斜向鋼筋 的英文怎麼說
中文拼音 [xiéxiànggāngjīn]
斜向鋼筋
英文
diagonal reinforcement-
Fabrication of the box beam is divided into such parts as reinforcement, formwork, concreting, prestressing, moving and storing of beam, pipe grouting under pressure, end sealing of the beam, water - proof layer on the bridge surface system, protective coating etc. the paper makes description of effective box beam construction technology and workmanship which can be adopted in other projects, such technologies as : manufacturing and fixing of reinforcement, steel reinforcement fixing baseplate, web plate and top plate respectively and lifting the steel skeleton into form, requirements of design and manufacturing and way of utilization for dismantling - erection type formwork and hydraulic formwork, optimization of concrete ratio, concrete pouring process of two ends of beam in priority over the middle, in sequence of first baseplate followed by web plate and top plate at last, concrete pouring in inclined section and in horizontal layer, concrete vibration mainly by external vibrator in assistance with internal vibrator, methods and regulation for steam curing of concrete, dual controls over stress and strain to ensure quality of prestressing workmanship, construction method of effective beam moving by heavy - weight special moving facility, some regulations and key notes about construction of grouting under pressure, beam ends sealing, water - proof layer on the bridge surface system, protective coating
箱梁製造由鋼筋工程、模板工程、混凝土工程、預應力工程、移存梁工程、孔道壓漿工程、梁體封端工程、橋面防水層和保護層工程等施工環節組成。文中介紹的採用胎具製作和綁扎鋼筋，分底腹板和頂板分別綁扎並吊裝鋼筋骨架入模；拆裝式和液壓式兩種模板的設計、製作要求和使用方法；綜合考慮、優化混凝土配合比，混凝土灌注從兩端至中間、先底板、后腹板、再頂板的施工順序和斜向分段、腹板水平分層、附著式振搗為主、插入式搗固為輔的施工工藝，蒸汽養護的方法和規定；應力應變雙控制確保預應力施工質量的施工技術；採用重物移運器有效移梁的施工方法；壓漿、封端、橋面防水層和保護層施工的一些規定和注意事項等都是對箱梁製造行之有效的施工技術和施工方法，並可為以後類似施工作借鑒。Test research and theoretic study on shear strengthening of reinforced concrete restrained beams using externally applied carbon fabrics reinforced plastics under concentrated loads is presented in this thesis, which is part of the project of construction bureau of hunan province
本文結合省建設廳課題碳纖維加固鋼筋混凝土結構的受力變形性能及加固方法研究，對鋼筋混凝土約束梁斜向貼cfrp抗剪加固進行了試驗研究和理論探討。Secondly, the basic principle on optimal design of structure is presented. based on the characteristics of aqueduct - stayed optimal design, cable optimization, aqueduct body selection optimization and aqueduct body vertical section optimization are included. the prestresses of cable - stayed, the dimension of aqueduct and the number of reinforcing steel bar are chosen as the design variables
根據斜拉式渡槽優化設計的特點，本文將槽身優化分為索力優化、槽身橫斷面優化以及槽身縱斷面優化三個方面進行優化設計，確定斜拉索預應力、槽身斷面尺寸、槽身橫向及縱向預應力鋼鉸線配筋數量等槽身設計的主要變量。According to test results of two specimens of local transfer rc joint from inclined column to beeline - shaped wall under vertical static loads and results of corresponding finite element analysis ( ansys ), fundamental behaviors of the joint are achieved, which include paths of vertical load transfer before and after cracking, stress distributions, occurrence and development of cracks and final failure mode of the joint
本文通過兩個鋼筋混凝土斜柱?一字形薄壁柱局部轉換節點在豎向荷載作用下的靜力試驗以及有限元分析，獲得了該節點的基本性能，其中包括開裂前後的豎向荷載的傳遞路徑、試件應力分佈，裂縫的發生、發展，及試件最後的破壞形態等。Then the coupling beams with new reinforcement layout were made an inquiry into, and the improvement on the seismic behavior by coupling beams diagonally reinforced with a few rows in end regions was found out at last, based on the observations of the experimental phenomena and the analysis of the measurement result, and by the comparison of seismic behavior by making use of hysteretic response, ductility and energy dissipation behavior, a conclusion is presented : the code for design and construction of reinforced concrete high - rise structures ( the draft asked for advise hi 2000 ) ca n ' t ensure that the coupling beams have fairly good seismic ductility ; the result of improvement of the seismic ductility of the coupling beams by the increase hi stirrups besides the strengthen of longitudinal detailing reinforcement was n ' t obvious ; the coupling beams diagonally reinforced with a few rows in end regions have fairly good mechanisms, and the ductility and the behavior of energy dissipation are better than conventionally reinforced concrete coupling beams, so it is suitable to te tised in short coupling beams
本文通過對三根小跨高比（均為l h = 1 . 0 ）剪力墻洞口連系梁在低周反復荷載作用下的試驗，了解了嚴格按《鋼筋混凝土高層建築結構設計與施工規程》 （ 2000年徵求意見稿）設計的連梁具有的抗震性能，研究了採取增大連梁配箍量同時加強縱向構造筋的方案對抗震性能的影響，並進一步對新的配筋形式的連梁進行了探討，了解了在連梁梁端配置多排交叉斜筋方案對連梁抗震性能的改善。通過對試驗現象的觀察和量測結果的分析，利用荷載?位移滯回曲線、延性和耗能性能等指標對各個試件的抗震性能進行了比較，最後得出結論： 《鋼筋混凝土高層建築結構設計與施工規程》 （ 2000年徵求意見稿）不能保證小跨高比連梁具有較好的抗震延性：通過增大連梁配箍量同時加強縱向構造筋的方案對改善連梁的抗震延性的效果不太明顯；梁端配置多排交叉斜筋的連梁具有相對較好的受力性能，其延性和耗能性能等各項性能指標均優于普通配筋連梁，宜在深連梁中採用。In order to reveal load mechanism and failure mode of thick pile caps, by means of the test of 1 / 4 - scale models of thick pile caps with six piles and post - handling study of 3 - dimensional non - linear finite element adina, this paper points out the shortage, which is that the design of pile caps is carried out by flexural strength in chinese technical code for building pile foundations jgj94 - 94 and american reinforcement concrete building construction code aci318 - 02, promulgates that the failure mode of thick pile caps is punching failure and load transfer mechanism is the strut - and - tie, which is that zones of concrete with primarily unidirectional compressive stresses are modeled by compress struts, while tension ties are used to model longitudinal reinforcement over pile
摘要為揭示厚承臺的傳力機理和破壞形式，通過對4個1 : 5比例的六樁厚承臺的模型試驗研究與三維非線性有限元adina的后處理研究，指出中國建築樁基技術規范jgj94 - 94與美國鋼筋砼房屋建築規范aci318 - 02規范中，承臺以彎曲強度進行配筋計算的設計方法之不足，揭示出厚承臺的破壞模式是沖切破壞，傳力機理是以帶有主要單向壓應力的砼區域作斜壓桿，樁頂區域的縱筋作拉桿的空間桁架。The coal unloading chute is a kind of the underground reinforced concrete box structure. the main beam of coal unloading chute being made skew, this kind of structure has been the first time in domestic
進煤系統的主體建築物卸煤溝為地下式鋼筋混凝箱形結構，卸煤溝溝頂主梁採用斜向布置，這種結構布置形式在國內尚屬首次。Inclined stirrups are not effective in beams resisting shear reversals, such as seismic loads, because the reversals will cause cracking parallel to the inclined reinforcement, rendering it ineffective
也就是說，哪怕縱向鋼筋不彎起（保證支座叢筋在上下都足以抵抗地震力產生的彎矩） ，箍筋用斜的，也不行！Experiment and theories analysis express low shear walls the general occurrence shear to slice the breakage, before shearwalls " concrete crack, the wall plate concrete under takes the big part shear stress, exsist inclined pull lord should dint ; after wall concrete crack, wall plate the reinforcing bar undertakes the big part shear stress, so changes to suffer the mechanism originally, hence formation the inclined direction suffers to press the piece of with suffer to pull the reinforcing bar pull, press the resistance
試驗及理論分析表明低矮剪力墻一般發生剪切破壞，在墻體混凝土開裂前，墻板混凝土承擔大部分剪力，存在著斜拉主應力；在墻體混凝土開裂后，墻板中鋼筋承擔大部分剪力，從而改變了原來的受力機理，於是形成斜向受壓構件（裂縫間混凝土斜壓柱體）和鋼筋的拉、壓抗力。By modifying the level and vertical steel bars and adding bevel steel bars to the model structure, the paper compares the influencing factors of ratio of reinforcement and bevel steel bars to seismic properties, and pushes forward the methods to improve the seismic behaviors of the same kind
，通過改變模型結構水平與豎向配筋以及在墻板中增加斜向鋼筋等試驗參數，對比研究了配筋率和斜向鋼筋對其抗震性能的影響，提出了改進這類結構抗震性能的設計與構造建議。分享友人