撓性試驗 的英文怎麼說
中文拼音 [náoxìngshìyàn]
撓性試驗
英文
flexion test- 撓 : 動詞1. (輕輕地抓) scratch 2. (擾亂;阻止) hinder 3. (彎曲,比喻屈服)yield;flinch:不屈不撓indomitable; unyielding
- 性 : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
- 試 : 名詞(古代占卜用的器具) astrolabe
- 驗 : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
- 試驗 : trial; experiment; test
-
Rubber vulcanized. determination of temperature rise and resistance to fatigue in compression flexometer testing
硫化橡膠.用壓力撓度計試驗時對溫升和抗疲勞性能的測定Rubber, vulcanized and thermoplastic - determination of temperature rise and resistance to fatigue in flexometer testing
硫化和熱塑橡膠.撓度計試驗中溫度上升和抗疲勞性的測定Leather - physical and mechanical tests - determination of flex resistance by flexometer method iso 5402 : 2002 ; german version en iso 5402 : 2002
皮革.物理和機械試驗.用撓曲計測定耐曲撓性Abstract : making use of test data and some instances presented in test, it could be apprvoed that partial resonant vibrations of acoustics system occurred in ultrasonic hoing. meanwhile, it was pointed out in this paper that flexible pole - oilstone holder could be considered as a single vibrations system when designing acoustics subsystem, as pioneers a new in designing acoustics system of ultrasonic honing
文摘:經試驗證實了超聲珩磨聲學系統中存在著局部共振現象,指出「撓性桿-油石座」振動子系統設計時可作為一個單獨的振動體系進行考慮,為超聲珩磨聲學系統設計開辟了一條新的思路。Standard test methods for measurement of hydraulic conductivity of saturated porous materials using a flexible wall permeameter
使用撓性壁滲透計測量飽和滲透性材料水滲導性的標準試驗方法Meanwhile, according to the reduced theoretic of the open - web truss, the strength simplification computational method are proposed, and in comparison of the theoretical calculating value with the tested one and the behavior analysis of the tested beams during the process, the hypothesis and the theory of the beam are verified and the stress distribution of the circular hole castellated beam is also obtained
通過費氏空腹桁架簡化計算理論值與實測值的對比分析以及對試驗梁在試驗過程中的性態分析,驗證了理論計算及各項假設的正確性,分析得出圓孔蜂窩梁圓孔周邊應力分佈特徵;並通過撓度分析,提出了實用的簡化計算式。Methods of test for adhesives - physical tests on hot - melt adhesives - determination of low temperature flexibility or cold crack temperature
粘合劑試驗方法.第h2部分:熱熔粘合劑物理試驗.低溫撓性及冷爆裂溫度測定The research shows that : 1 ) the ductility of the hsc bending members constructed is much greater than 5 ; 2 ) increasing the vertical links and distribution steel can increase the deflection under ultimate moment ; 3 ) with appropriate compressive bars, vertical links and distribution steel the increase of moment after yield and the decrease of moment under ultimate moment can be ignored, so the ductility of the hsc bending member is much larger ; 3 ) the width / depth ratio of hsc bending member has no obvious effect on the ultimate compressive strain of concrete ; 4 ) the method used here to calculate the deflection is applicable ; 5 ) the location of crack coincides with the location of vertical links and distribution steel ; 6 ) the bending property of the hsc structure under the blast load can meet the demand of protective engineering
研究表明:本文研究的梁、板構件的延性比遠大於5 ;增加箍筋(鉤筋、分佈筋)含量,可以提高壓區混凝土剝落時的撓度;在適當的受壓筋、箍筋(鉤筋、分佈筋)含量下,可以忽略壓區混凝土剝落瞬間的承載力下降,從而大大提高構件的延性;受彎構件的寬高比對壓區混凝土極限應變的影響不明顯;受彎構件的裂縫間距受箍筋(鉤筋、分佈筋)的布置影響;文中所用的承載力和變形計算方法是可行的。化爆試驗表明,高強混凝土構件的動載抗彎性能能夠滿足防護結構的要求。Test method for deflection of resilient floor tile
彈性地板磚撓曲性試驗方法Standard test methods for flexivity of thermostat metals
恆溫金屬撓性的標準試驗方法Packaging testing - integral test method for packagings made of films or foils for leakage using a flexible test chamber with tracer gas
包裝材料試驗.用有示蹤氣體的撓性試驗室對薄膜或箔制Tests relating to pavements. determination of the mechanical characteristics on material bound with hydraulic binders. part 4 : flexural test
路面試驗.水硬性粘結劑材料的機械性能測定.第4部分:撓性試驗Standard test methods for rubber property - stiffening at low temperatures flexible polymers and coated fabrics
橡膠特性試驗.低溫下加勁撓性聚合物和塗層織物的標準試驗方法Agricultural drainage. corrugated unplasticized pvc pipes. flexibility test
農田排水.未增塑聚氯乙烯圓管.撓性試驗Rubber and plastics hoses - sub - ambiant temperature flexibility tests
橡膠和塑料軟管.亞環境溫度撓性試驗Cellular plastics, rigid - flexural tests - part 2 : determination of flexural properties
硬質泡沫塑料.撓曲試驗.第2部分:撓曲性能的測定Aerospace series. glass fibre reinforced plastics. flexural test. three point bend method
航空航天系列.玻璃纖維增強塑料.撓性試驗.三點彎曲試驗法Plastics piping systems - joints for glass - reinforced thermosetting plastics pipes and fittings - test methods for leaktightness and resistance to damage of flexible and reduced - articulation joints
塑料管道系統.玻璃增強的熱固塑料管和配件.撓性和還原接合接頭密封性和耐損傷性試驗方法The tensile tests of rebar and bend tests of armor plates show that the produced fbgs have very good strain sensing attributes. the developed strain sensors using fbgs have good linearity, coincidence and high sensitivity
通過鋼筋拉伸和鋼板撓曲試驗,說明所製作的光柵具有良好應變反應特性,利用光纖光柵所製作的應變傳感器具有非常好的線性、一致性及非常高的靈敏度。Conveyor belts - transverse flexibility and troughability - test method
傳送帶.橫向撓性和可成槽形性.試驗方法分享友人