晶態原纖 的英文怎麼說

中文拼音 [jīngtàiyuánxiān]
晶態原纖 英文
crystalline fibril
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 原 : Ⅰ形容詞1 （最初的; 原來的） primary; original; former 2 （沒有加工的） unprocessed; raw Ⅱ動詞（原...
  • 纖 : 纖形容詞（細小） fine; minute
  1. Fe - ni alloy fiber were first prepared in a mixed solution of ferrous and nickelous salts, using kbh4 as a reducing agent. conditions, such as quantity of naoh, concentration of salts, and species of surfactants, of preparation of fe - ni alloy were studied. the result show that fe - ni alloy were soft magnetic materials and they exhibited superparamagnetization at room temperature that have been widely used in industry

    本文用液相還原法首次制備出纖維狀的fe - ni合金、球形的fe - co 、 co - ni合金、 fe - co - ni合金粉體材料，並對其性能進行了分析和測試，結果表明：這些合金粒徑小，比飽和磁化強度較大，矯頑力為零，呈現超順磁性，是非晶態的軟磁材料。
  2. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  3. The metastable austenitic phase of s s fiber at the interface of the fiber / cu composite would turn back to equilibrium with the interfacial energy and inter stain inducing, when the cu films were separated from s s fiber. so the magnetism value of the s s fiber declined. the information of grain - orientation at the interface of the fiber / cu composite can serve as a mechanism responsible for its declining coercivity, and a part of cu elements diffused into s s fibers

    不銹鋼纖維銅復合體去除銅層后，原有的界面能及應力下降，使得原纖維界面處弱磁性的部分亞穩奧氏體，恢復到平衡態，它們對樣品s測試結果不再有貢獻；不銹鋼纖維銅復合體中，處于界面處的纖維晶粒具有很強的軸向取向排列，當晶粒取向性減弱，磁疇轉動的阻力增加，磁體的矯頑力上升。
  4. The results showed that the in - situ formed tibi particles which had a size of about 50nm, exhibited a homogenous dispersion in the copper matrix. moreover, the interface between the nanoscale particles and the copper matrix was clean, and there was no certain location relationship. due to their reinforcement, the tensile strength and hardness of the in - situ cu - tib _ 2 nanocomposite significantly improved

    通過光學顯微鏡、 tem 、 xrd等對cu - tib2原位復合材料進行了金相組織、微結構分析，原位復合材料的鑄態金相組織中彌散分佈著團簇狀的tib2顆粒；形變態金相組織中tib2顆粒呈纖維狀排列； tem觀察表明：在基體內存在著尺寸約為50nm 、彌散分佈的tib2顆粒，且tib2顆粒與基體之間界面清晰，但由於tib2結構與銅晶體結構的差別較大， tib2顆粒與基體之間無固定的位向關系；納米tib對銅基體有良好的增強作用。
  5. So we decide to fabricate gi - pof by the method of interfacial - gel mass polymerization of methyl methacrylate ( mma ). secondly, some ways for purifying mma such as two - stage rectification, dynamic melt crystallization and distillation - melt crystallization hybrid process were researched

    其次討論了制備塑料光纖的主要原料mma的精製方法，研究了填料塔兩級精餾、動態熔融結晶及熔融結晶-精餾耦合工藝，提出用分子蒸餾法提純摻雜劑的設想。
分享友人
分享到 Line

分享到臉書