裂有限元程序包，程序採用平面八結點等參數單元分析計算平面結構在外荷載作用下損傷及宏觀裂縫的發展規律，考慮了混凝土結構體內存在著初始損傷和同時存在的拉、壓損傷，並且採用更為合理的具有損傷含義的混凝土二維本構關系（即正交異性損傷模型中的本構方程）和指數函數模型建立的並可進行拉、壓損傷可比性換算的損傷演變方程，較為真實地反映了實際情況。
  8. Set up a model for lfm signal detection and parameter estimation on the basis of realization of the digital computation of discrete fractional fourier transform 4

    3 .在分數階fourier變換離散數值計算實現的基礎上，建立了lfm信號的檢測與參數估計系統模型，並模擬實現。
  9. By means of laboratory and field experimentation of typical semi - rigid base materials, the relationships among laboratory experimental values, field maintain values, field core values and construction criteria are put forward. and the relationships between different test methods are established. using time - temperature conversion principle, it processes the intensity assessment of field cores, then offers the method of determining the test deflection of pavement surface

    通過典型半剛性基層材料的室內外試驗，研究主要設計參數的室內試驗值、野外養生值、現場取芯值及施工指標間的關系，建立了不同試驗方法間的相關關系，運用時溫換演算法則，對現場芯樣進行強度評定，並提出了路表彎沉檢測標準的確定方法。
  10. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  11. This paper discussed the coordinate transformation method of wgs84 coordinate system to 1954 - beijing gauss grid coordinate. introduced transformation model of wgs84 to beijing 54 and computing method of transformation parameter. according to different model and computing method, computed and compared with the result combine real data

    本文詳細討論了wgs84大地坐標轉換到北京54坐標系下的高斯平面坐標的方法，重點介紹了wgs84和北京54的空間直角坐標的轉換模型及轉換參數的計算方法，並根據不同的模型和計算方法結合實際數據進行計算和結果的比較，認為採用基線向量求解的四參數模型具有較高的轉換精度，分區變換和提高控制點精度也能提高轉換的精度。
  12. The paper analyses the advantages and disadvantages of a large number of harmonic analysis methods and puts forward to a new algorithm in order to improve precision of fft, which is plural list and interpolating windowed split - radix fft ( srfft ). the simulating result shows that the algorithm can meet precision of harmonic parameters

    為了提高fft的精度，本文在分析目前國內外各種諧波分析及測量方法利弊的基礎上，提出了利用復序列加窗插值分裂基快速傅立葉變換（ srfft ） 。該演算法能極大地提高fft計算的精度，從而滿足諧波測量中對諧波參數的精度要求。
  13. Their size parameters, the largest probability of a successful impersonation attack and the largest probability of a successful substitution attack are computed ; chapter three use sympletic geometry to construct authentication codes with arbitration, some parameters and the largest probability of successful attack are also computed ; chapter four is about lattices generated by transitive sets of subalgebras under finite chevalley groups

    並計算了相關參數及成功偽造和成功替換的最大概率；第三章在辛幾何的基礎上構造了具有仲裁的認證碼，亦計算了相關參數及各種攻擊成功的最大概率；第四章討論了有限域上chevalley群作用下的子代數軌道生成的格。
  14. Based on the current jiangmen independent coordinate system and the method of coordinate transformation, this paper analyzes and resolves the coordinate transformation between jiangmen independent coordinate system and beijing geodetic coordinate system 1954 using 10 - parameters orthomorphic map projection transformation formula, then validates the results of coordinate transformation and analyzes the precision

    摘要以現有江門獨立坐標系及坐標轉換公式著手，分析了江門獨立坐標系與54北京坐標的相互轉換，提出了10參數正形變換方法，並進行了轉換計算結果驗證及精度分析。
  15. In the selective calculation module, the calculations of heat exchanger design, the analysis of pipe setting patterns are combined with the database so that the selective calculation sub - system is developed. considering the factors such as uniform flowing of the fluid, smaller inner radius of the shell, the well heat exchanging effect and saving materials, the pipe setting module is developed based on the designing data. in the module for automatically generating parts and assembly drawings, the database of pattern sizes and the drawing libraries are established according to the classifications and series

    在選型計算模塊中，通過換熱器設計計算、管束組件的布管方式分析、數據庫的檢索，開發了浮頭式換熱器輔助設計計運算元系統；在布管定型模塊中，按照確保殼程流體流動均勻、且換熱器殼體的內徑較小、管程殼程間換熱良好且節省材料的原則，根據設計計算參數建立了自動布管定型系統；在零部件圖和裝配圖自動生成模塊中，分級分類地開發了浮頭式換熱器所有零部件圖和裝配圖的圖紙尺寸數據庫和圖庫，運用「死圖活尺寸」的開發理念，開發了圖形自動生成與管束參數化設計的集成系統。
  16. The | operator yields the bitwise ( inclusive ) or of its arguments, which must be plain or long integers. the arguments are converted to a common type

    運算符進行比特級的or （同或）運算，參數必須是普通整數或長整數.參數轉換成通用類型
  17. The ^ operator yields the bitwise xor ( exclusive or ) of its arguments, which must be plain or long integers. the arguments are converted to a common type

    運算符進行比特級的xor （異或）運算，參數必須是普通整數或長整數.參數轉換成通用類型
  18. The - ( subtraction ) operator yields the difference of its arguments. the numeric arguments are first converted to a common type

    減）計算參數的差，數值型的參數首先轉換成通用類型
  19. Plentiful simulations are presents and discussed. in the third chapter, a modified radon - wigner transform algorithm with two - step searching and clean method is proposed, which is used in radar multi - target resolving and parameter estimation

    首先分析了基於radon - wigner變換的參數估計原理，提出了變尺度兩級搜索演算法，並應用頻域信號分離技術，對原radon - wigner變換改進，並進行了模擬。
  20. The embedding template in algorithm allows identifying both the transformation parameters and translation coordinates, so that can estimate distortions and maximize watermark recovery effectiveness

    演算法中的嵌入模板既可以標識變換的參數，也可以標識移動的坐標，以便於評估幾何失真程度和提高水印恢復的效率。
分享友人
分享到 Line

分享到臉書