放大器輸出 的英文怎麼說

中文拼音 [fàngdàqìshūchū]
放大器輸出 英文
amplifier output
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. Part of the output of an amplifier can be fed back to get rid of sound distortion.

    放大器部分輸出可以進行反饋以消除聲音的失真。
  2. A facsimile of the original amplifier outputs is then reconstructed inside the computer.

    一個放大器原來輸出的復製品就送到處理裝置中去。
  3. The system cybernation method is distributed control system. in this way, the audio process computer switch the signal between input and output channels. the main function of audio process computer is general broadcast, service broadcast and emergency broadcast. there is a special control computer. it " s main function is supervise - control the system status such as the amplifier and speaker circuit

    在控制上，採用了分散式控制方式，由語音計算機進行音源輸入和輸出的切換，執行業務性廣播、服務性廣播和火災事故緊急廣播；由控制計算機進行系統的監控，監視功率放大器和揚聲器迴路的工作狀態，並根據當前的設備狀態執行相應的控制任務。
  4. Again call the the ratio, namely the electric voltage of the enlarger s exportation signal with at the same time output s voice ratio for electric voltage, usually use the decibel number to mean. the equipments s letter the ratio is more our output of high enunciation is more little. by any large, letter the ratio is more big, and the elucidation is in the in the signal a the quantity for more smallly, voice returning putting is more high, otherwise contrary. letter the ratio should be generally not lower than 70 dbs, high the letter of the true box the ratio should attain 110 dbs are above

    又稱為訊噪比，即放大器的輸出信號的電壓與同時輸出的噪聲電壓的比，常常用分貝數表示。設備的信噪比越高表明它產生的雜音越少。一般來說，信噪比越大，說明混在信號里的噪聲越小，聲音回放的音質量越高，否則相反。
  5. If the node is at, or near to, ground then a grounded guard ring will be appropriate, if it is at some other potential it may be necessary to use a high input impedance buffer amplifier, with its input connected to the node, to force the guard ring to the node potential

    如果被保護的節點的電位是（或接近）零電位，採用地線保護環最為合適；如果節點電位是其他值，那麼可以用高輸入阻抗放大器組成緩沖器，輸入端連接該節點，輸出端連接保護環。
  6. Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit

    延遲線振蕩器由寬帶放大器、可調衰減器和聲表面波質量傳感器件構成。延遲線振蕩器輸出信號經濾波后與109mhz的本機晶體振蕩器輸出信號相混頻，通過低通濾波取其差頻，並經整形後由數字信號處理電路處理。
  7. With the stringent requirement of low output voltage and high output current, semiconductor diode is necessarily replaced by synchronous rectifier to minimum voltage drop. because the existed driving schemes can not drive srs properly, two novel driving schemes for synchronous rectifiers in magnetic amplifier post regulating circuit are proposed in this paper

    已有的同步整流管驅動電路主要面對多路輸出的主輸出電路，而應用磁放大器調節的輔助輸出電路同步整流管的驅動，現有的方法存在磁放大器調節與同步整流管驅動的失配，降低了開關電源的效率。
  8. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  9. The power ’ s quality is decided in the system performance, the amplifier has 4 groups ’ power sources, input 220v through the filter, the transformer transformation, the full - wave rectification, finally through manostat leveling off voltage, after the electric capacity filter outputs

    電源質量的好壞是決定系統性能的一個重要因素，放大器共4路電源，輸入220v通過型濾波，變壓器變壓，全波整流，最後通過三端穩壓器穩壓，電容濾波后輸出。
  10. Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively

    其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。
  11. D / a conversion chip and isolation amplifiers are used to obtain the comparative levels required by isolation channels, which could be set with actual requirement ; it can enhance flexibility of the module. otherwise, four - channel isolation signal sources are exported using d / a conversion chip and isolation amplifiers as well

    另外還利用d / a轉換晶元和隔離運算放大器輸出四路隔離信號源，該隔離信號源能與隔離比較電平通過繼電器進行程式控制切換，這樣擴展了該計數器模塊的功能。
  12. According to the eer theory, using the amplified envelope signal as the power supply of the class - d amplifier, the envelope will modulate the magnitude of the rf signal. the modulated impulse rf signal is added to the impedance match circuit, so the amplified am signal is achieved

    將放大的包絡信號作為class - d載頻放大器的電源，根據eer原理， class - d載頻放大器輸出載頻信號的幅度將受到包絡信號的線性調制，達到同時實現對載頻信號的放大和am調制的目的。
  13. A gradual change in the output of a circuit or amplifier

    電路或放大器輸出功率的逐漸改變
  14. The synchronous rectifying and low power sampling technology is used to reduce the power consumption, flexible external loop compensation, error amplifier output clamp are adopted for better system large signal response. the piecewise slope compensation technology is employed to minimize the consequence of over compensation. the sensor resistor is externally connected, which realize output voltage programmable. the overheat protection and under voltage protection modules are integrated in the die to allow the reliable operation of the system

    同時，電路設計採用同步整流技術、低功耗電流采樣技術降低功耗，提高轉換效率;採用靈活的外部環路補償技術、誤差放大器輸出嵌位技術以實現良好大信號特性;採用分段斜坡補償技術，消除不穩定因素，並最大程度地減小過補償帶來的問題;採用外接輸出采樣電阻的方式，實現輸出電壓的可編程。
  15. Characteristic study of output cavity in gyroklystron amplifier

    迴旋速調管放大器輸出腔的特性研究
  16. Third, rail - to - rail amplifier output stages exhibit load - dependent gain which affects amplifier open - loop gain, and hence closed - loop gain accuracy

    第三，軌到軌放大器輸出級增益與負載有關，這將影響放大器的開環增益，當然也影響了閉環增益的準確性。
  17. In the diagram, the output of the error amp is connected to the base of an npn transistor : when the error amp drives current into this transistor ' s base, it allows current to flow from collector to emitter, and that transistor in turn pulls current from the base of the pass transistor

    在這個圖里，誤差放大器的輸出端連接到了一個npn三極體的基極上：當誤差放大器輸出電流到了三極體的基極上，三極體允許電流從集電極向發射極流動，這個傳輸三極體工作時就是就是從基極吸取電流的過程。
  18. We expatiate on the theory of ccd from the physical base and point out the different theory of ccd engendering noise. we describe the mathematic model of ccd output noise by correlation theory and analyze the noise quantificationally, it gives the correlation conditions. at these bases, we discuss the correlated double sampling elaborately

    課題從ccd的物理基礎入手，闡述了ccd的工作機理，對ccd的各種不同噪聲進行了深入分析，指出了ccd不同噪聲產生的原理，課題運用相關理論對浮置擴散放大器讀出方式工作的ccd輸出復位噪聲進行了數學描述，進而對復位噪聲的相關性進行了定量的分析和計算，給出了復位噪聲相關的條件。
  19. In the description of circuit design, the emphasis is paid the following hardware modules : ad / da inverter, dsp module, external program / data memory, cpld control logic, serial communication module, power module, and so on. problems and the corresponding solutions found in the design and debug stage are discussed, too. finally, the low - level software driver design is presented in detail, including system booting, initialization of dsp registers, cpld logic and timing control, drivers for asynchronous communication fifo, and drivers for ad converter

    在電路模塊分析中，重點介紹了語音的輸入放大和輸出緩沖部分、 ad da轉換、 dsp語音壓縮解壓、外部程序數據存儲器、 cpld邏輯控制、串列收發組件、電源供電以及dsp的jtag介面等等，並且給出了在硬體電路設計和調試過程中的問題與解決辦法。
  20. Transistor hi - fi power amplifier, the output impedance is low, can actuate the speaker well

    高速晶體管hi - fi功率放大器，輸出阻抗低，能更好地驅動揚聲器。
分享友人
分享到 Line

分享到臉書