柱外效應 的英文怎麼說

中文拼音 [zhùwàixiàoyīng]
柱外效應 英文
extra column effect
  • 外 : Ⅰ名詞1 （外面） outside; external side 2 （外國） foreign country 3 （以外） besides; beyond; in ...
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 效應 : [物理學] effect; action; influence
  1. Finally, convergent geometry had an important effect on the perturbance coupling between the interfaces of the finite fluid. the attenuation factor of perturbance coupling from the outer interface in was greater than the one from the inner out

    本文研究表明：收縮幾何效應對有限厚度流體的界面之間的擾動耦合有重要影響，柱和球幾何中擾動耦合從外界面到內界面的衰減因子大於從內界面到外界面的情況。
  2. Secondly, this paper made some theoretic researches on its engineering classfication and applicable scope for this technology ; then combining with project example, this paper carried out scheme design for this technology, and compared some different kinds of underpinning scheme and node and structure design, and put forward the method of " reinforcce steel bar through column " to build pile cap beam, " resistant bend and shear anchored reinforce steel bar " to strengthen column consolidation effect, and the method of " steel plate hoop " to build reinforcing bar connection of the foundation beam, etc. in the process of the consturction scheme research and implement, this paper synthetically elaborated the organizaton for project construction, put forward the construction technical measure of specific aim on the artificial pile, and pile cap beam, and underground adding layer and structure stabilization, and overall structure stabilization and so on. for this project, adopt reinforcing bar concrete to brace hole wall to ensure the safety of engineering in the artificial pile construction, use flexible connection catch to make the cage hoisting easier to simplify the construction process, use the method of earthwork statified symmetrical balance in the process of underground adding layer excavation

    本文首先對于基礎托換與結構加固技術的目的和意義、國內外發展狀況進行了綜合闡述；其次對該項技術工程分類及適應范圍進行了理論上的分析研究；然後結合工程實例對該項技術進行了方案設計，對比幾種不同的托換方案和節點及構造設計，提出了「通筋穿柱法」做承臺梁， 「抗彎抗剪錨筋法」強化柱加固效果， 「鋼板箍法」做地基梁鋼筋連接點等多項技術；在施工方案的研究和實施過程中，對于工程施工組織進行綜合闡述，並就人工挖孔樁、承臺梁、地下加層及結構加固、整體結構穩定等專項施工方案提出有針對性的施工技術措施，人工挖孔樁施工採用鋼筋砼護壁確保挖孔樁的安全成型，使用柔性連接鉤進行鋼筋籠吊裝簡化施工工序；承臺梁施工採用梁主筋橫穿柱身化學膠錨固等；地下加層綜合施工技術採用土方分層對稱平衡開挖，分段挖土做筏基結構自穩等；最後對于該工程實施后的效果分析，說明該項綜合施工技術的可行性。
  3. Influential factors and behavior of concrete prism confined with cfrp have been studied, based on the effective confined concrete area with cfrp, the peak stress and peak strain of cfrp - confined concrete prism depend on, and calculating equation is put forward

    此外本文還對碳纖維布約束混凝土的受力性能及影響參數進行了研究。基於碳纖維布有效約束混凝土的面積，在原有箍筋約束混凝土的模型的基礎上，提出了碳纖維布約束混凝土稜柱體應力-應變關系模型。
  4. The main works are shown as followings : in order to get best economic benefits and quickest time response, the advantages and shortages of existing methods for machining twin - screws are analyzed. in view of the production of co - rotating twin - screw is various and mostly in small batch, a new approach for forming cylinder helical surface with milling cutter is put forward. it presents the theoretical foundation for machining of twin - screw

    論文主要工作有如下幾點：針對同向雙螺桿產品零件的多品種、小批量的生產特點，為了取得最佳經濟效益和快速地時間響應，在查閱了雙螺桿加工有關的國內外文獻資料，研究分析了雙螺桿各種現有的加工方法的優缺點，提出了一種新的加工方法? ?用圓柱立銑刀成形加工雙螺桿螺旋面。
  5. Extra - column effect

    柱外效應
  6. The results showed that the creep coefficients in cfrp - confined concrete columns and in epoxy - coated concrete columns are almost same, both are less than that in plain concrete columns on the same other conditions but surface treatment, which demonstrates that the creep reduction in cfrp - confined concrete columns is due to the existence of epoxy coating not of cfrp sheet. furthermore, the physical apperence and dimension have litter effect on the creep behavior of cfrp - confined and epoxy - coated concrete columns

    結果表明:其他條件相同時， cfrp約束混凝土柱與塗膠混凝土柱的徐變基本一致，比素混凝土柱徐變小29 . 0 %和26 . 9 % 。 cfrp約束混凝土柱的徐變減小是由於粘貼cfrp布時的膠層所致而非核心混凝土的約束效應。 cfrp約束或表面塗膠的混凝土柱的外形、尺寸及體表比對其徐變的影響很小。
  7. In the paper, the method of equivalent stress is adopted to confirm the outside force of the truss model, and the factor of the angle of inclined column is considered. a design method of the wall was suggested

    採用等效應力法確定了桁架模型的外力，即薄壁柱傳來的荷載，其中考慮了斜柱的傾角以及反映薄壁柱與轉換梁共同作用的薄壁柱端部塑性發展系數的影響。
  8. Observing the mechanics and effect of the new strengthening method with test and finite element method is supposed to offer a guide for technology and become valuable in theory and practice. both compression test, including four reinforced and three control specimens, and shear - compression test, including nineteen reinforced and four control specimens are being studied in this paper. the research on the curves of load - strain, load - deflection and hysteretic shows that the transverse translation of the reinforced columns is well controlled with an upgrading of both ductility and ultimate bearing capacity ( ubc )

    本文對4根鋼絲網外噴高強砂漿加固鋼筋混凝土柱和3根對比鋼筋混凝土柱進行了軸壓試驗研究，並對19根加固鋼筋混凝土柱和4根對比鋼筋混凝土柱進行了剪壓試驗研究；通過對試件荷載-應變曲線、荷載-撓度曲線和滯回曲線等的研究表明，採用該加固方法能有效的約束柱子橫向變形，並對提高鋼筋混凝土柱的極限承載力和延性有明顯的效果；同時根據理論及加固機理分析提出了適應於此加固方法的軸壓極限承載力計算公式。
  9. The ratio of story shear rigidity as well as the equivalent lateral rigidity ratio of story above the transfer story to the story under the transfer story should be designed properly to avoid the transfer story becoming weak story, thus the shear walls and the columns in the large base will not yield before the elements above the transfer story ; ( 2 ) the translation - torsion coupled effects and the vibration in the plane should be considered in analysis of structure with large base and muti - towers

    轉換層的設計除應控制層剪切剛度比外，還應控制轉換層上部與下部結構的等效側向剛度比以避免薄弱層出現在框支層，保證地震作用下落地剪力墻和框支柱不先於轉換層上部結構進入屈服狀態；大底盤多塔樓結構的分析必須考慮平扭耦聯振動和樓板平面內振動的影響。
  10. The effect and safety of reinforced concrete column strengthened with bonded external angle steel are related with many factors, such as reinforced design, process of reinforcement, anchored structure of reinforced end, reinforcement rate of the angle steel, ductility and the stress applied on original column as well as maintenance in use

    摘要採用外包角鋼加固的鋼筋混凝土柱、其加固效果和安全性與諸多因素，如加固設計、加固施工工藝、加固端錨固構造、加固角鋼的增鋼率與增箍率、原柱所處的應力狀態、使用過程中的維護管理等有關。
  11. This paper firstly compares the provisions about torsion effect and anti - torsion design in several codes ( the old and new chinese code for seismic, and some other countries " codes ). then, according to the code for seismic design of buildings ( gb50011 - 2001 ) and the code for concrete structure design ( gb50010 - 2002 ), the paper designs two multi - storied irregular concrete spatial frames, which respectively situated at the area of fortification intensity 8 and 9. subsequently, using the program based on the column - beam element of fiber model, input several ground motion records, which are selected according to the demand of code, to carry the structures " three - dimensional nonlinear analysis in two perpendicular directions at the same time

    本文對比了我國新、舊建築抗震設計規范（ gb50011 - 2001 、 gbj11 89 ）以及國外設計規范（或指南）中關于結構扭轉效應與抗扭設計的相關規定；按照新建築抗震設計規范和混凝土結構設計規范（ gb50010 2002 ） ，設計了設防烈度分別為8度和9度的兩個多層鋼筋混凝土不規則空間框架結構，利用纖維模型樑柱單元的三維非線性動力分析程序，根據新抗震設計規范的要求，在設防地震作用和罕遇地震作用水準下選擇適當的地震波作為輸入，對結構進行了雙向地震作用下的三維非線性動力反應分析。
  12. At last some further research proposals of strengthening concrete structures with hfrp were presented : besides the theoretical descriptions of the durability of hfrp and its successful applications, further experimental research should be carried out to study its feasibility in strengthening concrete ; in order to inspect and amend the practical effect of the reasonable matching, experimental study of concrete columns and beams ( the author have fabricated 30 hfrp strengthening concrete columns with a diameter to height ratio of 1 : 3 and 15 concret

    汕頭大學碩士學位論文摘要最後提出了今後hfrp加固混凝土結構的研究設想，主要是: hfrp的耐久性除進行合理的應用實例和理論分析外，還需通過試驗研究進一步論證其可行性。應將合理匹配用於樑柱加固試件（作者已製作30個直徑/高為1 : 3的hfrp加固柱試件和15根混凝土梁試件供后續實驗研究之用。 ） ，檢驗實際效果，並進行修正。
分享友人
分享到 Line

分享到臉書