斬波 的英文怎麼說

中文拼音 [zhǎnbō]
斬波 英文
chopped wave; chopping斬波放大器 chopper amplifier; chopping amplifier; 斬波晶體管 chopper transistor; 斬波穩壓電源 chopper voltage stabilizer; 斬波信號 chopping signal
  • 斬 : 動詞（砍） cut; chop; behead
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  1. Specification for thyristor chopper of trolley bus

    無軌電車晶閘管斬波器技術要求
  2. Principle and design of a chopper applied in smes

    超導儲能系統用斬波器的原理及設計
  3. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現蓄電池恆流放電過程智能控制是蓄電池放電裝置發展的必然趨，本文提出了一種通過三極電阻調節模塊和由智能功率模塊ipm為開關器件進行斬波從而實現蓄電池恆流放電的方法。為達到對ipm的驅動保護和放電過程的智能控制，文中設計了igbt門極驅動脈沖pwm信號形成電路和ipm故障封鎖保護電路及由單片機80c196為核心的微機控制器。本裝置能夠對蓄電池進行0 150a放電電流及放電時間的精確控制及釋放容量的計算。
  4. However, the h - bridge maglev chopper has serious switching losses, so as to have snubber circuit ; there is high emi with the chopper

    然而， h -橋斬波器開關損耗大，需要添加緩沖網路，電磁干擾十分嚴重;對供電電源有反向電流沖擊，容易造成供電電源和濾波電容的損壞。
  5. A design adding a dc chopper after the triphase rectification was given to reduce the peak of the pulse of voltage, aiming at the characteristics that the magnitude of the rated voltage of permanent magnet synchronous motor ( pmsm ) is far below that of the power supply, also the electric parameters of the devices were given

    針對專用永磁同步電機額定電壓大大低於電網電壓這一特點，為降低電機上承受的峰值脈沖電壓，設計了在三相整流之後增加一級直流斬波器並給出了相應的電氣參數。
  6. Firstly. operation principle of induction heating is introduced and the actuality of the power supply for induction heating is summarized. then, the scheme of structure of the power supply is established : uncontrolled rectifier and buck chopper constitute dc circuit. in this part, operation principle of a kind of soft switching buck chopper is presented mainly and the conclusion that the power semiconductor devices operate in soft switching is also illustrated by analysing the operation principle of all stages ; series resonant inverter is selected as inverter circuit via comparing the advantage and shortcoming of parallel resonant and series resonant. moreover. the work principle of series resonant inverter is analysed and the calculating method of the best dead time is put forward as well

    文中首先介紹了感應加熱電源的工作原理並綜述了國內外的研究現狀。接下來分析並制定了電源主電路的構成方案：在對比幾種功率調節方式的基礎上選擇了不控整流加斬波調壓作為直流部分。在這部分里，重點研究了一種軟開關buck變換器，通過分析各階段的工作原理說明了開關器件如何工作在軟開關狀態；對于逆變器部分，在比較了串、並聯逆變器優缺點的基礎上選擇了串聯諧振逆變器，並詳細分析了串聯逆變器的工作原理，提出了最佳死區的計算方法。
  7. This paper select the series - resonant inverter because it is more suited to high frequency power supply and it will be easy to enhance power capacity and enable the power supply to work on higher frequency if power is regulated in the rectifier. so uncontrolled rectifier and buck chopper constitute dc circuit is selected as rectifier circuit

    並分析了感應加熱電源的各種調功方式，在對比幾種功率調節方式的基礎上，得出在整流側調功有利於高頻感應加熱電源頻率和功率的提高，選擇了不控整流加斬波器調壓作為研究對象。
  8. At last, this paper also design a small capacity buck - boost type chopper system, pointing out the problems and difficultes of the ac modulation voltage system in the future

    最後，對小容量斬波控制buck - boost電路調壓系統作了初步的設計，指出了本課題研究調壓系統有待解決的一些問題。
  9. Two nonlinear simulation methods are designed by curve fitting method and anfis which seem simply and right in the simulation experiment. based on the model different control strategies also were realized in detail such as chopped current control ( ccc ), angular position control ( apc ), amplitude - change ccc and pi control. a simple torque sharing function ( tsf ) method and a tsf controller were designed which decreases torque ripple effectively

    文章中還建立一種基於模糊神經網路的非線性模型，並對比分析了三種方法，模擬中確定了電機的最優開通關斷角，在此基礎上實現了電流斬波控制、角度位置控制、變幅值電流斬波控制以及分段雙閉環pi控制，模擬結果表明，它實現了電機的正常運行，很好的抑止了電機轉矩脈動，同時有效地降低了噪聲。
  10. Thus, an open loop control scheme and a closed loop control scheme based on chopper system are introduced. lastly, a hardware and software design based on m icro - controller is presented

    本文最後對基於斬波方式的三相交流異步電動機的軟起動方法給出了基於遠程監控的具體實現方案。
  11. The study shows that the output pulse value of resistance absorption equipment is related to the chopper switch conduction ration and the selection of lagging angle

    研究表明，地面電阻吸收裝置的輸出電流脈動與斬波器的導通比、各支路斬波器的開關滯后角有關。
  12. An available chopper circuit of stepmotor ' s power

    1種實用型步進電機功率斬波電路研究
  13. Output current is also discontinuous ( chopped )

    輸出電流也不連續（斬波） 。
  14. Input current is discontinuous ( chopped )

    輸入電流不連續（斬波） 。
  15. Two - quadrant current chopper control for brushless dc motor

    電流型兩象限斬波器控制的無刷直流電動機
  16. Chopper synchronizing rectifier circuit

    斬波同步整流電路
  17. Using operation amplifier to control power of laser emitter

    基於斬波自動穩零運算放大器的激光器平均光功率控制
  18. Principleand applications of icl7650 chopper - stabilized operational amplifier

    7650斬波穩零運算放大器的原理及應用
  19. Current reversible chopper

    電流可逆斬波電路
  20. The control method was introduced and the hardware of the controller was designed. the controller uses the 89c52 and 89c2051 as the main control unit and produces the on and off and angle signal of each phase. combined with protecting signal and current chopping signal, it can control the igbt on and off

    介紹了srd的控制方式和本系統所採用的控制策略，對控制器的硬體電路進行了設計，控制器以89c52和89c2051雙cpu為主控單元，採用模糊調節，發出相通斷信號和角度信號，並和電流、電壓等保護信號以及斬波信號相結合，實現對主功率元件的通斷控制。
分享友人
分享到 Line

分享到臉書