柱狀化作用 的英文怎麼說

中文拼音 [zhùzhuànghuàzuòyòng]
柱狀化作用 英文
stylolitization
  • : Ⅰ名詞1 (形狀) form; shape 2 (情況) state; condition; situation; circumstances 3 (陳述事件或...
  • : Ⅰ動詞1 (使用) use; employ; apply 2 (多用於否定: 需要) need 3 (敬辭: 吃; 喝) eat; drink Ⅱ名...
  1. The peak is composed of banded biotite tonalite of fine mediate grain developing in mengshan rock suit of fuping period of archean era about 2. 7billion years ago. it ' s very steep

    由27億年左右形成的太古代阜平期蒙山巖套條帶中細粒黑雲母英雲閃長巖構成,節理發育,差異性風剝蝕強烈,組成雲蒙「山」峰,俗稱「掛心崛子」 ,形容雲蒙峰之陡峻。
  2. This drilling adopts crank connecting link and walking beam percussion mechanism, which make the drilling possess two percussive functions, normal drilling takes connecting link impact as main mode, when encountering special situation and the connecting link impact can not drill, it can transform into hoisting impact, the stroke length can be modulated, it realizes automatic percussive drilling due to continuous operating of connecting link percussive mechanism, these can enhance drilling efficiency and relieve labor intensity ; it adopts pumping reverse circulation to drain slag, which not only resolves the drilling difficulty in special stratum such as pebble and gravel stratum and hard stratum, but also resolves the problem that the percussive drill ' s efficiency is low ; it adopts spur gear differential mechanism as double cylinders lazy tongs of main hoist, which not only ensures the balance state of drilling tool, but also reduces the mechanical design, and reduces the cost ; the bottom plate traveling motion of this drilling machine adopts walking type ; the drilling tower adopts hydraulic pressure uprising, and reduces the assistant operating time

    該鉆機採曲柄連桿、游梁式沖擊機構,使鉆機具有兩種沖擊功能;正常鉆進以連桿沖擊為主,遇到特殊情況,連桿沖擊不能鉆進時,可轉為卷揚沖擊,沖程可調,因連桿沖擊機構連續工,所以實現了自動沖擊鉆進,可提高鉆進效率,減輕勞動強度;採泵吸反循環的方式排渣,既能有效解決卵礫石地層、堅硬地層等特殊地層鉆進的困難,又很好地解決了沖擊鉆機效率低下的問題;採直齒圓齒輪差速機構為主卷揚的雙筒同步機構,既保證了鉆具處于平衡態,又大大簡了該機構設計,降低了成本;該鉆機底盤行走移位採步履式;鉆塔採液壓起立,減少了輔助業時間。
  3. According to the research results of the rock quality calculation, the columnar section digitlizing, the rock mass structure diagnosis and other methods this paper used engineering limited parameters, basic structure and evolutionary structure of rock mass as the first grade indexes, proposed the technique of dynamic engineering classification of stability of mine road surrounding rock mass ? dec ?, pointed out the method of using dec results

    基於圍巖質量計算、圖數字與重組、圍巖結構診斷、采動應力后圍巖結構演等研究成果,採工程要求、基本結構、演結構」為一級指標,提出了巷道圍巖穩定性動態工程分類技術、分類結構的表達技術及分類結果的應方法
  4. This material was loaded onto a silica gel column and the column was eluted with chloroform several times until the fraction of interest was collected. finally we obtained some light yellow green ointment liquid f i

    硅膠干層析填充物,氯仿展開劑和洗脫液,反復硅膠層析,對柄海鞘鞘囊氯仿浸提物進行分離、提取與純,最後得到一淺黃綠色的油液體fraction (以下均稱f ) 。
  5. In uses in front of the software the usual use stick plot or the thick line network chart, after use the software to work thin, two not good comparisons, thus frugal time not too good quantification

    在使軟體之前通常使圖或粗線條網路圖,使軟體后工更細,兩者不好比較,從而節約的時間不太好量
  6. To directly estimate the life of this kind of motor, and to design a orbit curve with the longest life at same condition, this paper gives theoretic research of the equal contact stress inner curve of radial piston motor. the research is divided into four parts : 1 ) taken all forces the piston endured into consideration when radial piston motor working, the force between roller ( or ball ) and orbit is deduced. the simple style of the press expression can be confirmed by ignoring minor influence factors after analysis all factors that will influence this press

    靜壓傳動技術在各類工程機械中得到廣泛的應,對為其核心部件的徑向塞式低速大扭矩液壓馬達的研究顯得十分重要,為了能直接對這種馬達進行壽命估計,並能在相同工況下求得壽命最長的軌道曲線,本文從設計等接觸應力內曲線的角度對這類馬達探討性的研究,主要從以下四個方面進行: ( 1 )綜合考慮徑向塞式液壓馬達工時的各種主要受力況,對塞組件進行受力分析,並通過模擬分析影響軌道和滾動體間正壓力的各個因素,得到正壓力的簡表達式。
  7. Tem reveals that the complex possessed good dispersibility in the system and the status varied reversibility with the ph value and the size of the complex is within 20 ~ 40nm. the complex was characterized by ft - ir, uv - vis, fluoresence and electrical conductivity methods. paa - ag nanospheres were also synthesized by coordination of polyacrylic acid and silver ( i ) ion and queued in line in lr

    本論文還以低分子量的聚丙烯酸和硝酸銀為主要原料,通過控制體系的ph值合成響應環境ph值變的聚丙烯酸銀納米微球和納米物,通過tem觀察尺寸達20 - 40nm ,ir 、 uv - vis 、熒光、電導率法分析聚丙烯酸和銀的配位、所形成配合物的組成與結構,並將聚丙烯酸和硝酸銀置於「線性反應器」中進行配位聚合,合成出線性排列的paa - ag納米微球。
  8. However primary industry, heavy industry and chemical industry, which have been highly protected from the nation, will be gravely affected. fourthly, using three standards - productivity, the relation of industries and elastic of demand - income, and combining current situation and restricted factors, the paper point out that the principal industries are processing of farm and sideline products, building materials products, metal products, paperboards and machine - made paper, chemical industry and tourism trade

    生產率上升率、產業關聯度和需求收入彈性這三個衡量基準,結合河北省鄉鎮企業發展的現與限制因素,對河北省鄉鎮企業的支產業進行了測算、選擇,提出農副產品加工業,金屬製品業、建材工業、造紙及紙製品業、學原料和學製品業,旅遊業應為河北省鄉鎮企業的支產業。
  9. The transfer of the carrier in photoconductor is anisotropy owing to the column structure of the film is anisotropy. on the basis of the new concept suggested in this paper, the maximum diffusion length in the lateral direction of the photo - carrier in the photoconductor ( which is related to the resolution of lclv directly ) as function of conductivities of both in lateral and normal directions in the film can be obtained as the expression as following. the nc - si / a - si : h photoconductor of lclv deposited and crystallized at low temperature of exactly 250 c stack column structure by al inducing a - si : h

    本文根據結構存在各向異性的特點,並根據半導體物理知識,推出光導層光生載流子橫向最大擴散長度(該擴散長度與液晶光閥光導層解析度直接相關)與薄膜橫向和縱向電導率關系的表達式為:由於a - si : h在al金屬的誘導下在不高於250的溫度下即開始晶,本文對金屬al誘導非晶硅晶制備的nc - si a - si : h薄膜進行研究。
  10. 3. for the component of sub - eutectic, the cu - cr alloys are difficult to form complete eutectic tissue on the condition of non - equilibrium solidification. the general microstructure is of cellular primary a ( cu ) and circumference - distributed eutectic ( a + p ) where the former mainly acts as the conductor and the latter as the reinforce, together to be fibrous eutectic reinforced in - situ composites

    3在非平衡凝固條件下,亞共晶cu - cr合金凝固組織的一般特徵為的初生晶之間分佈著條的cu - cr共晶體,前者主要起導電,後者為強相,形成共晶纖維強的自生復合材料。
  11. According to the research results of rock qulity calculation, rock mass structure combination, and others, the authors use “ limited engineering parameters, basic structure of rockmass, evolved structure of rockmass ” as the first - order index, propose a technique of dynamic and engineering classification of mine road surrounding rockmass ( dec ), and suggest a method to use the dec

    基於圍巖質量計算、圖數字和重組、結構面診斷、圍巖結構裝配、采動應力后圍巖結構演等研究成果,採「工程要求、基本結構、演結構」為一級指標,提出了圍巖的動態工程分類技術、分類結果的表式表達技術,並指出了分類結果的應方法。
分享友人