模擬方法學 的英文怎麼說

中文拼音 [mónǐfāngfǎxué]
模擬方法學 英文
simulation methodology
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 學 : Ⅰ動詞1 （學習） study; learn 2 （模仿） imitate; mimic Ⅱ名詞1 （學問） learning; knowledge 2 （學...
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  • 法學 : law; the science of law; jurisprudence法學博士 doctor of laws; 法學概論 general jurisprudence; 法...
  1. The frame structure, work flow and 3 - dimensional model building method of the virtual prototype design of the air compressor are presented in detail

    摘要闡述了空壓機虛擬樣機設計的框架結構、工作流程及其三維模型構建方法，進行了設計與運動學模擬方法研究。
  2. By means of dynamic simulation of multi - body and finite element methods, the influence of the footwell design parameters to lower extremity injuries of the driver in passenger car frontal impacts was studied

    運用多剛體與有限元結合的動力學模擬方法，本文研究了轎車腳艙設計參數對駕駛員在前碰撞中下肢損傷的影響。
  3. Fortunately, the modern geodetic measurements such as the global positioning system ( gps ) technique can overcome the shortage of the geological and seismographic methods in the time dimension ; and yet, the coverage of the geodetic survey stations is not sufficient. as a result, it is necessary to employ numerical simulation to investigate the continuous deformation of the crust

    而以全球定位系統（ gps ）等技術為主的大地測量方法彌補了地質和地震學方法在時間維上的不足，但大地測量方法存在測點覆蓋不足及測點地理分佈不均勻的缺點，因此，要得到連續的地殼形變場有必要藉助數值模擬方法。
  4. The improved scheme can ensure the south branch to be open to navigation and the flow here not to be broken in low water seasons, and it will have active effect on protecting the south branch and fuyuan town. this study is an attempt of applying three - dimensional mathematical model in analogue calculation and analysis of flow, sediment and riverbed movements in a long river reach. it is very important for the future thorough research, and has great significance for promoting the application of the three - dimensional model to resolve

    本研究是三維數學模型對較長河段水流、泥沙、河床運動模擬計算分析的一次嘗試，其對今後進一步深入研究和應用三維模型解決工程實際問題，完善模擬方法、提高模擬水平，真正發揮數學模型其省時、省力、靈活方便和模擬細膩等在研究水沙運動規律和河床變形等方面研究中優勢具有重要的意義。
  5. Based on the normal form obtained above, a global perturbation method is utilized to give the analysis for the global bifurcations and chaotic dynamics of the rotor - ambs system. the global bifurcations analysis indicates that there exist the heteroclinic bifurcations and the silnikov - type homoclinic orbit in the averaged equations

    利用全局攝動法研究了電磁軸承-轉子系統的全局分叉和混沌動力學，利用數值模擬方法分別對平均方程和原方程進行了分析，得到了的描述系統混沌運動的相圖和波形圖，從而驗證了理論結果的正確性。
  6. The tectonic subsidence curves on the southeastern margin of the yangtze plate are drawn out using of backstripping method for the basin formation and evolution. the basins located in the southern margin of the yangtze plate, in the basin dynamic computer simulation, is explored and constituted to be a typical foreland basin which is of not rather high mountain and thermal situation to be lower in this older orogeny belt

    在沉積盆地分析方面，基本查明揚子板塊東南邊緣早古生代被動大陸邊緣沉積特徵及沉積構造演化，同時運用反剝法技術對揚子板塊東南大陸邊緣沉積盆地形成，演化的構造沉降動力學進行探討，運用計算機模擬方法，定量動力沉積學對揚子東南邊緣奧陶紀到志留紀前陸地進行計算機模擬分析，探索並建立這個古老造山帶前陸盆定量參數和動態定量模擬。
  7. The nonlinear finite - element digital simulation method plays an important role in the mechanical analysis of ship collision accident

    摘要非線性有限元數值模擬方法在船舶碰撞事故的力學分析中正得到日益廣泛的應用。
  8. In this dissertation we research the inversion pattern of three water through environment isotope information analysis, evaporation pattern analysis and inversion analysis of groundwater ; quantitatively analyse inversion amount through rule computational method and numeric value imitation, supplying scientific foundation for evaluation of water resources and rightful development and use

    論文通過環境同位素信息分析、潛水蒸發試驗分析、近河岸地帶地下水動態分析研究三水轉化規律特徵；採用常規計算方法和數值模擬方法，定量分析地下水各轉化資源量。為研究區水資源評價及合理開發利用提供了科學依據。
  9. Because that complex phenomena in pegs involve kinetic effects of plasma and cathode emitted electrons, and evolution of electromagnetic fields, particle - in - cell ( pic ) code is chosen as study tool, and a two and half dimensional cylindrical fully electromagnetic pic code cylinder2 - 1 / 2d, which is suitable for simulating the operation of the pegs, has been established

    考慮到peos物理現象涉及到等離子體和陰極發射電子的動力學行為以及空間電磁場的復雜變化，我們採用粒子模擬方法作為研究工具，研製了適用於peos物理問題模擬研究的二維柱坐標全電磁粒子模擬程序cylinder2 - 1 2d 。
  10. Dynamics of pedomotor and methodology of controlled integrative simulation

    步行機動力學與控制集成模擬方法
  11. Abstract : futures, application scope and limits of computer mod els aftox 、 tanks3 for chemicals vapor emission are analyzed particularly. the sim alating ways, parameters and results of oil gas pollution are tested and verified through application in an oil terminal. it ' s considered that further application of the model in terminals of china is feasible

    文摘:重點分析化學品蒸汽擴散計算機模式aftox 、 tanks3的特點及適用范圍，通過在油港實際應用，對模擬方法和參數、模擬結果進行了研究和驗證，認為模式在國內港口的進一步應用是可行的。
  12. By using mathematical model and computer simulation, the results are obtained from simulating the quantitative influence of 9 important factors on the heat consumption of ceramic fuel fired tunnel kilns

    利用陶瓷燃料隧道窯熱耗數學模型及計算機模擬方法，得出了9種重要因素對熱耗定量影響的模擬結果，並對模擬結果進行了分析。
  13. Abstract : by using mathematical model and computer simulation, the results are obtained from simulating the quantitative influence of 9 important factors on the heat consumption of ceramic fuel fired tunnel kilns

    文摘:利用陶瓷燃料隧道窯熱耗數學模型及計算機模擬方法，得出了9種重要因素對熱耗定量影響的模擬結果，並對模擬結果進行了分析。
  14. Abstract : according to the relationship between the prototypes and the models the models are divided into the material one and idealized one. the simulated method for the material models and the idealized method for the idealized models are discussed

    文摘:根據模型與原型的關系，把模型分為物質模型和觀念模型兩大類，並從科學研究的目的出發，分別探討了建立兩大類模型的典型方法? ?模擬方法和理想化方法。
  15. 6. the electric field induced by the ring electrode is calculated and a model of the electric field induced by charged droplets is presented

    6 、模擬了環狀電極誘導的空間電場，建立了荷電霧滴誘導空間電場的數學模型並就模擬方法進行了探討。
  16. ( 3 ) the basic theories and techniques on distributed radar cfar detection are reviewed. in particular, using the numerical performance simulation results, the performance of distributed cfar detect system under nonhomogeneous backgrounds and simple detect conditions are analyzed in some details. we have summarized the performance characteristics of distributed cfar detect systems against interference and edge clutter when different fusion rule is used

    西北工業大學博士學位論文（ 3 ）對分散式cfar檢測技術的相關理論、方法進行簡要總結與分析，特別是利用數值分析與性能模擬方法，對非均勻環境下簡單條件檢測系統的性能進行了較為深入和系統的研究，總結了不同融合方式時分散式cfar檢測在抗干擾與雜波方面的性能特點。
  17. Based on object - oriented analysis and design, this paper discussed the basic theory of computer graphics, visual simulation method, non - instantaneous pole envelope method about cnc machine and the three - dimension graphics modeling method. with triangle graphic element as the basic modeling tool we developed simulation system that cnc machine manufactured special shape screw pole

    本文以面向對象分析和設計為基礎，對計算機圖形學基本理論、可視化模擬方法、數控機床無瞬心包絡加工方法和三維圖形造型方法進行研究，利用三角形圖元作為基本的造型工具，建立了數控機床加工異形螺旋桿的模擬系統。
  18. The process of stress change near the blasting cut was displayed objectively by the numerical simulation in different solid fea models. moreover, results of numerical analysis in blasting vibration load agree with the practical results, which show that ansys can be helpful to design and optimize the parameters of demolition blasting

    數值模擬結果客觀的再現了不同切口參數條件下的實體模型的受力情況，爆破振動荷載的數值分析與實際結果相吻合，也證明了數值模擬方法在高聳建築物爆破拆除中的適用性和科學性。
  19. Simulation results for the forward projection of ot are presented for the cases of strong and low scattering media respectively based on monte - carlo ( mc ) method along with some discussions

    應用monte - carlo （ mc ）模擬方法，分別給出了強、弱兩類散射介質中光學ct正向問題的數值模擬結果，並將其與基於擴散方程的數值計算結果進行了比較。
  20. To avoid re - execution of the whole simulation system on condition that some nodes or agents are invalidated, a distributed simulation scheme with fault - tolerant mechanism is proposed, including fault classification, fault detection, the fault - tolerant extension of distributed simulation algorithm, and dual global service agents. with the prevalent of the internet and web, it is ne

    在本文的第三部分中，針對于金融證券市場，依據基於agent的建模與模擬方法學，提出了金融證券市場的基於agent的同構模型，並且在分佈模擬平臺jcass上得到了實現。
分享友人
分享到 Line

分享到臉書