斜終點線 的英文怎麼說

中文拼音 [xiézhōngdiǎnxiàn]
斜終點線 英文
oblique winning line
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 終 : Ⅰ名詞1 （最後; 末了） end; ending; finish 2 （指人死） death; end 3 （姓氏） a surname Ⅱ形容詞（...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 終點線 : finish line
  • 終點 : 1 （一段路程結束的地方） terminal point; finishing point; destination 2 [體育] finish; 終點裁判員...
  1. The method is as follows : calculating the length, angles and coordinates of pre - cast hollow slab in cartesian coordinate system, and then adjusting the width of hollow slab beams and length of cantilever boards to make the linear cantilever slabs close to the transition of mute

    具體方法是：採用直角坐標系計算預制空心板斜長、首尾夾角和起終點坐標，根據計算結果與路線線形之差，多次調整空心板梁的梁板寬度和懸臂長度，使外懸臂折線滿足路線的緩和曲線線形。
  2. According to the design theory of the cable - stayed bridge and to the feature of the cantilever construction the authors propose a construction control method called optimum completion state method ( ocsm ) for rc cable - stayed bridges in the proposed method, the optimum completion state is regarded as the final target of the construction control, and the optimum construction state at each construction stage is taken as the technical route the key of the method is to properly choose or adjust the cable forces the objectives function of optimization is to minimize the elevation error of the girder under the constraint condition that the internal forces ( bending moments ) of the girder are bounded the optimization variables are the cable forces on the basis of the above principles, a optimum model for a construction step is established and cable force adjustments can be found for each construction step in this model, the creep and shrinkage effects of concrete have been considered a bridge example is given which shows that the final state of the bridge is very close to the design aim and that this method is much better than the so - called double - control method the example is a good illustration of the soundness and practical value of the proposed method

    根據現代斜拉橋結構設計理論和懸臂施工方法的特點，提出了以最佳成橋狀態作為施工控制的最終目標，以實施最佳施工階段為技術路線，以索力調整為核心內容的斜拉橋施工控制理論，簡稱為最佳成橋狀態法；以斜拉橋主梁標高誤差最小為目標函數，以主梁內力（彎矩）為約束條件，以索力為優化變量，建立了最佳施工階段的索力調整計算模型；推導了考慮徐變收縮效應的索力調整計算公式；用最佳成橋狀態法對一實橋工程進行了施工控制全過程計算研究，得到的成橋狀態與設計目標相當接近，優于該橋以「雙控」為控制目標的實測結果，有力地證明了本文方法的正確性及其工程實際價值
分享友人
分享到 Line

分享到臉書